Table of Contents
Indesit INS 1801 AA User Manual
Displayed below is the user manual for INS 1801 AA by Indesit which is a product in the Fridges category. This manual has pages.
Related Manuals
Instructions for use
3
ENGLISH Instructions for use Page 4
Always disconnect the appliance from the power supply before replacing the light bulb. Then follow
the instructions based on the type of light bulb for your product.
Replace the light bulb with one with the same features, available from the Technical Assistance Service
and authorised sellers.
Light type 1)
To remove the light bulb, unscrew it in an anti-clockwise direction, as
shown in the figure. Wait 5 minutes before reconnecting the appliance.
- traditional light bulb (max 25W)
or
- LED light bulb (with the same features)
only available from the Technical Assistance Service
Light type 2)
If the product has LED lights, as demonstrated in the figures below, contact the Technical Assistance
Service if you need a replacement.
LEDs last longer than traditional light bulbs, improve internal visibility and are environmentally-friendly.
4
Clean the appliance occasionally with a cloth and a solution of warm
water and neutral cleaning agents specifically for cleaning the inside
of the refrigerator. Do not use abrasive cleaning agents. To ensure
the constant and correct flow of the defrosting water, regularly clean
the inside of the drain situated in the back wall of the refrigerator
compartment near the fruit and vegetable drawer using the utensil
provided (see figure).
Before carrying out any maintenance or cleaning, take the plug out of the socket or disconnect the
appliance from the power supply.
Connect the appliance to the power supply.
In models with electronics, a sound signal may be emitted, which means that the temperature alarm
has been activated: press the sound alarm off button. Where provided, position the antibacterial anti-
odour filter in the fan as demonstrated in the filter packaging.
Note: After turning the appliance on, you must wait for 4-5 hours for the correct storage temperature
to be reached for a normally filled appliance.
USING FOR THE FIRST TIME
MAINTENANCE AND CLEANING
OF THE APPLICANCE
REPLACING THE LIGHT BULB OR LED
(depending on the model)
Light bulb
LED light bulb
LED- strip
Dragon
et2
5
Disconnect the appliance from the power supply, empty it, defrost it (if necessary) and clean it.
Keep the doors slightly ajar to let air circulate inside the compartments. By doing this, you avoid the
development of mould and bad odours.
IN THE EVENT OF NONUSE
OF THE APPLICANCE
Keep the doors closed so the food stays cold for as long as possible. Do not re-freeze food that has
partially defrosted. If there is a prolonged power cut, the black out alarm may also activate (in products
with electronics).
IN THE EVENT OF AN INTERRUPTION TO THE
POWER SUPPLY
The refrigerator compartment allows for the storage of fresh food and drink.
The refrigerator compartment defrosts completely automatically.
The occasional presence of drops of water on the internal back wall of the compartment is a sign of
the automatic defrosting phase. The defrosting water is channelled into a drain and then collected in a
container, where it evaporates.
Depending on the model, the product may be equipped with a special “Zero Degrees” compartment,
which is ideal for storing fresh meat and fish.
Warning: do not clean refrigerator accessories in a dishwasher.
Note: the ambient temperature, how often the doors are opened and the position of the appliance
may affect the internal temperatures in the two compartments. Set the temperatures depending on
these factors.
Note: in very humid conditions, condensation may form in the refrigerator compartment, especially on
the glass shelves. In this case, it is recommended that you close containers with liquids in (e.g. a pot of
stock), wrap up food with a high water content (e.g. vegetables) and turn on the fan, if there is one.
Removing the fruit and vegetable drawer (depending on the model)
Pull the drawer outwards as far as it will go, lift it up and take it out.
To make it easier to remove the fruit and vegetable drawer, it may be necessary to empty (and possibly
remove) the two lower door shelves and then continue to remove the drawer.
Fan and antibacterial anti-odour filter (depending on the model)
The fan allows for the even distribution of the temperatures inside the compartments and,
consequently, better preservation of the food and reduction of excess humidity. Do not obstruct the
ventilation area. The fan can be turned on/off manually (see the Quick Guide); if it is turned on, it
operates automatically when necessary.
REFRIGERATOR COMPARTMENT
6
Model with separate freezer compartment
The freezer compartment allows for the storage of frozen food (for the period indicated on the
packaging) and the freezing of fresh food. The quantity of fresh food that can be frozen in 24 hours is
written on the rating plate. Arrange the fresh food in the freezing area inside the freezer compartment (see
Quick Guide), leaving enough space around the food packages to allow air to circulate freely. It is advisable
that you do not re-freeze food that has partially defrosted. It is important to wrap the food in a way that
prevents the ingress of water, humidity or condensation.
Making ice cubes
Fill 2/3 of the ice tray (if available) with water and put it back in the freezer compartment. Do not use
sharp or pointed objects to remove the ice under any circumstances.
Removing the drawers (depending on the model)
Pull the drawers outwards as far as they will go, lift them up and remove them. To get more volume,
the freezer compartment can be used without the drawers.
Make sure that the door is closed properly after putting the food back on the grilles/shelves.
For frost free models it is not necessary to carry out any defrosting procedures.
For other models, the build up of frost is a normal occurrence.
The quantity and speed of frost accumulation varies depending on the ambient conditions and how
often the door is opened. It is advisable to set the temperature colder or, if available, turn on the quick
freeze function (see Quick Guide) four hours before removing the food from the freezer compartment,
to prolong the preservation of the food during the defrosting phase. To defrost, turn the appliance off
and remove the drawers. Put the frozen food in a cool place. Leave the door open to allow the frost to
melt. To prevent the water from escaping during the defrost, it is advised that you place an absorbent
cloth on the bottom of the freezer compartment and wring it out regularly.
