LevelOne IPS-1201E User Manual
Displayed below is the user manual for IPS-1201E by LevelOne which is a product in the Power Distribution Units (PDUs) category. This manual has pages.
Related Manuals
IPS-1201
12-Outlet Intelligent Power Distribution Unit
Quick Installation Guide
Windows Users
Revision: A
May, 2018
- 1 -
Getting Started
The following procedure describes the
basic
steps
needed to set
up the PDU III:
1.
To set up the hardware, connect power to the
power inlet and output devices to the power
outlets. Connect to an EMD to the EMD port.
2.
To configure the PDU III, users can use the console
(mini USB Port) or LAN port. Connect the PDU III to a
console and a LAN to enable its configuration through
the console or browser menu.
3.
After connecting to a console (mini USB port), use a console application such as PuTTY to access
the console menu. Please set up the PuTTY configuration as shown firstly. After PuTTY configuration
and please enter default user name and password (admin/admin). Select the IP, Time and System
Group submenu under the PDU Configuration Settings to set up the related IP address and the
system date/time. This IP address will be used while accessing the web interface to configure the PDU
III parameters.
a. To configure the related Serial line and Speed (115200) of the PuTTY. Regarding to Serial line, please
check Connection Port (COM) of Device Manger in the Window system.
- 2 -
b. To enter the username and password (default username and password: admin).
c. To select PDU Configuration Setting.
d. To Select IP, Time and System Group.
- 3 -
- 4 -
e. To Select IPV4 Group.
f. To configure the related IPv4 parameters.
4. After connecting to LAN, open a browser from a PC in the network and use the PDU III’s IP address
specified through the console menu to open the web interface for system configuration.
- 5 -
Connecting EMD
An Environmental Monitor Device (EMD) that is connected to sensors for detecting temperature,
humidity, water leak and so on can be connected to the PDU III with the console port. The EMD can
also be connected to alarms or indicators and controlled through the PDU III. Connect the EMD to
the console port as shown:
After connecting to EMD, open a browser from a PC in the network. The temperature and
humidity status is automatically displayed on the PDU III Environment Monitoring page.