Bouncepad Swivel 60 User Manual
Displayed below is the user manual for Swivel 60 by Bouncepad which is a product in the Tablet Security Enclosures category. This manual has pages.
Related Manuals
Congure the angle of rotation - ensuring both
arrows are pointing in the same direction before
starting. Default angle conguration is 270˚.
Insert the limit screws for 90˚ or 180˚ rotation.
#1
In the box
0
Fixings Kit
Faceplate
Tablet Set-up Kit
Tools Required
0
Swivel Desk/S60
Assembly Instructions
Follow these instructions for
the successful assembly your
Bouncepad Swivel Desk/S60.
Sheet Code: BP-OR-IM-022_REV2
Release Date: 24/07/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Condential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Electric Drill
Pencil Socket
Screwdriver
7mm Spanner (or
adjustable Spanner) 20mm
Holesaw
*if routing the tablet
cable through your
mounting surface
4.0mm Drillbit
*if xing from below
3.5mm Drillbit
*if xing from above
Attach your chosen mounting arm. Your mounting arm must forward lean
in the same direction as the two arrows. Tighten by hand, ensuring full
and correct engagement.
#2
Buttonhead
screw
T20 Driverbit
*Desk *S60
#3 #4
Using the template (see A4) mark and drill the
mounting holes appropriate to your mounting
surface and cable routing conguration.
Use the above template to mark the drill holes - appropriate to your
chosen xing method. ‘A’ if xing from above. ‘B’ if xing from below.
Follow the corresponding steps (PTO) specic to each xing method.
B
B
B
Front
C
B
A
A
A
A
Ø68.0mm
Ø65.5mm
48.0mm
46.0mm
B4mm Drillbit
*if xing from below
20mm
Holesaw
*if routing the tablet
cable through your
mounting surface
C
A3.5mm Drillbit
*if xing from above
Static60
Mounting
Arm
Desk
Mounting
Arm
or
Case
Rotate
#5 If routing your tablet cable atop the
mounting surface, feed it through
the Mounting Arm as shown.
A1 Fixing From Above:
Lift & hold the rubber screw covers.
Use caution to not scratch the parts.
A2 Fixing From Above:
Secure the base with the 4x screws.
Close the screw covers once nished.
*Must be completed by hand.
Take care to ensure the screws go in
fully and are straight.
Take care to not damage any parts.
Fixing From Below:
Screw in the 4x Socket Set Screws.
Ensure full thread engagment.
B1 B2 Secure to the surface. Nylocs provide
higher security whilst Wing Nuts
allow for easier removal.
Nyloc Nut
Metal Washer
Metal Washer
Wing Nut
#6 Installation of the mounting arm is
complete. Now install your Case as
shown above.
T20 Driverbit
Case Washer
M4 Button head screw
M4 Split Washer
#7 #8 #9
Install the Tablet Setup Kit. Each kit is specic per
tablet device and Bouncepad Case.
Route your tablet cable through
the Case. Install the tablet into
the Case and connect to power.
Locate and lock the Faceplate
to the Case.
4x Corner Pieces
1x Cable Clip
4x Tablet Supports
*if routing your cable atop the
mounting surface, feed this
through the Case now.