Table of Contents
Little Tikes 3 in 1 Mobile Entertainer User Manual
Displayed below is the user manual for 3 in 1 Mobile Entertainer by Little Tikes which is a product in the Baby Walkers category. This manual has pages.
Related Manuals
1
635946/992261
Illustrations are for reference only. Styles may vary from actual contents.
Ages 6-18 months
ADULT BATTERY INSTALLATION AND ASSEMBLY REQUIRED
‘Let’s care for the environment!’
The wheelie bin symbol indicates that the product must not be disposed of with other household
waste. Please use designated collection points or recycling facilities when disposing of the item.
Do not treat old batteries as household waste. Take them to a designated recycling facility.
Adult Battery Installation:
1. Using a Phillips screwdriver (not included) remove the screw and battery compartment
cover from the bottom of the Cozy Coupe® 3 in 1 Mobile Entertainer. (Fig. 1)
2. Install two (2) 1.5V AA alkaline batteries (not included) making sure the (+) and (-) ends face
the proper direction as indicated inside the battery compartment. (Fig. 2)
3. Replace the compartment cover and tighten the screw.
CONTENTS
BEFORE YOU BEGIN
Cozy Coupe®
3 in 1 Mobile Entertainer
1
8
Visit our website at
www.littletikes.com
to register your product
and to enter our
sweepstakes.
(No purchase necessary)
Please keep this manual as it contains important information.
© The Little Tikes Company,
an MGA Entertainment company.
LITTLE TIKES® and COZY COUPE® are trademarks of Little Tikes in
the U.S. and other countries. All logos, names, characters, likenesses,
images, slogans, and packaging appearance are the property of
Little Tikes.
Little Tikes Consumer Service
2180 Barlow Road Hudson, Ohio 44236 U.S.A.
1-800-321-0183
Printed in China
FCC COMPLIANCE
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: Modifications not authorized by the manufacturer may void users authority to operate this device.
Fig. 1
Fig. 2
The Little Tikes Company makes fun, high quality toys. We warrant to the original purchaser that this product
is free of defects in materials or workmanship for one year * from the date of purchase (dated sales receipt is
required for proof of purchase). At the sole election of The Little Tikes Company, the only remedies available
under this warranty will be the replacement of the defective part or replacement of the product. This
warranty is valid only if the product has been assembled and maintained per the instructions. This warranty
does not cover abuse, accident, cosmetic issues such as fading or scratches from normal wear, or any other
cause not arising from defects in material and workmanship. *The warranty period is three (3) months for
daycare or commercial purchasers.
U.S.A and Canada: For warranty service or replacement part information, please visit our website at
www.littletikes.com, call 1-800-321-0183 or write to: Consumer Service, The Little Tikes Company, 2180
Barlow Road, Hudson OH 44236, U.S.A. Some replacement parts may be available for purchase after warranty
expires—contact us for details.
Outside U.S.A and Canada: Contact place of purchase for warranty service. This warranty gives you specific
legal rights, and you may also have other rights, which vary from country/state to country/state. Some
countries/states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you.
LIMITED WARRANTY
C.
G.
J.
www.littletikes.com
2 x AA Batteries
1.5V AA/LR6
1.5V AA/LR6
(Not included)
• Charging of rechargeable batteries should only be done under adult supervision. Use only size “AA” (LR6)
alkaline batteries (2 required).
• Never mix old batteries with new batteries, rechargeable (nickel-cadmium) or carbon zinc with alkaline
batteries.
• Be sure to insert the batteries correctly and follow the toy and battery manufacturer’s instruction.
• Always remove exhausted or dead batteries from the product.
• Dispose of dead batteries properly: do not burn or bury them.
• Do not attempt to recharge non-rechargeable batteries.
• Remove rechargeable batteries from the product before recharging.
• Charging of rechargeable batteries should only be done under adult supervision with batteries removed
from product.
• Avoid short-circuiting battery terminals.
