RAM Mounts RAM-316-3AU User Manual
Displayed below is the user manual for RAM-316-3AU by RAM Mounts which is a product in the Holders category. This manual has pages.
Related Manuals
Parts Index
* not to scale
rammount.com
1.800.497.7479
support@rammount.com RAM® Pod™ III Universal No-Drill™ Base
RMR-INS-316
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Pr
oducts, Inc.T
o see more mounting options, visit rammount.com
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
2Locate 3 attachment points and use existing seat bolt and washer to
secure the foot base assembly. Align the top of each flex rod with the
grooves of (E) housing wedge as shown. Install (F) top housing along with
a RAM® ball base or post (not included) using (I and J) screws and nuts.
Tighten using (C) allen key. Screws may need to be re-tightened after
mount is used or until wedge is fully engaged.
D
G
H
A
B
1Pre-bend (A) flex rods to brace against another object while mounted,
such as the center console of your vehicle. Assemble the seat base as
shown. Make sure you have each (A) flex rod pre-bent to the desired
angle before sliding on (B) tube coverings.
Before installation, locate the best possible attachment points for (D) foot bases, such as a seat bolt or any other existing screw, nut or bolt.
If desired, you may drill your own attachment point using a bolt, washer and nut, or with a sheet metal screw.
x 3
B
x 3
A
x 3
D
x 1
C
x 3
#10-24 x 1 1/2”
x 3
#10-24
x 1 x 3
1/4”-20 x 1”
x 3
1/4”-20
I
J
x 3
K
F
x 1
EG
H
F
E
J
I
K