Bouncepad Floorstanding User Manual
Displayed below is the user manual for Floorstanding by Bouncepad which is a product in the Tablet Security Enclosures category. This manual has pages.
Related Manuals
Orientate, locate and secure the Floorstanding
Pole to the Floorstanding Base as shown. Ensure
that all xings are installed correctly.
Locate the Floorstanding
Cover over the
Floorstanding Pole.
Feed the tablet power
cable through the Case &
Floorstanding Pole.
Fixings Kit
Faceplate
Tablet Set-up Kit
Case
Sheet Code: BP-IM-047_REV2
Release Date: 28/10/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Condential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
1 2
5
Floorstanding
Rubber Collar
Floorstanding Base
Floorstanding
Pole
Floorstanding Cover
Floorstanding
Assembly Instructions
Tools Required:
Socket Driver
10mm Spanner *or adjustable spanner
Pair of Keys
In the Box
4x M6x25mm
Countersunk
screw
4x M4x20mm
Buttonhead
screw
1x T20 Pin
Torx Driver Bit
1x PZ3 Pozi
Driver Bit
4x M6
Locking Nut
4x M4 Split
Washer
4x M6 Split
Washer
1x Case
Washer
Fixings List
* Due to the modular nature of our product range
you may receive additional xings in the xings kit
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
M6 Nylon Locking nut
M6x25mm
Countersunk
screw
M6 Split Washer
Locate and secure the Case onto the
Mounting Arm as shown. Tighten by
hand.
3
Case Washer
M4x20mm Button head screw
M4 Split Washer
T20 Pin Torx Driver Bit
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
Unlock & remove the
Faceplate from the
Bouncepad Case.
4
4x Corner Pieces
1x Cable Clip
4x Tablet Supports
6Install the Tablet Setup
Kit. Each kit is specic
per device & case.
Install the tablet into the
Case & connect to power.
7
89.1 9.2
10
Locate and lock the Faceplate to the
Case.
Connect the tablet power cable to its
mains power source.
If installing a battery pack, connect
the tablet cable and locate the pack
into the Floorstanding Base.
With the Floorstanding Cover on
the ground, locate and t the
Floorstanding Rubber Collar.
*designed to support the Anker PowerCore 10000mAh.
*battery pack is not provided.
11 Installation is now
complete.
*We recommend recording the key number so
you can purchase additional keys in the future.
Key number here