Hoover CJ625/1 User Manual
Displayed below is the user manual for CJ625/1 by Hoover which is a product in the Vacuums category. This manual has pages.
Related Manuals
USER MANUAL
- 1 -
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning,
as described in this user guide. Please ensure that this guide
is fully understood before operating the appliance.
Do not leave the appliance plugged in. Always switch o
and remove the plug from the socket after use, or before
cleaning the appliance or any maintenance task.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised Hoover
service engineer must replace the power cord.
Keep hands, feet, loose clothing and hair away from
rotating brushes.
Use only attachments, consumables or spares
recommended or supplied by Hoover.
Static electricity: some carpets can cause a small build up
of static electricity. Any static discharge is not hazardous to
health.
Do not use your appliance out of doors.
Do not pick up hard or sharp objects, matches, hot ashes,
cigarette ends or other similar items.
Do not spray with or pick up ammable liquids, cleaning
uids, aerosols or their vapours.
Do not run over the power cord when using your appliance
or remove the plug by pulling on the power cord.
Do not continue to use your appliance if it appears faulty.
Hoover service: To ensure the continued safe and ecient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised Hoover
service engineer.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
Do not position the appliance above you when cleaning the
stairs.
Do not touch the plug or appliance with wet hands.
For UK and Ireland only: This appliance has a 13 Amp mains
plug. If you need to change the fuse in the mains plug, use
a 13Amp ASTA (BS1362) fuse.
INSTRUCTIONS FOR SAFE USE GB
*Certain models only - 2 -
GETTING TO KNOW YOUR CLEANER
Congratulations on the purchase
of your new Hoover.
Please take the time to read this
manual carefully.
You’ll then be ready to make the
most of the special features only
the new Hoover can oer!
When rst unpacking your cleaner
please check all items are included:
Cleaner body
Upholstery brush*
Flexible hose *
Hose bag*
HANDLE RELEASE
BUTTON
CARRY HANDLE
INLET COVER
DIRTY WATER TANK
RELEASE LEVER
DIRTY WATER TANK
HANDLE
DIRTY WATER TANK
CLEAN WATER TANK
WATER RELEASE
BUTTON
CORD CLIP
UPPER STORAGE
HOOK
POWER CORD
LOWER STORAGE
HOOK
ON/OFF PEDAL
CLEANER RELEASE
PEDAL
UPHOLSTERY
BRUSH *
HOSE BAG*
FLEXIBLE HOSE*
HOOVER
CARPET
CLEANING
SOLUTION
EXHAUST
FILTER
EXHAUST FILTER
CHAMBER
HANDLE
GB
1
3
2
4
- 3 -
PREPARING YOUR CLEANER
Remove the contents of the packaging.
You should find the following:
Raise the handle to the upright position
until it locks in place.
Test for colourfastness - Wet a white absorbent cloth
with the solution. In a small, hidden area of your
carpet, gently rub the surface with the dampened
cloth.
Wait ten minutes and check for colour removal or
bleed with a white paper towel.
If your carpet has more than one colour, check all
colours.
When cleaning an entire room, move furniture out of
the area to be cleaned. If the furniture is too heavy to
move, place aluminium foil or wax paper under legs.
This will prevent wood finishes from staining your
carpet. Pin up furniture skirts and curtains.
NOTE: Do not over saturate your carpet.
To fold the handle press the handle
release button and fold to the storage
position.
Once the handle has been lowered lift
the carry handle to allow the cleaner to
be carried from room to room.
BEFORE CLEANING A CARPET
IMPORTANT: This cleaner
should not be used to dry
vacuum the carpet.
• Cleaner body
• Upholstery brush*
• Flexible hose*
• Vacuum thoroughly.
• Test for colourfastness
• Move the furniture
GB
*Certain models only
45
12
3
*Certain models only - 4 -
Add the required amount of cleaning fluid to
a measuring jug.
(approx. 40ml per 1L of water)
The clean water tank holds the water and cleaning
solution.
