Da-Lite 85739 User Manual

Displayed below is the user manual for 85739 by Da-Lite which is a product in the Projection Screens category. This manual has pages.

INSTRUCTION BOOK FOR

Advantage® Manual With CSR

(Controlled Screen Return)

Pre-Installation Operating Screen

Case Installation

Screen And Roller Assembly Installation

1. Carefully unpack case from shipping carton. DO NOT unpack

fabric and roller assembly yet.

2. Make sure to recheck measurement of case for proper

installation clearance.

3. Remove any protective foam or tape from case.

1. Pull down on pull bail until desired picture area is obtained.

Lock into position as on a window shade. Be sure surface is

locked before releasing.

NOTE: this screen will not lock into position in the upper

portion of its travel.

2. To re-roll the screen, pull the picture surface down about 6 inches

and start the fabric up quickly and release.

Large picture surfaces are heavy and will start up too slowly to

prevent the locking pawl from catching unless help is provided.

If the locking pawl catches pull the picture surface down and

start the surface up rapidly.

The CSR feature of this screen will allow the fabric to retract

rapidly until about the last 612 inches of travel then it will slow

and retract gently into the case.

To view an online CSR retraction tutorial, please visit http://

www.da-lite.com/products/product_lash/modelc_csr/.

1. Hang case and attach to support structure with bolts.

See suggested methods of installation on page 3.

NOTE: Carriage bolts can be installed anywhere along the

length of the case. The head of the carriage bolt slides into

the variable-position mounting channel. It is recommended

that the center is supported on cases longer than 7 feet.

2. Tighten bolts until trim lange is lush with ceiling.

NOTE: For proper operation, screen assembly must be

level after installation.

If your screen was shipped with the motor and roller already

installed, skip this section.

1. Remove access door. First remove the 2 screws from the

ends (Figure 1). Be sure to support the door during this step

to avoid injury. Lift the door slightly and pull away from the

edge of the case.

2. Carefully unpack screen and roller assembly. Leave packing

paper on roller.

3. Loosen (but do not remove) two 1/420 nuts securing the pin

end bracket (stage left) to the case housing. Slide the bracket

towards the end of the case.

4. Insert the spring end of the roller into the spring end bracket.

The mounting brackets have a formed tab that the slat bar

will rest against. Be sure to install the roller assembly so the

slat bar is positioned onto the tab. (Figure 2).

5. Slide the pin end bracket onto the CSR pin. Tighten the

1/420 nuts securely.

6. Re-install the access door. Procedure is reverse of removal.

Figure 1

Remove 2 Screws

To Remove

Access Door

Formed

Tab

Mounting

Bracket

Slat Bar

Figure 2

⅜" Threaded Rod

(Not Supplied)

Advantage® Manual Installation

Hanger Bracket

See Detail A

Detail A

3.41"

Variable

Position

Mounting

Channel

3/8" Threaded

Rod (Not

Included)

Attached

To Mounting

Bracket

Finished

Ceiling

Self-Trimming

Flange

6 ⅜"

9 ¼"

6 ⁄"

7 ¾"

7.75"

6.42" 7.95"

Troubleshooting

Symptom Cause Solution

Screen is retracting too slowly.

Over 8 seconds retracting from

the bottom into the case.

The CSR adjustment is not correct. Retract screen completely, and then rotate

CSR shaft 1/2 turn at a time counterclockwise.

Screen is retracting too fast.

Under 3 seconds retracting

from the bottom into the case.

The CSR adjustment is not correct. Retract screen completely, and then rotate

CSR shaft 1/2 turn at a time clockwise.

Screen is retracting too slowly, and

then slams the case when adjusted

counterclockwise.

The CSR unit (shock absorber) is too strong. Reset the CSR unit. Call Da-Lite (8006223737)

for detailed instructions.

Screen does not retract.

Retraction procedure*. Pull the screen down, and then retract irmly and quickly.

The CSR has been over adjusted

counterclockwise.

The CSR unit is jammed. Reset or replace the CSR unit.

Call Da-Lite (8006223737) for detailed instructions.

The roller tube is bent and binding. Replace the screen.

Screen does not stay down.

Locking procedure. Pull the screen down, and then slowly

retract until it locks.

Dog is not locking. Retract screen completely, and then rotate

CSR shaft 1/2 turn counterclockwise.

*To view an online CSR retraction tutorial, please visit http://www.da-lite.com/products/product_lash/modelc_csr/.

LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTS

Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in

materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser; provided they are properly

operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the

factory.

This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered

with or repaired by a person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.

Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,

transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.

To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS

OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use,

or merchantability, that may be mandated by statute or rule of law are limited to the one (1) year warranty period. This warranty gives

you speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED

BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION

OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137,

Warsaw, IN 465810137, (574) 2678101, (800) 6223737.

IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DALITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS

WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DALITE WRITTEN INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.

85778

A Milestone AV Technologies Brand

3100 North Detroit Street

Warsaw, Indiana 46582

P: 574.267.8101 or 800.622.3737

F: 574.267.7804 or 877.325.4832

E: info@da-lite.com

www.da-lite.com

DL–0281 01.14