Clean the inside of the freezer compartment and dry it carefully.
Turn the appliance back on and put the food back inside.
HOW TO DEFROST
THE FREEZER COMPARTMENT (depending on the model)
FREEZER COMPARTMENT
In the freezer compartment you can also freeze fresh food.
The quantity of fresh food that can be frozen in 24 hours is written
on the rating plate.
How to freeze fresh food:
• arrange the food directly on the bottom of the compartment (figure 1
and 2)
• put the food in the middle of the compartment without it
coming into contact with food that is already frozen, keeping a distance
of about 20 mm (figure 1 and 2).
Models with an internal product compartment
14m_4s
12m_4s
Figure 1
Figure 2
STOP FROST SYSTEM (depending on the model)
The STOP FROST SYSTEM (available depending on the model) facilitates the defrost procedure for the
freezer compartment. The STOP FROST accessory (figure 1) is designed to collect some of the frost
that forms in the freezer compartment and it is easy to remove and clean, therefore reducing the time
needed to defrost the inside of the freezer compartment.
To remove the frost on the STOP FROST accessory follow the cleaning procedure demonstrated below.
PROCEDURE TO CLEAN THE STOP FROST
ACCESSORY
- Open the freezer compartment door.
- Unfasten the STOP FROST accessory (figure2)
and remove it (figure 3). Note: if the accessory
is jammed or difficult to remove, do not keep
trying to remove it, but proceed with the
complete defrost of the freezer compartment.
- Close the door to the freezer compartment.
- Remove the frost on the accessory by rinsing it
under running (not hot) water (figure 4).
- Let the accessory drip dry and dry the plastic
parts with a soft cloth (figure 5).
- Reinsert the accessory by placing the back part
on the projections shown in figure 6-A, then
refasten the claps of the accessory to the lateral
bushes (figure 6-B).
- Close the door to the freezer compartment.
It is possible to clean the STOP FROST accessory
on its own without completely defrosting the
freezer compartment. Cleaning the STOP FROST
accessory regularly helps to reduce the need to
completely defrost the freezer compartment.
Note: the product specifications, including
volume and energy, are calculated without the
STOP FROST accessory.
7
8
“ZERO DEGREES” COMPARTMENT
(depending on the model)
The “Zero Degrees” compartment is specifically designed to
maintain a low temperature and the correct humidity to preserve
fresh food for longer (for example, meat, fish, fruits and winter
vegetables).
Humidity control technology coupled with Activ0° provides the
best food preservation when the food is not completely packed.
Turning on and turning off the compartment
To turn on the compartment, press the
button shown in the figure for more than
one second until the symbol lights up.
The lit symbol means that the compartment is
working. Press the button again for more than
one second to turn off the compartment. To
turn off the compartment completely, you must
remove the drawer.
For the correct functioning of the “Zero Degrees” compartment, it is necessary that:
- the refrigerator compartment is turned on
- the temperature is between +2°C and +6°C
- the drawer in the “Zero Degrees" compartment must be inserted for it to be turned on
- one of the following special functions is not selected: Stand-by, Cooling-Off, Vacation (if present), in
this case, remove the food contained in it.
Note:
- if the symbol does not light up when you turn on the compartment, check that the drawer is properly
inserted; if the problem persists contact the authorised Technical Assistance Service.
- if the compartment is turned on and the drawer is open, the symbol in the control panel may
automatically turn off. The symbol will light up again when the drawer is inserted
- regardless of the state of the compartment, you may hear a faint noise, which you should consider as
normal
- when the compartment is not in operation, the temperature inside it depends on the general
temperature of the refrigerator compartment. In this case, it is advised that fruits and vegetables that
are not sensitive to cold (berries, apples, apricots, carrots, spinach, lettuce, etc.) are stored in it.
Important: if the compartment is turned on and food with a high water content is present,
condensation may form on the shelves. In this case, turn the function off temporarily.
Be careful when positioning food and containers that are small in size on the upper shelf of the “Zero
Degrees” compartment in order to prevent them accidentally falling between the shelf and the back
wall of the refrigerator compartment.
Removing the “Zero Degrees” compartment:
Carry out the following steps:
- to make it easier to remove the compartment, we recommend that you empty (and possibly remove)
9
Before contacting the Technical Assistance
Service:
Restart the appliance to check if the problem
has been solved. If not, disconnect the appliance
again and repeat the procedure after one hour.
If, after having completed the checks listed in the
guide for malfunctions and after restarting the
appliance, your appliance continues to function
incorrectly, contact the Technical Assistance
Service, clearly describing the problem and
stating:
• the type of malfunction
• the model
• the type and serial number of the appliance
(written on the rating plate)
• the Service number (if available) (the number
that is after the word SERVICE on the rating
plate placed inside the appliance)
Note:
Reversing the doors of the appliance, if carried
out by the Technical Assistance Service, is not
considered as a warranty claim.
TECHNICAL ASSISTANCE SERVICE
the lower door shelves
- turn off the compartment
- remove the compartment by rotating it upwards
- remove the white plastic shelf under the compartment
Note: it is not possible to remove the upper shelf and side supports.
To use the “Zero Degrees” compartment again, carefully reposition the white plastic shelf under the
compartment before inserting the drawer and turning the function back on.
To have a larger refrigerator volume and to reduce energy consumption, it is recommended that you
turn off the “Zero Degrees” compartment and remove the compartment.
Clean the compartment and its components occasionally using a cloth and a solution of warm water
(taking care not to submerge the white plastic shelf under the drawer) and neutral cleaning agents
specifically for cleaning the inside of the refrigerator. Do not use abrasive cleaning agents.
Before cleaning the compartment (also externally) it is necessary to remove the drawer to
disconnect the electrical supply for the compartment.
400010866852 02/16
EN