RAM Mounts RAP-274-1-GA12 User Manual

Displayed below is the user manual for RAP-274-1-GA12 by RAM Mounts which is a product in the Navigator Mounts category. This manual has pages.

Related Manuals

RAP-274-1U Instructions

EZ On EZ Off Mount

PART INDEX

(QTY. 1) QUICK RELEASE SPRING LOADED TOP (A)

(QTY. 1) QUICK RELEASE BOTTOM (B)

(QTY. 1) EZ MOUNT RUBBER BASE (C)

(QTY. 1) EZ MOUNT TAPERED RUBBER BASE (D)

(QTY. 2) 7” LONG CABLE TIE (E)

(QTY. 1) 2” x 3” NEOPRENE ADHESIVE STRIP (F)

STEP 1,

Combine quick release bottom (B) with either EZ rubber

base (C) or (D). Use EZ rubber base (C) for standard

handlebars, and EZ rubber base (D) for tapered

handlebars. Wrap Neoprene strip around bar at location

Where EZ mount will be installed. The strip can be

trimmed as desired but must contact EZ mount at rubber

base and at the cable ties to prevent slipping.

STEP 2.

Insert zip ties (E) into quick release bottom (B) with

perforated side facing down towards handlebars. Do not

fully tighten zip ties until you have reached a desired

position on handlebars. Once desired position is

reached, completely tighten and remove excess cable

tie with scissors.

STEP 3.

Attached quick release spring loaded top (A) to cradle.

STEP 4

Attach assembly from step 3 by pressing it against the

assembly mounted on handlebar, turning, and then

letting go.

National Products, Inc., 8410 Dallas Ave S. St., Seattle, WA 98108, (206) 763-8361 www.ram-mount.com