IMPORTANT: Always turn the cleaner off and
disconnect from the electrical outlet before filling
the clean water tank.
NOTE: Before using this
appliance, please ensure
dirty water tank release
lever and inlet cover are
fully locked.
Press the clean water tank release latch
and remove from the cleaner.
Open the screw cap on the bottom of
the tank.
Pour the solution into the clean water
thank. Do not exceed the max fill line.
Replace the cap and return the clean
water tank to the cleaner.
Mix the solution with warm water.
(Max. temperature - 40ºC)
IMPORTANT: When filling the
clean water tank, do not exceed
the max fill line.
WARNING: Use only Hoover carpet cleaning solution. Using other solution brands may cause excess foaming and will
prevent the cleaner from working effectively.
Using other solutions may affect your warranty
FILLING THE CLEAN WATER TANK* GB
1 2
54 3
- 5 -
Unwrap the power cord and plug the
cleaner into the power supply.
Press the cleaner release pedal and recline
the cleaner.
Press the solution mix trigger to release
the solution.
For best results apply the solution on the
forward stroke (press trigger) and recover
the solution on the backward stroke (release
trigger).
Press the ON/OFF pedal.
CLEANING CARPETS
IMPORTANT: This cleaner
should not be used to dry
vacuum the carpet.
WARNING: Use only Hoover carpet cleaning solution. Using other solution
brands may cause excess foaming and will prevent the cleaner from working
effectively. Using other solutions may affect your warranty.
CAUTION: This product is intended for cleaning
purpose only. Do not use the main suction head or
upholstery brush to remove large spills.
Dry vacuum the carpet thoroughly before cleaning
your carpet.
Ensure the carpet has been checked for colour
fastness.
GB
*Certain models only
1
2 3 4
56 7
- 6 -
NOTE: Do not over saturate your upholstery.
NOTE: The clean water tank will need to be
lled with solution and water before use.
Lift the inlet cover
Take out the flexible hose and the
upholstery brush
Press trigger to release solution. Pull upholstery brush back
over spill to pick up liquid.
For best results apply solution
on the forward stroke and
release the trigger to recover
on the back ward stroke.
Upholstery brush can only work with
the cleaner in the upright position
Insert the hose connector Press the ON/OFF pedal
USING THE UPHOLSTERY BRUSH*GB
*Certain models only
- 7 -
Before storing the cleaner:
Turn the cleaner off and disconnect from the electrical
socket.
Empty and rinse the dirty water tank. Allow to air dry.
Press the handle release button and lower the handle
for storage.
Put the flexible hose * and the upholstery brush *
back into the bag for storage.
Turn the cleaner off and remove the plug from the
electrical socket. Wind the power cord around the cord
storage hooks.
Rotate the storage hooks to quickly release the full
length of the power cord.
Do not run over the power cord.
Clip the power cord in the cord clip at the back of the
handle to avoid accidentally running the cleaner over
the cord and causing any damage.
Do not store the cleaner on a wood surface unless the
cleaner is completely dry.
STORAGE
CORD STORAGE
CORD CLIP GB
*Certain models only
1
3
2
4
*Certain models only - 8 -
EMPTYING THE DIRTY WATER TANK
WARNING: DO NOT exceed the max fill line on the dirty water tank.
WARNING: Always switch the cleaner off and unplug it from the
electrical socket before emptying the dirty water tank.
IMPORTANT: Clean the filters
after each use.
WARNING: Ensure both lter are
tted to the cleaner before use.
Press the dirty water tank release lever.
Turn the tank cap anti-clockwise to open.
Remove the dirty water tank from the
cleaner.
Press the exhaust filter
release latch.
Remove the exhaust filter
chamber.
Remove the dirty water
tank from the cleaner.
Take out the pre motor
filter, then clean it.
Remove the filter from the
chamber.
Rinse under hand warm
water to remove any
debris. Allow to completely
dry before returning to the
cleaner.
