Bouncepad VESA User Manual
Displayed below is the user manual for VESA by Bouncepad which is a product in the Tablet Security Enclosures category. This manual has pages.
Related Manuals
Sheet Code: BP-IM-036_REV1
Release Date: 25/09/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Condential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Fixings Kit
Tablet Set-up Kit
Position & mark were the
VESA is to be located.
Ensure the VESA is level.
A1 Drill the xing holes in
your surface.
A2 Secure the Bouncepad
VESA mount to the
mounting surface.
A3
Attach the Bouncepad Case to the
Mounting Arm. Take care to ensure
correct & full thread engagement.
1
T20 Driverbit
M4x20mm
Buttonhead screw
M4 Split Washer
Case Washer
In the Box Fixings List
* Due to the modular nature of our product range
you may receive additional xings in the xings kit
Pair of Keys
VESA
Assembly Instructions
Tools Required:
Pencil
Electric Drill
2.5mm Drillbit *if xing to a surface
Socket Driver
4x M4x20mm
Buttonhead
screw
4x M4 Split
Washer
1x Case
Washer
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
*xings not provided.
VESA Mount
Faceplate Case
Follow steps A if “Fixing
to a surface”.
Follow steps A if “Fixing
to a surface”.
A
B
Secure the Bouncepad VESA mount to
VESA mounting bracket
B1
* Bouncepad VESA to third party VESA mount xings
not provided. Image shown for illustrative purposes &
may bare zero resemblance to xings specied for your
VESA mount. Refer to specications provided by the
third party VESA mount for the recommended xings.
*Bouncepad VESA mount is compatible with 75x75mm
and 100x100mm VESA mounting congurations.
Go to step 1. Go to step 1.
A4 B2
Locate & lock the Faceplate onto the
Bouncepad Case.
5
* we recommend holding the Tablet within the
Bouncepad Case during application and removal of the
Faceplate.
Unlock & remove the Faceplate from
the Bouncepad Case.
2Install the Tablet Setup Kit. Each
kit is specic per tablet device and
Bouncepad Case.
3
4x Corner Pieces1x Cable Clip
4x Tablet Supports
Feed the tablet cable through the
Case. Connect it to its power supply.
Install your tablet into the case.
4
6Installation is now
complete.
*We recommend recording the key number so
you can purchase additional keys in the future.
Key number here