Table of Contents
Philips SPN4087C/10 User Manual
Displayed below is the user manual for SPN4087C/10 by Philips which is a product in the Surge Protectors category. This manual has pages.
Related Manuals
Register your product and get support at
www.philips.com/welcome
EN Surge protector
1
Contents
English
EN
Contents
1 Important safety instructions 2
Recycling the product 2
2 Your surge protector 2
Feature highlights 2
3 Get started 3
Connect the surge protector 3
Connect the surge protector to a
phone/fax/modem 3
Conditions for damage claims 4
Connect the surge protector to a TV/
VCR/DVD/satellite/cable box 4
Conditions for damage claims 4
4 Limited warranty 5
One year product limited warranty 5
Connected equipment warranty 5
2
2 Your surge
protector
Congratulations on your purchase and welcome
to Philips!
To fully benet from the support that Philips
offers, register your product at www.philips.
com/welcome.
For online help, go to www.philips.com/support.
Feature highlights
Your surge protection is equipped with any of
the following features. Check the availability of
these features on the package.
Protection indicator: alerts you on
the operating status of the surge
protector.
Power blocker protection: cuts off
all power to AC outlets in the event
of an electrical or power surge that
overwhelms its protection.
Phone/fax/modem protection:
provides maximum protection
against surges present on standard
two-wire dial-up phone service.
Network/data protection: provides
maximum protection against surges
present on the network or phone
lines.
Coaxial cable protection: provides
maximum protection against surges
present on standard coaxial and
broadband lines.
1 Important safety
instructions
This manual contains important information
about the Philips power surge protectors. Read
it carefully before you start the installation and
setup.
Warning
Do not operate your surge protector near the •
rain or wet areas.
Do not operate your surge protector if liquid •
of any kind is spilled onto or inside the unit.
Do not disassemble or repair. •
Do not expose your surge protector to •
direct sunlight or place it near wall heaters,
space heaters, or enclosed space prone to
temperature increase.
The Philips surge protector requires a properly •
grounded outlet for safety and to protect the
connected equipment. If you are not sure
whether your home’s electrical wiring has
proper grounding, consult a qualied electrician.
Recycling the product
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused. When you
see the crossed-out wheel bin symbol attached
to a product, it means the product is covered
by the European Directive 2002/96/EC:
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products. The correct
disposal of your old product helps prevent
potentially negative consequences on the
environment and human health.
EN
3
IN/OUT phone protection
1 Connect your phone/fax/modem line
from your wall outlet to the input jack on
the surge protector.
2 Connect one end of a phone cord into
the output jack on the surge protector,
and the other end to the phone/fax/
modem jack of the device.
Splitter phone line protection
If you have one telephone number for both
your modem and telephone, you can split the
incoming phone line into two outs:
1 Connect your phone/fax/modem line
from your wall outlet to the input jack on
the surge protector.
2 Connect one end of a phone cord into
the output jack on the surge protector,
and the other end to the phone/fax/
modem jack of the device.
Note
You cannot use the modem or phone at the •
same time.
Device phone line protection
This is an advanced two-line phone/modem/
fax protection which two devices can be used
simultaneously.
3 Get started
This surge protector is designed to guard the
connected equipment against electrical damage.
Philips offers an entire line of surge protectors
to safeguard your home electronics and
computer systems.
Connect the surge protector
1 Plug the power cord into a properly
grounded outlet.
2 Plug the component power cord into the
surge protector.
Caution
Do not use any extension cords, adapters, •
other grounding wire or electrical connections
with your surge protector. Doing so will void
all Philips warranties.
Connect the surge protector
to a phone/fax/modem
Some Philips surge protector models come
with phone/fax/modem surge protection,
Instead of running a connection directly from
your phone/fax/modem to the wall jack, pass
the connection through the protected jacks on
your surge protector.
English
EN
4
1 Connect your incoming cable/broadband
line to the input coaxial connector on the
surge protector.
2 Connect one end of a coaxial cable to the
output coaxial connector on the surge
protector, and the other end of to the
input coaxial connector of the device.
