Peerless DS-VWM770 User Manual
Displayed below is the user manual for DS-VWM770 by Peerless which is a product in the Signage Display Mounts category. This manual has pages.
Related Manuals
12013-08-27 #:125-9465-5 2014-04-21
DS-VWM770
ENG
46" - 70"
(1168 - 1778 cm)
125 lb
(56 kg)
MAX
22013-08-27 #:125-9465-5 2014-04-21
ENG - This product is designed to be installed on wood stud, solid concrete or cinder block walls. Hardware is
included for wood stud, solid concrete and cinder block installation. Before installing make sure the supporting
surface will support the combined load of the equipment and hardware. Screws must be tightly secured. Do
not overtighten screws or damage can occur and product may fail. Never exceed the Maximum Load Capacity.
Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This product is
intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury. Be
careful not to pinch ngers when operating the mount. For support please call customer care at 1-800-865-2112.
WARNING
Symbols
ENG
WARNING
ENG
#
Skip to step.
ENG
x3
Screws must get at least three
full turns and t snug.
ENG
Do not overtighten screws.
ENG
32013-08-27 #:125-9465-5 2014-04-21
5/32"
(4mm)
5/16"
(8mm)
Tools Needed for Assembly.
ENG
1
2
ENG To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
+1/2
4
3
3/8"
(10mm)
42013-08-27 #:125-9465-5 2014-04-21
B (4)
concrete anchor
locking tab
D (1)
C (4)
wood screw
.219" spacer
E (1)
polyester sleeve
F (2)
A (1)
wall plate
Parts (Before beginning, make sure you have all parts shown below).
ENG
Parts List
Part Description Qty. Part #
Awall plate 1 201-0387
Bconcrete anchor 4 590-0320
Cwood screw 4 5S1-015-C03
Dlocking tab 1 200-1871
E.219" spacer 1 540-1032
Fpolyester sleeve 2 600-1014
Gcable tie 4 560-9711
HM5 x 10mm screw 5 520-1063
IM4 x 12mm screw 4 510-1079
JM5 x 40mm screw 1 510-1001
K4mm allen wrench 1 560-9646
Ladaptor bracket 2 145-1779
Mplate assembly 1 145-1784
NM10 x 15mm 4 520-9262
OM5 x 8mm 4 520-1167
PM6 x 12mm 4 520-1050
Qshoulder washer 4 590-2233
RM8 x 15mm 4 520-1068
52013-08-27 #:125-9465-5 2014-04-21
M5 x 10mm M4 x 12mm M5 x 40mm
cable tie
H (5) I (4) J (1)
G (4)
L (2)
adaptor bracket
plate assembly
M (1) M10 x 15mm
N (4)
M5 x 8mm
O (4)
M6 x 12mm
P (4)
shoulder washer
Q (4)
M8 x 15mm
R (4)
4mm allen wrench
K (1)
62013-08-27 #:125-9465-5 2014-04-21
2a
ENG - When installing Peerless wall mounts on a
wood stud wall covered with gypsum board (drywall),
verify that the woods studs are a minimum of 2" x
4" nominal size. Do not install over gypsum board
thicker than 5/8".
WARNING
1
A
Remove
ENG
2
2a
Wood stud wall.
ENG
2b
Concrete/Cinder block.
ENG
2a-1 Use stud nder to locate
and mark stud center lines.
ENG
ENG
72013-08-27 #:125-9465-5 2014-04-21
2.5"
(64mm)
5/32"
(4mm)
Mounting hole must center on stud.
ENG
2a-3
5/32"
(4mm)
Drill mounting holes into supporting surface
(2.5" (64mm) minimum depth required).
ENG
A
3
A
C (4)
2a-4
Level wallplate. Install using wood screws provided.
ENG
Maximum 80 in. • lb (9 N.M.).
ENG
2a-2
Level wallplate. Mark mounting holes on stud
centerlines (studs must be 16" (406mm) on
center).
ENG
16.00"
(406mm)
82013-08-27 #:125-9465-5 2014-04-21
2b-1
2b-2
5/16"
(8mm)
2.5"
(64mm)
5/16"
(8mm)
Level wallplate. Mark mounting holes.
ENG
Do not drill into mortar joints.
ENG
A
Drill mounting holes into supporting surface
(2.5" (64mm) minimum depth required).
ENG
2b
ENG • When installing Peerless wall mounts on a concrete wall, the wall must be at least 8" thick with a minimum
compressive strength of 2000 psi.
• When installing Peerless wall mounts on a cinder block wall, the cinder blocks must meet ASTM C-90
specications and have a minimum nominal width of 8". Do not drill into mortar joints! Be sure to mount in a solid
part of the block, generally 1" (25 mm) minimum from the side of the block. It is suggested that a standard electric
drill on slow setting is used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole
when entering a void or cavity.
• Never attach expansion anchors to concrete or cinder block covered with plaster, drywall or other nishing
material.
WARNING
92013-08-27 #:125-9465-5 2014-04-21
B (4)
A
C (4)
1b-42b-4
2b-32b-3
Level wallplate. Install using concrete
anchors and wood screws provided.
