RAM Mounts RAM-HOL-UN15WU User Manual
Displayed below is the user manual for RAM-HOL-UN15WU by RAM Mounts which is a product in the Holders category. This manual has pages.
Related Manuals
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
To see more mounting options, visit RamMount.com This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM® Quick-Grip™
Holder for Apple MagSafe
rammount.com
1.800.497.7479
support@rammount.com
RMR-INS-461
Part Index
*not to scale Not Included
Apple MagSafe
Connect (B) Puck Slide to (A) RAM® Quick-Grip™ Holder, using (E) Screws
and (D) Ratchet Washers. Do not fully tighten yet.
Shift Apple MagSafe cable up and down until magnets are properly
aligned with phone. Once aligned, fully tighten (E) Screws on the back.
Hand-tighten only, do not over-tighten.
Insert Apple MagSafe into (B) Puck Slide, followed by phone.
1
3
2
A
A
B
B
C D
D
E
E
F G H I J K
x1 x1 x1 x2 x2
(#8-32)
x2
(#6 X ½")
x2
(#8-32 X ½")
x2
(#8-32 X 5/8")
x2
(#8-32 x 3/4")
x2 x1
1
Remove phone from holder. Plug Apple MagSafe into power source and
connect phone to holder again to ensure proper connection.
4
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
To see more mounting options, visit RamMount.com This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
rammount.com
1.800.497.7479
support@rammount.com
RMR-INS-461
2
To connect RAM® Diamond Ball Base (not included), remove device from
holder, insert (F) Nuts into nut pockets and connect base with (G, H or I)
Screws, and enclose with (C) Panel.
5
C
F
G, H or I
Not Included
RAM® Quick-Grip™
Holder for Apple MagSafe