• Remove batteries before placing unit into storage for a prolonged period of time.
BATTERY SAFETY INFORMATION
D.
H. I.
L R
LR
F.
A.
B.
A. 1 Vehicle Body of Little
Tikes® Cozy Coupe® 3 in 1
Mobile Entertainer
B. 1 Rolling Base
C. 1 Activity Bar with 3 Rings
D. 2 Front Wheels
E. 2 Rear Wheels
F. 1 Steering Wheel
G. 1 Removable Seat
Cushion
H. 1 Seat Backing
E.
1214-1-E
I. 2 Suspension Pegs
J. 2 Suspension Boots
27
IMPORTANT NOTE: Once the Activity Bar is installed, it cannot be removed.
1. Slide the rings onto the Activity Bar.
2. With the bar curve facing away from the seat, align the pegs on the Activity Bar with the
openings above the dashboard. (Fig. 23)
3. Press down firmly until the Activity Bar fits into place. (Fig. 24)
ACTIVITY BAR
Fig. 23 Fig. 24
WARNING:
ADULT ASSEMBLY REQUIRED
• Read all instructions before assembly and use of the Cozy Coupe®
3 in 1 Mobile Entertainer. Keep instructions for future use.
• Failure to follow instructions and warnings could result in serious
injury or death.
• Discontinue use of this product once child can walk unassisted.
• Do not use the Cozy Coupe® 3 in 1 Mobile Entertainer if it is damaged
or broken.
• Use only on flat, level surfaces free of objects that could cause the
walker to tip over.
• Do not use until baby / child can sit up by itself. This Cozy Coupe® 3 in
1 Mobile Entertainer is only intended for use with children who can sit
upright unassisted at approximately 6 months of age.
• Maximum child’s weight: 25 lbs. Limit 1 child.
• To avoid burns, keep the child away from hot liquids, ranges, radiators,
space heaters, fireplaces, etc.
• Never use near steps, pools, hot surfaces, or areas that may be
hazardous to a child.
• Do not expose the Cozy Coupe® 3 in 1 Mobile Entertainer to liquid of
any kind as moisture may damage the unit. Wipe clean with a damp
cloth only. See separate instructions below for washing Seat Cushion.
•
Clean friction pads regularly to maintain stopping performance. See
IMPORTANT NOTE on Page
5
for further information.
• Never use near staircase.
• Strings can cause strangulation! DO NOT place items with a string
around child’s neck, such as hood strings or pacifier cords. DO NOT
suspend strings over product or attach strings to toys.
WARNING:
Never leave child unattended. Always keep child in view while in walker.
WARNING:
Parking brake use does not totally prevent walker movement. Always
keep child in view while in walker, even when using the parking brake.
WARNING:
STRANGULATION HAZARD
Never place walker near windows where cords from blinds or drapes
may strangle child.
WARNING
– STAIR HAZARD
Avoid serious injury or death.
Block stairs/steps securely before using walker even when using
parking brake.
2
SEAT CUSHION WASHING AND DRYING INSTRUCTIONS
• Machine wash separately in cold water with machine set to the delicate cycle.
• Do not use chlorine bleach or hot iron.
• Drip dry ~ do not put in dryer.
WARNINGS
STEERING WHEEL ASSEMBLY
IMPORTANT NOTE: Once the Steering Wheel is snapped into place, it cannot be removed.
1. Connect the wires from the Steering Wheel to the wires in the Dashboard. (Fig. 21)
2. Tuck the wires into the opening.
3. Insert the Steering Wheel into the opening with the numbered buttons at the bottom and
snap it into place. (Fig. 22)
Fig. 21Fig. 21 Fig. 22
Fig. 22
23
6
THE WALKER
1. There are 3 positions on the Walker for different heights indicated on the suspension pegs.
Position 3 is tallest, 2 is medium, and 1 is shortest.
