TP-Link MC100CM User Manual
Displayed below is the user manual for MC100CM by TP-Link which is a product in the Network Media Converters category. This manual has pages.
©2019 TP-Link 7106508387 REV6.2.0
Fast Ethernet Media Converter
Enlarge Your Ethernet Network
Package Contents: Converter, Power Adapter, User Guide
LED Explanation
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
On: Power on
O:
Power o
PWR
On: Valid link
Flashing: Transmitting or receiving data
O: Invalid link
FX
Link/Act
On: Valid link
Flashing: Transmitting or receiving data
O: Invalid link
TP
Link/Act
LC-SC Fiber Cable Twisted-Pair Cable
Fiber CableTwisted-Pair Cable Twisted-Pair Cable
10/100M
PWR
TP
Link/Act
FX
Link/Act
TX RX
10/100M
PWR
TP
Link/Act
FX
Link/Act
TX RX
10/100M
PWR
TP
Link/Act
FX
Link/Act
TX RX
Scenario 1: Connect Devices with and without Optical Interfaces
Ethernet Device
with Optical Interfaces
Ethernet Device
without Optical Interfaces
Media Converter
10BASE-T/100BASE-TX Interface
100BASE-X (Fiber) Interface
Note:
1. Please use two Media Converters of the same model to work properly.
2. Please connect the TX port of one converter to the RX port of the other using a ber cable.
Scenario 2: Connect Devices without Optical Interfaces
Ethernet Device
without Optical Interfaces
Media Converter Media Converter Ethernet Device
without Optical Interfaces
10BASE-T/100BASE-TX Interface 10BASE-T/100BASE-TX Interface
For MC100CM/MC110CS
General Specifications Environmental and Physical Specifications
Specications
0˚C to 40˚C (32˚F to 104˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
5% to 90% RH non-condensing
10% to 90% RH non-condensing
Operation Temperature
Storage Temperature
Storage Humidity
Operation Humidity
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of
directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce
この装置は、クラスA情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがあります。こ
の場合には使用者が適切な対策を講ずるよう要求されることがあります。
VCCI-A
Safety Information
Keep the device away from water, re, humidity or hot environments.
Do not attempt to disassemble, repair, or modify the device.
Do not use damaged charger or USB cable to charge the device.
Do not use any other chargers than those recommended.
Adapter shall be installed near the equipment and shall be easily accessible.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Do not point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can
injure your eyesight.
IEEE 802.3, IEEE 802.3i, IEEE802.3u
Standards
1 SC ber optic; 1 RJ45 jackConnector
Twisted-Pair 10BASE-T: 2-pair UTP/STP of Cat. 3 or above (≤100m)
100BASE-Tx: 2-pair UTP/STP of Cat. 5 or above (≤100m)
External Power Adapter: 9V/0.6APower
For MC100CM/MC110CS: 1310nm
For MC111CS: 1550nm TX, 1310nm RX
For MC112CS: 1310nm TX, 1550nm RX
Wave Length
LED PWR, FX Link/Act, TP Link/Act
Fiber
For MC100CM:
62.5/125μm multi-mode (≤2km); 50/125μm multi-mode (≤2km)
For MC110CS/ MC111CS/MC112CS:
9/125μm single-mode ber (≤20km)
Explanation of the symbols on the product label
DC voltage
Indoor use only
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive
2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer
when he buys a new electrical or electronic equipment.
Scenario 1: Connect Devices with and without Optical Interfaces
LC-SC Fiber Cable
Ethernet Device
with Optical Interfaces
Twisted-Pair Cable
Ethernet Device
without Optical Interfaces
Media Converter
10BASE-T/100BASE-TX Interface
100BASE-X (Fiber) Interface
Note: Please use one MC111CS and one MC112CS to work properly.
Scenario 2: Connect Devices without Optical Interfaces
SC-SC Fiber CableTwisted-Pair Cable Twisted-Pair Cable
Ethernet Device
without Optical Interfaces
Media Converter Media Converter Ethernet Device
without optical Interfaces
10BASE-T/100BASE-TX Interface 10BASE-T/100BASE-TX Interface
PWR
TP
Link/Act
FX
Link/Act
10/100M
PWR
TP
Link/Act
FX
Link/Act
10/100M
For MC111CS/MC112CS
PWR
TP
Link/Act
FX
Link/Act
10/100M
This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user
may be required to take adequate measures.
CE Mark Warning
Responsible party:
TP-Link USA Corporation, d/b/a TP-Link North America, Inc.
Address: 145 South State College Blvd. Suite 400, Brea, CA 92821
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6803
E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the
applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the
equipment is properly maintained and operated.
Issue Date: 2019.5.10
CAN ICES-3 (A)/NMB-3(A)
Industry Canada Statement
BSMI Notice
安全諮詢及注意事項
請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。
注意防潮,請勿將水或其他液體潑灑到本產品上。
插槽與開口供通風使用,以確保本產品的操作可靠並防止過熱,請勿堵塞或覆蓋開口。
請勿將本產品置放於靠近熱源的地方。除非有正常的通風,否則不可放在密閉位置中。
請不要私自打開機殼,不要嘗試自行維修本產品,請由授權的專業人士進行此項工作。
此為甲類資訊技術設備,于居住環境中使用時,可能會造成射頻擾動,在此種情況下,使用者會被要求採取某些適當的
對策。
限用物質含有情況標示聲明書
產品元件名稱
PCB
外殼
電源適配器
限用物質及其化學符號
備考1: "○"系指該項限用物質之百分比含量未超出百分比含量基準值。
備考2: " - " 系指該項限用物質為排除項目。
○ ○ ○ ○ ○
鉛
Pb
○
○
-
鎘
Cd
○
○
汞
Hg
○
○
六價鉻
CrVI
○
○
多溴聯苯
PBB
○
○
多
溴二苯醚
PBDE
○
○
Component Name Model
I.T.E. POWER SUPPLY T090060-2B1
Product Name: Fast Ethernet Media Converter
Model Number: MC100CM/MC110CS/MC111CS/MC112CS
Product Name: I.T.E. POWER SUPPLY
Model Number: T090060-2B1
Responsible party:
TP-Link USA Corporation, d/b/a TP-Link North America, Inc.
Address: 145 South State College Blvd. Suite 400, Brea, CA 92821
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6803
E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the
applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the
equipment is properly maintained and operated.
Issue Date: 2019.5.10
FCC compliance information statement
Canadian Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
FCC compliance information statement
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів
та вимогам, що передбачені чинними законодавчими актами України.