Conditions for damage claims
To claim damage under the connected •
equipment warranty as a result of coaxial
line transients, ensure the equipment is
properly connected to a Philips surge
protector which offers coaxial line
protection.
If you fail to connect the coaxial cable •
protection, your connected equipment
will not be covered by the connected
equipment warranty. Most TV/VCR/
DVD/satellite/cable box damage can be
prevented if you connect coaxial cable
protection carefully and properly.
Caution
The coaxial feature of this product could be •
rendered inoperable if improperly installed.
Conditions for damage claims
To claim damage under the connected •
equipment warranty as a result of
telephone service line transients, ensure
the equipment is properly connected
to a Philips surge protector which
offers telephone line protection. Also,
ensure the telephone service equipment
has included a properly installed and
operating primary protection device at
the service entrance (such devices are
normally added during telephone line
installation).
If you fail to connect the phone/fax/•
modem protection, your connected
equipment will not be covered by the
connected equipment warranty.
Most modem damage can be prevented •
if you connect the phone/fax/modem
protection carefully and properly.
Surge protector models with telephone •
protection are designed to provide
maximum protection from surges present
on standard two wire dial-up telephone
service. Other communication networks
which use modular jacks are not
necessarily benet from this protection.
Caution
The telephone feature of this product could be •
rendered inoperable if improperly installed.
Connect the surge protector
to a TV/VCR/DVD/satellite/
cable box
Some Philips surge protector models come
with coaxial cable surge protection. Instead
of running a connection directly from your
TV/VCR/DVD/satellite/cable box to the wall
jack, pass the connection through the protected
coaxial connections on your surge protector.
EN
5
One year product limited
warranty
This warranty does not cover damages (a) as a
result of an accident; (b) resulting from the use
of parts not manufactured or sold by Philips;
(c) or resulting from modication of the surge
protector. After any repair or modication of
the surge protector by a facility not authorized
by Philips, any problems that arise will not be
remedied under this warranty.
These warranties extend only to the original
purchaser of the product, and are not
transferable. To exercise your rights under this
warranty, you must provide proof of purchase in
the form of an original sales receipt that shows
the product name and the date of purchase.
Connected equipment
warranty
Philips warrants to the original consumer that
it will, at its sole option, repair or replace any
equipment properly connected through a
Philips surge protector to a properly wired
AC power line with protective ground and
telephone/coax lines, which is damaged by
impulses from lightning, or other power
transients, or by momentary (less than 1ms)
voltage surges or spikes (an “Occurrence”) if
(a) the surge protector did not protect the
equipment (b) the surge protector shows clear
signs of damage; and (c) the damage resulted
from the Occurrence.
This warranty does not cover (a) damages
caused by acts of God, including ood, erosion, or
earthquake, but excluding lightning on products
with Power Blocker™ technology; (b) damages
caused by a sustained low voltage situation, or
a low voltage disturbance, including brownouts,
sags, or power outages; (c) damages caused by
war, vandalism, theft, normal use wear-and-tear,
depletion, obsolescence, abnormal care or uses,
or abuse; (d) damage due to non-authorized
program or system equipment modication or
4 Limited
warranty
Philips, Inc. (“Philips”) provides one or both
of the following warranties (Surge Protector
Limited Warranty and Connected Equipment
Limited Warranty) to the original consumer of
surge protectors sold under the Philips brand
names.
Provisions applicable to each warranty: These
warranties apply only to natural purchasers
of surge protectors for personal, family or
household use, not to commercial, institutional
or industrial purchasers. These warranties are
valid only in Europe.
THESE WARRANTIES ARE IN LIEU OF
ALL OTHER EXPRESS WARRANTIES; AND
ANY IMPLIED WARRANTIES, INCLUDING
BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A ARTICULAR PURPOSE,
ARE LIMITED TO THE DURATION OF THIS
WARRANTY.
