Table of Contents
- 1 Important
- 2 Your Portable Speaker
- 3 Get started
- 4 Use Bluetooth devices
- 5 Listen to an external device
- 6 Adjust volume
- 7 Product information
- 8 Troubleshooting
- 9 Notice
- 1 Important
- 2 Your Portable Speaker
- 3 Get started
- 4 Use Bluetooth devices
- 5 Listen to an external device
- 6 Adjust volume
- 7 Product information
- 8 Troubleshooting
- 9 Notice
Philips SB2000B/00 User Manual
Displayed below is the user manual for SB2000B/00 by Philips which is a product in the Portable Speakers category. This manual has pages.
Related Manuals
www.philips.com/support
User manual
Always there to help you
Register your product and get support at
SB2000
Question?
Contact
Philips
1
Contents
1 Important 2
2 Your Portable Speaker 3
Introduction 3
What's in the box 3
3 Get started 4
Charge the built-in battery 4
Power on/off 4
4 Use Bluetooth devices 6
Connect a device 6
Play audio via Bluetooth 7
Make a call 7
Clear the pairing history 7
5 Listen to an external device 8
6 Adjust volume 9
7 Product information 10
General information 10
Bluetooth 10
Amplier 10
8 Troubleshooting 11
General 11
About Bluetooth device 11
9 Notice 12
Compliance 12
Care of the environment 12
Trademark notice 12
Copyright 13
EN
2EN
1 Important
• Read these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not place the product near any heat
sources such as radiators, heat registers,
stoves, or other devices (including
ampliers)thatproduceheat.
• Onlyuseattachments/accessoriesspecied
by the manufacturer.
• Referallservicingtoqualiedservice
personnel. Servicing is required when the
product has been damaged in any way.
• Do not place any sources of danger on the
product, for example, lighted candles.
• Keep the product away from direct
sunlight,nakedamesorheat.
• During charging the battery or listening to
an external device through the USB cable,
do not expose this product to any liquid.
• Make sure that the protective lid is tightly
closed before exposing this product to any
liquid.
• Never open the protective lid under humid
circumstance or when the product is wet.
• After use under humid circumstance,
immediately clean the product with a soft
dry cloth and let it dry in a well-ventilated
place away from direct sunlight.
• The battery shall not be exposed to
excessiveheatsuchassunshine,reorthe
like.
• Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
Warning
• Never remove the casing of this apparatus.
• Never lubricate any part of this apparatus.
• Never place this apparatus on other electrical
equipment.
Caution
• Removal of the built-in battery invalidates the warranty
and may destroy the product.
Always bring your product to a professional to
remove the built-in battery.
Note
• Rechargeable batteries have a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
Note
• The type plate is located on the bottom of the product.
3EN
2 Your Portable
Speaker
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/support.
Introduction
With this speaker, you can
• listen to audio from an external device via
Bluetooth connection,
• listen to audio from an external device
through the micro USB socket, and
• make phone calls.
What's in the box
Check and identify the contents of your
package:
• Main unit
• USB cable
• Short user manual
• Safety sheet
DTD3190
Short User Manual
www.philips.com/welcome
Always there to help you
Register your product and get support at
Question?
Contact
Philips
4EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Charge the built-in battery
The speaker is powered by a built-in
rechargeable battery.
Note
• Before use, fully charge the built-in battery.
1 Open the protective lid.
2 Connect the USB cable between
• the micro USB socket on the speaker,
and
• a USB socket on your computer.
Battery indicator
The LED indicator beside the button
indicates the battery status.
Indicator Battery
Solid red Under charging
Off Fully charged
5V A
Power on/off
Press to power it on or off.
Note
• If the USB cable is connected to the micro USB socket,
this product does not automatically power off. To save
battery power, disconnect the USB cable or manually
power off the product after use.
• In Bluetooth mode, if there is no Bluetooth connection
or no audio is streamed to this product within 15
minutes, this product automatically powers off.
Use the auto sensor
An auto sensor is integrated in this product.
You can adjust the direction of this product to
power it off easily.
1 Switch the slider to ON to enable the auto
sensor.
OFFON ON
OFFON
5EN
2 Put the speaker upside down.
» After 30 seconds, it powers off
automatically.
• To power it on again, press .
• To disable the auto sensor, switch the
slider to OFF.
6EN
4 Use Bluetooth
devices
With this speaker, you can listen to audio from
a player and make a call through Bluetooth.
Note
• Gibson Innovations does not guarantee the
compatibility with all Bluetooth devices.
• Before pairing a device with this product, read its user
manual for Bluetooth compatibility. Make sure that the
connected Bluetooth device supports the Advanced
AudioDistributionProle(A2DP)andtheAudioVideo
RemoteControlProle(AVRCP).
• The product can memorize a maximum of 4 paired
devices.
• Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
• The operational range between this product and a
Bluetoothdeviceisapproximately10meters(30feet).
• Any obstacle between this product and a Bluetooth
device can reduce the operational range.
• Keep away from any other electronic device that may
cause interference.
Connect a device
SB2000
1 On your device, search for Bluetooth
devices.
2 In the device list, select SB2000.
• If a message prompts for the
permission for Bluetooth connection
with SB2000,conrmit.
• If a password is required, enter 0000
andthenconrm.
» The speaker beeps when the
Bluetooth connection is established.
Bluetooth indicator
The LED indicator beside the button
indicates the status of Bluetooth connection.
Indicator Bluetooth connection
Blinking blue Connecting or waiting for
connection
Solid blue Connected
Disconnect a device
On your device, disable the Bluetooth
connection with this product.
Note
• Before connecting another Bluetooth device, disconnect
thecurrentdevicerst.
Reconnect a device
• For a paired Bluetooth device on which
the automatic reconnection is enabled,
this product reconnects with it once it is
detected.
• For a paired Bluetooth device that does
not support the automatic reconnection,
reconnect it with this product manually.
7EN
Play audio via Bluetooth
Note
• If the connected Bluetooth device supports the
AdvancedAudioDistributionProle(A2DP),youcan
listen to tracks that are stored on the device through
the system.
• IfthedevicealsosupportstheAudioVideoRemote
ControlProle(AVRCP),youcancontrolplayonthis
product.
• IftheconnecteddevicedoesnotsupporttheAVRCP,
control play on the connected device.
• If there is an incoming call on the connected mobile
phone, music play pauses.
Buttons Functions
Start, pause, or resume play.
/ Increase or decrease the speaker
volume.
Make a call
Buttons Functions
Press to answer an incoming call.
Press to end the current call.
Press and hold to reject an incoming
call.
Press twice to dial the last called
number.
Press twice to hold on the current
call and answer another incoming call.
/ Increase or decrease the speaker
volume.
Clear the pairing history
When the product is powered off, press and
hold for 8 seconds.
8EN
5 Listen to an
external device
You can also listen to an external audio device,
for example, MP3 player, through this product.
Note
• Make sure that no device is streaming audio to the
speaker via Bluetooth.
1 Open the protective lid.
2 Connect the USB cable between
• the micro USB socket on this product,
and
• the headphone socket on the external
device.
3 Play audio on the external device (refer to
itsusermanual).
9EN
6 Adjust volume
Press / .
10 EN
7 Product
information
Note
• Product information is subject to change without prior
notice.
General information
Power Supply (through
USBsocket)
5V 1 A
Built-in Battery Lithium battery
(500mAh,7.4V)
Dimensions - Main
Unit(WxHxD)
123 X 92 X 123 mm
Weight - Main Unit 0.6 kg
Bluetooth
Bluetoothspecication V3.0
Supportedproles A2DPV1.0,AVRCP
V1.0,HFP,andHSP
Range 10m(Freespace)
Amplier
Rated Output Power 5 W RMS
Signal to Noise Ratio > 50 dBA
Audio input through
micro USB socket
650mVRMS,22kOhm
11EN
8 Troubleshooting
Warning
• Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support).Whenyoucontactthe
Consumer Care, make sure that the product
is nearby and the model number and serial
number are available.
General
No power
• Recharge your speaker.
No sound
•Adjust volume on this product.
•Adjust volume on the connected device.
•Make sure that your Bluetooth device is
within the effective operational range.
No response from the speaker
•Restart the speaker.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Cannot connect with the device.
•The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
•This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
The paired device connects and disconnects
constantly.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
•For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature. This does not indicate
any malfunction of this product.
12 EN
9 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
Gibson Innovations may void the user’s
authority to operate the equipment.
Compliance
This product is designed to be waterproof in
compliance with IEC 60529 IPX4.
This product complies with the radio
interference requirements of the European
Community.
Hereby, Gibson Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
ofDirective1999/5/EC.Youcanndthe
Declaration of Conformity on www.philips.com/
support.
Care of the environment
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
Your product contains batteries covered by
the European Directive 2006/66/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separateintothreematerials:cardboard(box),
polystyrenefoam(buffer)andpolyethylene
(bags,protectivefoamsheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Gibson
Innovations is under license.
13EN
Copyright
2014 © Gibson Innovations Limited. All rights
reserved.
Philips and the Philips’ Shield Emblem are
registeredtrademarksofKoninklijkePhilipsN.V.
and are used by Gibson Innovations Limited
underlicensefromKoninklijkePhilipsN.V.”
Specicationsaresubjecttochangewithout
notice. Gibson reserves the right to change
products at any time without being obliged to
adjust earlier supplies accordingly.
2015 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of
Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation
to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V. and are used under license from Koninklijke Philips N.V.
SB2000_00_UM_V3.0