ENG
Maximum 80 in. • lb (9 N.M.).
ENG
B
Insert anchor ush to concrete.
ENG
10 2013-08-27 #:125-9465-5 2014-04-21
3
A
11 2013-08-27 #:125-9465-5 2014-04-21
4
BOTTOM OF THE TV
LANDSCAPE
PORTRAIT
45
ROTATION PLATE
TOP OF TV
90°
EACH MARK
ROTATES TV
CLOCKWISE
90°
EACH MARK ROTATES TV
COUNTER-CLOCKWISE
DETAIL A
SCALE 2 : 1.5
90°
-90°
-75°
-60°
-45°
-30°
-15°
0°
15°
30°
45°
60°
75°
Setting the angle of the display.
ENG
Rotation Guide
ENG
Each notch rotates display
counter-clockwise 15°
Portrait
ENG
Portrait
ENG
Each notch rotates display
clockwise 15°
Landscape
ENG
4-2
Line up the viewport with the desired angle (view).
ENG
Rotating Plate
ENG
4-1
M
Viewport
ENG
Notch
ENG
Rotating Plate
ENG
ENG The viewport is used to reveal notches indicating the angle (view) of the display.
M
Viewport
ENG
12 2013-08-27 #:125-9465-5 2014-04-21
5
Leaving ¼" exposed thread, thread two M10 x 15mm (N) screws through plate assembly (M) and
rotating plate.
ENG
M
6
Slide plate assembly (M) into adaptor bracket (L) slots.
ENG
L
M
N
1/4"
(6mm)
13 2013-08-27 #:125-9465-5 2014-04-21
Determine VESA mounting pattern.
ENG
6-1
300mm x 300mm
400mm x 300mm
400mm x 400mm
400mm x 200mm
600mm x 400mm
500mm x 400mm
14 2013-08-27 #:125-9465-5 2014-04-21
6-2
L
Q
P, R
6-3
Secure plate assembly (M) to adaptor bracket (L) with four M5 x 8mm screws (O).
M
L
O
ENG
Do not use screws on inner adaptor bracket opening.
ENG
15 2013-08-27 #:125-9465-5 2014-04-21
8
G
F
7-1
N
M
A
7
Hook M10 x 15mm screws (N) of plate assembly (M) into top two key holes of wall plate (A).
ENG
TIGHTEN
CONNECTING
HARDWARE
16 2013-08-27 #:125-9465-5 2014-04-21
Adaptor Bracket Adjustment
9-2
9-3
9-1
9
Display adjustment.
ENG
17 2013-08-27 #:125-9465-5 2014-04-21
Turn knob CLOCKWISE to move corner toward the wall.
Turn knob COUNTER-CLOCKWISE to move corner away from the wall.
10
Use legend below to determine position of display. Each knob can be adjusted
independently for ne tuning adjustments.
ENG
18 2013-08-27 #:125-9465-5 2014-04-21
11-1
Lock-down in retracted position.
ENG
J (1)
11-2
Lock-down one arm in place.
ENG
H (1)
D (1)
E (1)
11
OPTIONAL: Alternative wall plate lock-down positions.
ENG
A
A
19 2013-08-27 #:125-9465-5 2014-04-21
This page intentionally left blank.
ENG
Peerless-AV
2300 White Oak Circle
Aurora, IL 60502
Email: tech@peerlessmounts.com
Ph: (800) 865-2112
Fax: (800) 359-6500
www.peerless-av.com
© 2014, Peerless Industries, Inc.
Peerless Industries, Inc. (“Peerless”) warrants to original end-users of Peerless® products will be free from defects in material and
workmanship, under normal use, for a period of ve years from the date of purchase by the original end-user (but in no case longer than
six years after the date of the product's manufacture). At its option, Peerless will repair or replace, or refund the purchase price of, any
product which fails to conform with this warranty.
In no event shall the duration of any implied warranty of merchantability or tness for a particular purpose be longer than the
period of the applicable express warranty set forth above. Some states do not allow limitations on how long a implied warranty lasts,
so the above limitation may not apply to you.
This warranty does not cover damage caused by (a) service or repairs by the customer or a person who is not authorized for such service
or repairs by Peerless, (b) the failure to utilize proper packing when returning the product, (c) incorrect installation or the failure to follow
Peerless' instructions or warnings when installing, using or storing the product, or (d) misuse or accident, in transit or otherwise, including
in cases of third party actions and force majeure.
In no event shall Peerless be liable for incidental or consequential damages or damages arising from the theft of any product,
whether or not secured by a security device which may be included with the Peerless® product. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
This warranty is in lieu of all other warranties, expressed or implied, and is the sole remedy with respect to product defects. No dealer,
distributor, installer or other person is authorized to modify or extend this Limited Warranty or impose any obligation on Peerless in
connection with the sale of any Peerless® product.
This warranty gives specic legal rights, and you may also have other rights which vary from state to state.
LIMITED FIVE-YEAR WARRANTY
Patented. Utility Patent No. 8,517,322