EXCEPT AS PROVIDED IN THE
CONNECTED EQUIPMENT LIMITED
WARRANTY (IF APPLICABLE), IN NO
EVENT SHALL PHILIPS BE LIABLE FOR
ANY DIRECT, INDIRECT, INCIDENTAL,
SPECIAL, CONSEQUENTIAL OR MULTIPLE
DAMAGES* ARISING OUT OF THE USE OF
THE PHILIPS SURGE PROTECTOR.
Philips warrants that this product shall be free
from defects in material, workmanship and
assembly, under normal use, in accordance with
the specications and warnings for the lesser
of (i) one year from the date of your purchase
of this product, or (ii) the date upon which this
product has exceeded its capacity to protect
against surges and spikes. The “Protection
Working” indicator light will no longer be lit
when this capacity is exceeded.
English
EN
6
a properly installed and operating “primary
protection” device at the service entrance.
(Such devices are normally added during
telephone line installation.) If you fail to connect
the telephone line protection properly, your
connected equipment will not be covered by
the Connected Equipment Warranty.
To claim damage as a result of coaxial line
transients, equipment must be properly
connected to a Philips surge protector which
offers coaxial line protection (see the user
manual for installation instructions). If you fail to
connect the coaxial cable protection properly,
your connected equipment will not be covered
by the Connected Equipment Warranty. The
customer service department will provide
the consumer with a Return Authorization
number (RA#). Philips will determine, at its sole
discretion, whether consumer should send the
damaged equipment and the surge protector
to Philips, or to an independent repair facility.
If Philips so requests, the consumer must,
at his/her own expense, send the damaged
equipment and the surge protector, along with
a copy of the sales receipt, to the specied
location, in secure packaging (to prevent further
damage) with the RA# clearly displayed on the
outside of the package, and with a full written
description of the problem, including the
consumer’s name, address, and daytime phone
enclosed. Philips also reserves the right to
examine the site where the damage occurred.
If Philips determines that the Connected
Equipment Limited Warranty covers the
damaged equipment, and that the equipment
was damaged as a result of the surge protector
which is covered under the Surge Protector
Limited Warranty, Philips will either (a)
authorize repair of the connected equipment, at
a cost up to the maximum amount set forth on
the packaging of the surge protector involved;
(b) provide the consumer with an equivalent
equipment replacement; or (c) reimburse the
consumer for the present fair market value
of the damaged connected equipment. If,
applicable, the equipment will be returned from
Philips to the consumer at Philips expense.
alteration; or (e) damage to equipment that was
not directly connected to the surge protector at
the time of the Occurrence.
This warranty extends through the lifetime of
the surge protector, which means until the surge
protector has exceeded its capacity to protect
against surges and spikes. The “Protection
Working” indicator light will no longer be lit
when this capacity is exceeded. The capacity of
the surge protector will be exceeded after an
occurrence.
This warranty is limited to losses that are not
covered by a warranty from the manufacturer
of the connected equipment, or by the
consumer’s homeowners insurance or renter’s
insurance policy. Consumer agrees to rst
seek coverage under any such warranty or
policy, and not seek duplicate coverage from
Philips. Consumer agrees to provide insurance
information to Philips, at its request; and
after a claims settlement, if applicable, Philips
reserves the right to be subrogated under any
existing warranty from the manufacturer of the
connected equipment or under any existing
insurance policies the claimant may have.
This warranty is limited to surge protectors
which indicate on the packaging an accompanying
connected equipment warranty. After any repair
or modication of the surge protector by a facility
not authorized by Philips, any problems that arise
will not be remedied under this warranty.
Your Philips surge protector must be plugged
into a properly grounded outlet. All connected
equipment must be plugged directly into your
surge protector. Using any extension cord,
adapters, other grounding wires or electrical
connections in conjunction with a Philips surge
protector will void all Philips warranties. All
wires leading into the equipment, including
telephone and coaxial lines, must pass through
an appropriate Philips surge protector.
To claim damage as a result of telephone
service line transients, equipment must be
properly connected to a Philips surge protector
which offers telephone line protection (see the
user manual for installation instructions), and
your telephone service equipment must include
EN
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
Printed in China
SPN_UM_10_EN_V1.2
wk10192