RAM Mounts RAM-VB-203 User Manual
Displayed below is the user manual for RAM-VB-203 by RAM Mounts which is a product in the Vehicle Interior Spare Parts & Accessories category. This manual has pages.
Related Manuals
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
Placement
rammount.com
1.800.497.7479
support@rammount.com
RAM® No-Drill™ Seat Base
RAM-VB-203
RMR-INS-VB-203
Passenger side on the floor, in front seat.
Important Note
Utilizes existing vehicle hardware. Plastic trim may
be re-installed once the RAM® No-Drill™ base has
been secured into vehicle.
Seat Configuration
Bucket
Construction/Finish
Steel/Black powder coat
Drilling Required
None - uses existing seat bolts.
Specifications
Dimensions
(A) 19.5” (B) 9” (C) 1.5”
(Hole Center) 17.5”
Pole or Pedestal
Purchased separately
A
B
C
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.To see more mounting options, visit rammount.com
rammount.com
1.800.497.7479
support@rammount.com
RAM® No-Drill™ Seat Base
RAM-VB-203
RMR-INS-VB-203
Installation Instructions
Move the passenger seat to its rearmost position. Loosen and remove
the front seat rail bolts using a T-50 torx bit.
If installing this base with a RAM® Tele-Pole™ assembly, attach the lower
female pole prior to installing the RAM® No-Drill™ base. The carriage
bolts should come up through the bottom with the rubber caps on the
top side covering the nuts once attachment is complete.
Note that once installed, this base will slightly lessen the amount of
forward travel available to the passenger side seat. Accessing the glove
box is still possible once system is installed.
1
Gently lift the front of the seat to allow clearance for the base
between the legs and the vehicle floor board. Slide the RAM®
No-Drill™ base under the seat frame rails. Push the base all the way
under, lining up the holes of the base with the seat frame holes.
2
Reinstall the front seat rail bolts. Fully tighten.
3
The use of the stabilizer foot is recommended to reduce bounce in all
applications. Simply replace one of the carriage bolts holding the pole
system or riser in place with the stabilizer foot as shown. You will need a
½” box wrench to tighten the hardware. The part number for the
stabilizer foot kit is RAM-FOOT2. Slide the bolt through the foot, slide a
lock washer over the thread so it rest on the foot. Place a nut over the
thread and tighten to secure the foot over the head of the bolt. Next,
thread a nut over the bolt and slide another lock washer over the bolt.
Pass the foot up through the base from the bottom. Once through the
base, slide the flat washer, lock washer, then thread the nut over the
bolt. Position foot while hardware is loose so it is supporting the base off
the floor. Once in position, tighten the nut so that it forces the foot down
against the floor. Secure with remaining nut and washers on top.
Optional Foot Stabilizer