Empty the tank. Rinse the tank with clean
water and allow to dry before storing the
cleaner.
CLEANING THE EXHAUST FILTER
CLEANING THE PRE MOTOR FILTER
GB
1 2
3 4
- 9 -
Turn the cleaner upside down. Remove any
threads or debris from the brush bar.
Remove any threads or debris ensuring the
agitator can rotate freely.
Press the dirty water tank release
lever and remove the dirty water
tank. Unscrew 4 retaining screws on
the top surface.
Turn the cleaner over. Remove
the brushbar alignment brackets.
Replace the brush bar and attach to the
nozzle. Attach the alignment brackets and
assemble to the cleaner.
Unscrew 2 retaining screws located
on the underside of the detergent
nozzle. Remove the brushbar from
the nozzle.
CLEANING THE BRUSHBAR* CHANGING THE BRUSHBAR*
CLEANING THE AGITATOR*
THIS FEATURE VARIES ACCORDING
TO MODEL
Please check the underside of your
cleaner and follow the appropriate
instructions.
THIS FEATURE VARIES ACCORDING TO MODEL
Please check the underside of your cleaner and
follow the appropriate instructions.
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity
supply before dismantling cleaner
GB
*Certain models only
1 2 3
4 65
- 10 -
CHANGING THE AGITATOR / BELT* IMPORTANT: Switch the cleaner off and remove the plug from the electricity supply
before dismantling cleaner.
THIS FEATURE VARIES ACCORDING TO MODEL
Please check the underside of your cleaner and
follow the appropriate instructions.
Turn cleaner over and remove 7
retaining screws.
Remove the agitator brackets Replace the agitator by looping the belt
round the agitator making sure it sits
securely in the belt channel.
Reassemble the agitator assembly to the
cleaner ensuring the agitator can rotate
freely.
Remove the belt cover and safety
bar.
Slide the agitator assembly out
of the cleaner and check the belt
for wear.
*Certain models only
GB
- 11 -
Troubleshooting
If your cleaner is not working properly run through the following checklist.
WARNING: To reduce the risk of personal injury, unplug the carpet washer
before performing maintenance/troubleshooting checks.
Why won’t the carpet washer turn on?
• It may not be plugged into the electrical outlet correctly: ensure that the plug is
pushed in securely and switched on.
• The power button on the unit hasn’t been fully depressed.
• If unit cuts out during use, disconnect the unit from the wall socket, allow to
cool for one hour, clean the filter and empty the dirty water tank and check
hose, brushbar for blockages.
Why won’t the cleaner pick up solution/spills?
• The dirty water tank may be full. Empty the dirty water tank.
• Ensure the dirty water tank is fitted correctly and the tank cap is securely fitted.
• Check the brushbar for blockages.
Why won’t the solution/clean water dispense?
• The solution/clean water tank may be empty.
• Ensure dirty water tank is fitted securely.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
Hoover spares and Consumables Always replace parts with genuine Hoover spares. These
are available from your local Hoover dealer or direct from Hoover.
When ordering parts always quote your model number.
Quality
Hoover’s factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from
the dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice
Environment
The symbol on this appliance indicates that this appliance may not be
treated as household waste. Instead it must be handed over to the applicable
collection point for the recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal. For more detailed information about treatment, recovery
and recycling of this appliance, please contact your local city office, your household and
waste disposal service or the shop where you purchased the appliance.
This appliance complies with the European Directives 2014/35/EU, 2014/30/EU
and 2011/65/EU.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy
USE ONLY HOOVER SPARES
SPARE PARTS CODE
AGITATOR Y30 35601321
FLEXIBLE HOSE D144 35601409
UPHOLSTERY TOOL AND BRISTLES INSERT MFT4 35601410
FILTER& BRISTLES INSERT U70 35601411
BELT V35 35601322
BRUSH F4 35601324
CLEANJET SOLUTION 35601351
GB
© 2015 48017673/01