Philips BT1300R/00 User Manual
Displayed below is the user manual for BT1300R/00 by Philips which is a product in the Portable Speakers category. This manual has pages.
Related Manuals
www.philips.com/support
User manual
Always there to help you
Register your product and get support at
Question?
Contact
Philips
BT1300
1EN
Contents
1 Important 2
2 Your Bluetooth speaker 3
Introduction 3
What's in the box 3
Overview of the speaker 4
3 Get started 5
Attach the string 5
Charge the built-in battery 5
Turn on/off 5
4 Play 6
Use Bluetooth devices 6
Play from external devices 7
Adjust volume 7
5 Product information 8
Specications 8
6 Troubleshooting 9
General 9
About Bluetooth device 9
7 Notice 10
Compliance 10
Care of the environment 10
Trademark notice 11
2EN
1 Important
Warning
•Never remove the casing of this speaker.
•Never lubricate any part of this speaker.
•Never place this speaker on other electrical equipment.
•Keep this speaker away from direct sunlight, naked
amesorheat.
• Make sure that there is enough free space
around the speaker for ventilation.
• Only use attachments or accessories
speciedbythemanufacturer.
• The battery shall not be exposed to
excessiveheatsuchassunshine,reorthe
like.
• The speaker shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on
thespeaker(e.g.liquidlledobjects,lighted
candles).
Note
•The type plate is located on the back of the product.
3EN
2 Your Bluetooth
speaker
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker, you can enjoy audio from
your Bluetooth-enabled devices, or other
external audio devices.
What's in the box
Check and identify the contents of your
package:
• Speaker
• USB cable for charging
• String for carrying
• Short user manual
• Safetyandnoticeleaet
Short user manual
www.philips.com/welcome
Always there to help you
Register your product and get support at
Question?
Contact
Philips
4EN
Overview of the speaker
a LED indicator
b
• Disconnect Bluetooth connection.
• Enter Bluetooth pairing mode.
• Answer or reject an incoming call.
• End the current phone call.
• Transfer the call to your mobile device.
c DC IN
• Recharge the built-in battery with a
USB cable.
d AUDIO IN
• Connect an external audio device.
e OFF/AUDIO IN/
• Select Bluetooth or AUDIO IN source.
• Turn the speaker off.
a
bcde
5EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Attach the string
For easy carrying, attach the supplied string to
this speaker as illustrated.
Charge the built-in battery
The speaker is powered by a built-in
rechargeable battery.
Note
•Before use, fully charge the built-in battery.
•The micro USB socket is for charging only.
•Rechargeable battery has a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
Connect the supplied USB cable between
• the DC IN socket on the speaker, and
• a USB socket of a computer.
Charging indicator status
The LED indicator indicates the battery status.
Under charging Fully charged
"OFF"
mode
Flashing white Off
"AUDIO
IN" mode
Flashing white Solid white
"Bluetooth"
mode
Flashing blue
or solid blue
(depending
on Bluetooth
connection
status)
Flashing blue
or solid blue
(depending
on Bluetooth
connection
status)
Turn on/off
• To turn the speaker on, slide the
OFF/AUDIO IN/ switch to or AUDIO
IN.
• : Listen to an external Bluetooth
device through Bluetooth connection.
• AUDIO IN: Listen to an external
device through an audio input cable.
• To turn the speaker off, slide the switch to
OFF.
DC IN
6EN
4 Play
Use Bluetooth devices
With this speaker, you can listen to audio from
Bluetooth-enabled devices and control the
incoming call through Bluetooth.
Play from Bluetooth devices
Note
•Make sure that your Bluetooth device is compatible
with this speaker.
•Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
•The speaker can memorize a maximum of 4 paired
devices.
•Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
•Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
•Keep away from any other electronic device that may
cause interference.
•The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
•If there is an incoming call on the connected mobile
phone, music playback pauses.
1 Slide the OFF /AUDIO IN/ switch to .
» TheLEDindicatorashesblue.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (refer to the user
manual of the device).
3 When [Philips BT1300] is displayed on
your device, select it to start pairing and
connection. If necessary, input “0000” as
the pairing password.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator turns solid blue.