2. To adjust the height for Positions 1 and 2 start with the knobs beneath the Suspension Pegs
in the vertical position (unlocked). Push down on the vehicle to the desired number, then
push in and turn the knobs to the locked position (Fig. 18 & 19). The numbers on both sides
of the Rolling Base must match before child use. Confirm that the position is locked before
child use.
3. As the infant grows, move the Walker to the next position and lock it in place.
IMPORTANT NOTE: Remove child before adjusting to the next position. Push in and turn the
knobs beneath the Suspension Pegs to unlock the position.The knobs on the Rolling Base must
be in the vertical position (unlocked) to use the Walker. Walker is intended for use on hard, level
surfaces.
1. In Position 3, turn the knob on the Rolling Base to the “Lock” position to lock it in place as
shown. (Fig. 20)
IMPORTANT NOTE: The vehicle will ONLY bounce in Position 3 (unlocked).
Fig. 18
Fig. 19
Fig. 3Fig. 3
SEAT CUSHION
1. Snap the Seat Backing into the back of the Walker. (Fig. 3)
2. Put the Seat Cushion into the opening of the Walker as shown. (Fig. 4)
3. Slip the back of the cushion over the Seat Backing. (Fig. 5)
Fig. 5Fig. 5
Fig. 4
Fig. 4
Fig. 20
THE BOUNCER (STATIONARY ACTIVITY CENTER)
Fig. 8Fig. 8
Fig. 7Fig. 7
4. Slide the clips indicated “1” through the corresponding openings on the seat area. (Fig. 6 & 7)
5. Pull the clips through the underside of the Walker and fit them over the tabs. (Fig. 9)
6. Repeat this process for clips indicated “2” (Fig. 6) and then clips indicated “3” (Fig. 6 & 8) until all
clips are securely fastened.
IMPORTANT NOTE: To remove the cushion for washing, follow these steps in reverse order, leaving
the Seat Backing in place. See SEAT CUSHION WASHING AND DRYING INSTRUCTIONS on page 2.
11
22
3
33
3
Fig. 6Fig. 6
seat undersideseat underside
Fig. 9Fig. 9
Fig. 15bFig. 15b
IMPORTANT NOTE: Once the Suspension Pegs are snapped
into place, they cannot be removed.
1. Remove the Suspension Boot from the Suspension Peg.
2. Turn the knob beneath the Suspension Peg so that it is
vertical. (Fig. 15a)
3. Place one Suspension Peg into the opening on the Rolling Base, aligning parts X and Y as
shown. Firmly press the Suspension Peg down onto the rolling base until the side tabs lock in
place. (Fig. 15a & 15b) Confirm the spring is engaged by pushing down on the peg a few
times.
4. Place the Suspension Boot on top of the Suspension Peg as shown. (Fig. 16)
5. Repeat steps 1-4 on the opposite side of the Rolling Base.
245
6. Turn the knobs beneath the Suspension Pegs so that they are horizontal.
7. Press the vehicle body onto the Suspension Pegs with the rear wheels directly over the knob
on the Rolling Base as shown. (Fig. 17a & 17b)
Suspension Peg
Suspension Boot
ROLLING BASE
1. With the vehicle body upside down, insert
Rear Wheel (L) as shown. (Fig. 10)
2. Push downward until wheel posts click into
place. (Fig. 11 and 12)
3. Repeat above steps for Rear Wheel (R)
assembly.
Fig. 10
Fig. 11
Fig. 11
Fig. 12
Fig. 12
1. With the vehicle body upside down, insert Front Wheel (L) as shown. (Fig. 13)
2. Press firmly until wheel is seated into unit body. (Fig. 14)
3. Repeat above steps for Front Wheel (R) assembly.
Fig. 13 Fig. 14
REAR WHEEL ASSEMBLY
FRONT WHEEL ASSEMBLY
CLICK!
Rear Wheel (L)
Front Wheel (L)
Fig. 17aFig. 17a
Fig. 16Fig. 16
Fig. 17b
Fig. 17b
TAB
TAB
X
YKNOB
Fig. 15a