RAM Mounts RAM-HOL-SAM60PD-AUDU User Manual
Displayed below is the user manual for RAM-HOL-SAM60PD-AUDU by RAM Mounts which is a product in the Holders category. This manual has pages.
Related Manuals
RMR-INS-SAM60PD-AUD
RAM® EZ-Roll’r™ Power + Data Cradle Kit
rammount.com
1.800.497.7479
support@rammount.com
1
2
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
To see more mounting options, visit rammount.com This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
1
Part Index
*not to scale
A
D
A
B
B
C
E
D
E
F
F
x 1
x 1
x 1
x 6
x 1
x 6
Sandwich the speaker bracket (B) between the
ball mount (D) and the cradle (A). Connect them
with provided bolts (E) and nuts (F).
Remove thumbscrews from the speaker
(C) to access mounting points on the
speaker bracket. Attach speaker bracket
with remaining bolts (E) and nuts (F) and
then reassemble.
RMR-INS-SAM60PD-AUD
RAM® EZ-Roll’r™ Power + Data Cradle Kit
rammount.com
1.800.497.7479
support@rammount.com
4
2
Part Index
*not to scale
Completed setup
Wiring Diagram
Connect 3.5 audio jack from the speaker to the included RAP-CAB-USBA-
AUD35U cable (I) and connect that to the USB-A port on the cradle (A).
Hardwire the loose red (+) and black (-) wires from the speaker to the trucks
12V ignition. For powering the device, connect the included USB cable (G) to
the Micro USB end of the cradle (A) and connect that to the included hardwire
power supply (H) that will ultimately be hardwired to the tucks 12V ignition.
G
H
H
I
I
G
x 1
x 1
x 1
Connection
to peripherals
Connection to
USB Power source
Inline 3A Fuse
Added by installer
*
Hardwire To Truck
12V Ignition
Wire to constant
12V power
Micro USB
3.5mm Audio jack
USB-A
USB-A