Da-Lite 88608 User Manual

Displayed below is the user manual for 88608 by Da-Lite which is a product in the Projection Screens category. This manual has pages.

INSTRUCTION MANUAL

Fast-Fold Deluxe

Screen Frames

with Standard or HD Legs

Procedure

Two-Section Frame Three-Section Frame

1. Remove screen surface from case, and set aside.

2. Fast-Fold® Deluxe frames are made of 1 1/" square hard aluminum tubing with an anodized inish. With proper care,

will provide many years of use. Remove the frame from case and wrapping. Position as shown (front view).

Set-up

3. Unfold the frame so that it is lying lat on the loor.

Ensure wheels are positioned down, facing the loor.

Procedure

Set-up

4. While holding the bottom of the frame in place,

extend the top of the frame to unfold the sides.

Snap-latches will automatically lock.

5. Lock down all four corner braces.

Snap-latch

Top

Lock

Corner Braces

6. Remove legs from the case. Unfold, ensuring keyways

are facing up. Start at wheel closest to bottom of

frame, and align stud/wheel with corresponding

keyway. Attach furthermost wheel from bottom of

frame (that falls within height of leg) and align stud/

wheel with keyway. Move to the center of frame and

with a irm grip, slide the leg down toward the feet of

leg to lock studs into the keyways. Ensure the wheel is

completely seated into the keyway safety channel.

Turn wheels clockwise until secure.

7. Match top of screen surface (labeled TOP) with top of frame.

8. Snap all four corners.

9. Starting at the bottom section, snap the center button. Continue snapping the remaining buttons.

10. Snap the top and sides in the same manner.

Leg

Frame

Keyway

Wheel

Keyway Safety

Channel

Procedure

Set-up

Wheel

11. Standard TLegs

A. Open and latch front foot braces.

B. Walk frame until upright.

C. Open and latch back foot braces. Tighten leg brace knobs to secure.

HD Legs (Accessory, recommended for screens 10' wide and greater or

those screens where drapery kits are used)

A. Open and latch front foot braces.

B. Walk frame until upright.

C. Open back foot braces. DO NOT latch braces at this time.

D. Raise A-braces to engage wheel on A-braces into keyway on legs.

Slide A-braces down until fully seated into keyways.

Turn wheels counter clockwise until secure.

E. Latch back foot braces.

12. Fast-Fold Deluxe screen height is adjustable in 6" increments either up

or down. Normal screen height is 44" from bottom of frame to loor and

is the standard height for use with presentation drapery accessories.

NOTE: Do not extend frame so that more than half of the frame height

is above the top of the legs.

Procedure

1. For tear-down, follow set-up procedures in reverse order.

2. To fold frame, unlock all four corner braces.

Push the blue snap-latch buttons and fold the frame.

NOTE: For some frames, fold the top and bottom irst.

Tear-down

Blue Snap-Latch Button

When folding the screen material for packing, observe the following precautions before proceeding:

• The surface should not be allowed to contact painted,

varnished or plastic inished objects for a prolonged

period of time.

• Make certain the viewing surface is on a clean, lat surface.

Then proceed in the following manner:

Place clean white tissue paper – with no printing – on top of the

viewing surface. If tissue is not available, a soft white cloth or

something similar will serve the same purpose. Under no

circumstances should newspaper or anything similar be used

since these may damage the screen material.

1. With the viewing side facing up, fold the surface in half from

top to bottom. Make certain when folding, the surface does

not come in contact with either the black binding, grommets

or snap buttons.

2. If the material on the irst fold is more than 3 feet

high, then fold once again, but always place clean tissue

paper between the folds.

3. For large size screens, fold in half again if necessary. Make

certain when folding, the surface does not come in contact

with either the black binding, grommets or snap buttons.

4. After the top to bottom folding procedure is completed, then

fold from left to right and continue folding until the fabric is of

suicient size to it into the leatherette case.

NOTE: Keep the screen surface in the envelope provided when it

is not in use. Failure to observe these normal precautions may

cause discoloration of the surface.

Cleaning

Da-Tex®, Dual Vision and HD Rental surfaces can be cleaned as

follows: Using a white clean cloth (100% cotton preferred) that is

dampened with clear water, gently wipe the area in one

direction. Do not use a circular motion. Using a dry 100% cotton

cloth, wipe dry after each cleaning session. To clean a stubborn

stain or a sticky surface, use denatured alcohol (methanol or

methyl alcohol) following the same procedure as for water. For

extremely stubborn stains, use VM&P Naphtha or Super Naphtha

and follow the same procedure as for water.

NOTE: Fast-Fold® screens are shipped with tissue paper packed

between the folds. This keeps the material from sticking to itself

and makes it easier to unfold.

Folding the Screen Surface

for Packing

Step One

Step Five

Step Four

Step Three

Step Two

Do not fold fabric onto black binding,

grommets or snap buttons

All other brand names or marks are used for identiication purposes and are trademarks of their respective

owners. All patents are protected under existing designations. Other patents pending.

FOR YOUR IMAGE | legrandav.com

USA P 866.977.3901 E av.da-lite.support@legrand.com

CANADA P 877.345.4329 E av.da-lite.support@legrand.com

EMEA P +31 495 580 840 E av.emea.sales@legrand.com

APAC P +852 2145 4099 E av.asia.sales@legrand.com

COMMERCIAL BRANDS

Chief | Da-Lite | Middle Atlantic | Projecta | Vaddio

89123

• Temperature: Between 40 – 100°F (5 – 40°C)

• Relative humidity: 30% to 70%, non-condensing

• Always keep the projection screen horizontal during transport and storage

• Make sure the entire package is supported when stored

• Do not stack more than six projection screens on top of each other

• Make sure the heaviest package is placed at the bottom of the stack

Screen surface should be allowed to air out once every two months, or otherwise used on a regular basis,

if the temperature is above 72°F (22°C) and at least once every month if the temperature goes above 85°F (30°C).

Conditions for

Transportation and Storage

LIMITED FIVE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTS

Legrand AV Inc. warrants certain Da-Lite branded products to the original purchaser only, to be free from defects in materials and

workmanship for a period of ive (5) years from the date of purchase by the original purchaser; provided they are properly operated

according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory.

This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered

with or repaired by a person other than authorized Da-Lite personnel.

Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise.

Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite,

transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment. To

protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS

OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANTABILITY. Any implied warranties of itness for use, or

merchantability, that may be mandated by statute or rule of law are limited to the ive (5) year warranty period. This warranty gives you

speciic legal rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT PERMITTED BY

APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING FROM INTERRUPTION IN OPERATION OF

EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE.

In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact Customer Care at 3100 North

Detroit Street, Warsaw, IN 46582, (866) 9773901.

IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DALITE BRANDED PRODUCTS SHALL NOT BE BOUND BY THIS

WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DALITE WRITTEN INSTRUCTIONS.

Keep your sales receipt to prove the date of purchase and your original ownership.