Da-Lite 29589 User Manual
Displayed below is the user manual for 29589 by Da-Lite which is a product in the Mounting Kits category. This manual has pages.
INSTRUCTIONS FOR
Touch Interactive Bracket Kits (Small and Large)
Tools Required for Installation Installation
1. Using the provided #4 x ½” screws and #4 nuts, attach the
touch module base plate to the bracket.
2. Remove the cover from the touch module. Using the screws
provided with the projection system, attach the touch
module to the touch module base plate.
3. Position the bracket with touch module along the top of the
IDEA Screen or IDEA Panoramic according to the projector
manufacturer’s instructions. Using the two provided #8 x ½”
screws, attach the bracket and touch module to the IDEA
frame with the touch module facing towards the audience.
NOTE: If the projector instructions do not specify a position,
center the bracket relative to the projected image. The lat
vertical surface of the touch interactive bracket should be
lush to the face of the IDEA frame.
4. Follow manufacturer’s instructions for aligning the IR curtain.
Required Hardware - Provided
Figure 1
Small Bracket Installation
Phillips Screwdriver
(2) #8 x ½” Screws(2) #4 x ½” Screws (2) #4 Nuts
NOTE: Interactive module terminology may vary from manufacturer to manufacturer.
#8 x ½" Screws
M4 x 30mm
Screws
M4 Nuts
Screws Supplied with
Touch Module
Touch Module
Base Plate
Touch Module
1/4” Wrench
A Milestone AV Technologies Brand
3100 North Detroit Street
Warsaw, Indiana 46582
P: 574.267.8101 or 800.622.3737
F: 574.267.7804 or 877.325.4832
E: info@da-lite.com
www.da-lite.com
DL-0712 08.16
© 2016 Milestone AV Technologies LLC. Printed in U.S.A. 10812
Installation
1. Remove the cover from the touch module. Using the
provided M4 x 30mm screws and M4 nuts, attach the touch
module to the touch interactive bracket as shown.
2. Position the bracket with touch module along the top of the
IDEA Screen or IDEA Panoramic according to the projector
manufacturer’s instructions. Using the two provided #8 x ½”
screws, attach the bracket and touch module to the IDEA
frame with the touch module facing towards the audience.
NOTE: If the projector instructions do not specify a position,
center the bracket relative to the projected image. The lat
vertical surface of the touch interactive bracket should be
lush to the face of the IDEA frame.
3. Follow manufacturer’s instructions for aligning the IR curtain.
Figure 2
Large Bracket Installation
Tools Required for Installation
Required Hardware - Provided
Phillips Screwdriver
(2) #8 x ½” Screws(2) M4 x 30mm
Screws
(2) M4 Nuts
NOTE: Interactive module terminology may vary from manufacturer to manufacturer.
#8 x ½" Screws
M4 x 30mm
Screws
M4 Nuts
Touch Module
7mm Wrench