4 Play audio on the Bluetooth device.
» Audio streams from your Bluetooth
device to the speaker.
To disconnect the Bluetooth-enabled device:
• Press and hold for two seconds;
• Disable Bluetooth on your device; or
• Move the device beyond the
communication range.
» TheLEDindicatorashesblue.
To reconnect the Bluetooth device:
• Next time you turn on the speaker, the
speaker will reconnect the last connected
device automatically; or
• On your Bluetooth device, select "Philips
BT1300" on your Bluetooth menu to start
pairing.
To connect another Bluetooth-enabled device:
1 Press and hold for two seconds to
disconnect the currently connected device;
» The speaker enters Bluetooth pairing
mode.
2 Connect another Bluetooth device.
LED indicator Description
Flashing blue Connecting;
Waiting for pairing
Solid blue Connected
Control your phone call
After Bluetooth connection, you can control an
incoming call with this speaker.
Button Function
Press to answer an incoming call.
Press and hold to reject an incoming
call.
During a call, press to end the current
call.
During a call, press and hold to
transfer the call to your mobile device.
Note
•Music play pauses when there is an incoming call, and
resumes when your phone call ends.
7EN
Play from external devices
With this speaker, you can also listen to an
external audio device such as an MP3 player.
1 Connect an audio input cable (not
supplied) with a 3.5 mm connector on
both ends to
• the AUDIO IN socket on this speaker,
and
• the headphone socket on the external
device.
2 Slide the OFF /AUDIO IN/ switch to
AUDIO IN.
» The LED indicator becomes white.
3 Play audio on the external device (refer to
its user manual).
Adjust volume
During play, use the volume control on your
Bluetooth or external device to adjust volume.
AUDIO-IN
8EN
5 Product
information
Note
•Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 2 W RMS
Frequency Response 80 -16000 Hz, ±3 dB
Signal to Noise Ratio >70 dBA
Audio-in Input 300 mV RMS
Speakers
Speaker Impedance 4 ohm
Speaker Driver 4.5 cm full range
Sensitivity >81dB/m/W±3dB/
m/W
Bluetooth
Bluetooth Version V3.0
BluetoothProle HFP, HSP, A2DP
Bluetooth Frequency
Brand
2.4 GHz ~ 2.48 GHz
Bluetooth Range 10 m (Free space)
General information
Power Supply
(through USB socket)
5 V 0.5 A
Built-in Battery Li-polymer battery
(3.7 V, 500 mAh)
Dimensions - Main Unit
(W x H x D)
55 x 55 x 55 mm
Weight - Main Unit 0.1 kg
9EN
6 Troubleshooting
Warning
•Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
General
No power
• Recharge your speaker.
No sound or poor sound
•Adjust volume on the connected device.
No response from the speaker
•Restart the speaker.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Cannot connect with the device.
•The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
•This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
Fail to search out BT1300 on your device for
pairing.
•Press and hold for three seconds, and
then try again.
The paired device connects and disconnects
constantly.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
•For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature. This does not indicate
any malfunction of this product.
10 EN
7 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Compliance
Hereby, WOOX Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
ofDirective1999/5/EC.Youcanndthe
Declaration of Conformity on www.philips.com/
support.
Care of the environment
Disposal of your old product and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU.
This symbol means that the product contains
a built-in rechargeable battery covered by
European Directive 2013/56/EU which cannot
be disposed of with normal household waste.
We strongly advise you to take your product to
anofcialcollectionpointoraPhilipsservice
centre to have a professional remove the
rechargeable battery.
Inform yourself about the local separate
collection system for electrical and electronic
products and rechargeable batteries. Follow
local rules and never dispose of the product
and rechargeable batteries with normal
household waste. Correct disposal of old
products and rechargeable batteries helps
prevent negative consequences for the
environment and human health.
Caution
•Removal of the built-in battery invalidates the warranty
and may destroy the product.
Always bring your product to a professional to
remove the built-in battery.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
A
11EN
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by WOOX
Innovations is under license.
2014 © WOOX Innovations Limited. All rights reserved.
Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V.
BT1300_00_UM_V2.0