Salora CR606USB User Manual
Displayed below is the user manual for CR606USB by Salora which is a product in the Alarm Clocks category. This manual has pages.
Related Manuals
-
-
-
$364#
"-"3.$-0$,3"%*08*5)
8&,,&33"%*0.&564#01-"%&3
($*,&34)"/%-&*%*/(
3"%*03&7&*-"7&$$)"3(&6364#
."/6&-%*/4536$5*0/4
64#$)"3(*/(
64&3."/6"-
12
34
5
6
7
9
10
11
12
8
LOCATION OF CONTROL
POWER SUPPLY
1. Alarm 1 indicator
2. Alarm 2 indicator
3. USB charging port
4. DC5V jack
5. MINUTE / TUNING button
6. TIME / MEMORY button
7. POWER ON/OFF / ALARM OFF/
MODE button
8. HOUR / TUNING button
9. VOLUME - / ALARM 2 button
10. VOLUME + / ALARM 1 button
11. SLEEP button
12. SNOOZE button
13. AC adaptor (not shown)
Mains supply : Insert the AC adaptor into a 230V AC ~ 50Hz mains outlet and the other
end of the cord into the DC 5V jack (4) on the back of the unit.
Battery back up : The clock time and alarm (if set) can be maintained during a power
failure by 2 x AAA/ LR03 batteries (not supplied).
Once the power is restored, check the time to make sure it is accurate and re-set if
necessary.
Inserting the Batteries
1. Open the battery compartment at the bottom of the unit by pressing on the catch and
removing the cover.
2. Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery
compartment, following the polarity as shown on the diagram inside the compartment.
3. Replace the battery compartment cover
Setting the clock
1. Press and hold the TIME button (6) and the hour/minute digits will flash.
2. Use the HOUR button (8) to set the hours.
3. Use the MINUTE button (5) to set the minutes.
4. Press the TIME button (6)to confirm.
Setting the alarm
Before setting the alarm time, make sure the Clock has been set.
1. In standby mode, press and hold AL1 (10) / AL2 (9) until “0:00” flashes on the display.
2. While “0:00” is flashing, set the alarm time by repeatedly pressing HOUR / MIN.
Press and hold HOUR (8) / MIN (5) respectively for fast advance.
3. Repeatedly press AL1 (10) / AL2 (9) to select the desired alarm mode (1) (2)
(buzzer or radio).
SETTING THE CLOCK AND ALARM
8
EN
Using the Alarm Function
1. To enable the alarm function, use the ALARM 1/2 buttons (9) (10) to select buzzer or
radio. The selected alarm mode indicator will light up.
2. The buzzer or radio will come on at the set time.
3. To stop the alarm, press the AL OFF button (7). The alarm will sound again the next day.
Note: While the buzzer alarm volume is fixed and cannot be adjusted, the radio alarm
volume can be adjusted to your desired level using the VOLUME buttons (9) (10). To
select a radio station to wake up to, see the section on “USING THE RADIO”.
Snooze function
When the alarm sounds, press the SNOOZE button (12). The alarm mode indicator will
flash and the alarm will sound again after 9 minutes. To cancel the SNOOZE function
and repeat the alarm the next day, press the AL OFF button (7).
Sleep Function
With this function, you can listen to the radio for up to 90 minutes, after which it will
turn off automatically.
1. When the unit is switched on, press the SLEEP button (11) repeatedly to select the
duration: 90, 80, 70, 60, 50, 40, 30, 20, 10 minutes or OFF.
2. At the end of the set time, the radio turns off automatically.
3. To cancel the sleep function before the end of the set time, press the button to
turn off the radio immediately.
1. Press the button (7) to turn on the radio.
2. Press and hold one of the <TUNING> buttons (5) (8) to start automatic tuning up/
down. Release the button when the unit is receiving a station you would like to listen
to. For manual fine-tuning, you can press it briefly to adjust the frequency step by step.
3. Press the button (7) to turn off the radio.
For optimum reception
Extend and position the FM antenna to achieve optimum reception.
Preset radio stations
You can store up to 10 stations.
1. Use the <TUNING> buttons (5) (8) to search for a station. Press and hold
the MEMORY button to store the station and a number to be assigned for
the preset will be flash.
2. Press the <TUNING> buttons to change the number.
3. Press the <MEMORY> button again to confirm the setting.
Listening to a preset station
While listening to the radio, press the MEMORY button to select a preset station.
The current time is always displayed. When you change to Radio mode, the frequency
will be displayed for 5 seconds and then the unit will go back to displaying the time.
To charge, connect your USB device like smartphone to the USB port of this clock. Use
only with devices that require 5V USB power. USB port provides 1000mA recharging
USING THE RADIO
USB CHARGING FUNCTION
9
EN
current. Devices requiring more than 1000mA should not be used. Charging time may
vary for difference devices.
Note:
Charging function may not be supported for all phones or electronic devices.
Charging output would be around 80% in radio mode.
This appliance is intended for domestic household use only and should not be used
for any other purpose or in any other application, such as for non-domestic use or in a
commercial environment.
The ventilation should not be impeded by covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc.
No naked flame sources, such as lighted candles, should be placed on the apparatus.
The apparatus shall not be exposed to dripping or splashing and that no objects filled
with liquids, such as vases, shall be placed on the apparatus.
Ventilation
Allow at least a 10 cm gap all around the product.
This apparatus is not suitable for use in a tropical climate.
Prior to cleaning or other maintenance, the appliance must be disconnected from the
supply mains.
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.
To protect the environment, use local recycling facilities for battery disposal.
Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
The marking plate is located on bottom of the enclosure.
FM: 87.5-108 MHz
Power supply: AC 230V~ 50 Hz
Back-up batteries: 2 X 1.5V “AAA” size batteries or equivalent (not included)
Electrical products should not be disposed of with household waste.
We kindly ask that you use the recycle collection points provided for this purpose.
Consult with your local authorities or dealer for advice on recycling.
We apologise for any inconvenience caused by minor inconsistencies in these
instructions, which may occur as a result of product improvement and development.
WARNINGS
SPECIFICATIONS
10
EN
SALORA | Vareseweg 44 | 3047AV | Rotterdam | The Netherlands