Whirlpool W1114 User Manual
Displayed below is the user manual for W1114 by Whirlpool which is a product in the Warming Drawers category. This manual has pages.
Related Manuals
Safety instructions, Use and Care and Installation guide
www.whirlpool.eu/register
x 2 90° C
141,5
500
500
595
80
160 min
550 min
134,5
554 550
551
22
22
441
455
470/540 595
595
455
116
595
22
526
500
500
595
80
160 min
550 min
=
=
INSTRUCTIONS FOR USE
Page
SAFETY INSTRUCTIONS 6
BEFORE USING THE WARMING DRAWER 9
INSTALLATION 9
HOW TO USE THE PRODUCT 10
CONTROL PANEL DESCRIPTION 10
WARMING DRAWER 10
OPERATION 10
TEMPERATURE SELECTION 11
WARMING TIMES 11
LOAD CAPACITY 11
CLEANING AND MAINTENANCE 12
TROUBLESHOOTING GUIDE 12
AFTER-SALES SERVICE 13
6
SAFETY
INSTRUCTIONS
IMPORTANT TO BE READ
AND OBSERVED
Before using the appliance, read
these safety instructions. Keep
them nearby for future reference.
These instructions and the
appliance itself provide
important safety warnings, to
be observed at all times. The
manufacturer declines any
liability for failure to observe
these safety instructions,
for inappropriate use of the
appliance or incorrect setting of
controls.
Very young children (0-3
years) should be kept away
from the appliance. Young
children (3-8 years) should be
kept away from the appliance
unless continuously supervised.
Children from 8 years old
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge can
use this appliance only if they
are supervised or have been
given instructions on safe use
and understand the hazards
involved. Children must not play
with the appliance. Cleaning and
user maintenance must not be
carried out by children without
supervision.
WARNING: The appliance
and its accessible parts become
hot during use. Care should be
taken to avoid touching heating
elements. Children less than 8
years of age must be kept away
unless continuously supervised.
Never leave the appliance
unattended during food drying.
Keep clothes or other
ammable materials away
from the appliance, until all the
components have cooled down
completely - risk of re. Always
be vigilant when cooking foods
rich in fat, oil or when adding
alcoholic beverages - risk of
re. Use oven gloves to remove
pans and accessories. At the
end of cooking, open the door
with caution, allowing hot air
or steam to escape gradually
before accessing the cavity -
risk of burns. Do not obstruct
hot air vents at the front of the
appliance - risk of re.
Exercise caution when the
appliance is in the open position,
to avoid hitting the door.
PERMITTED USE
CAUTION: The appliance is
not intended to be operated by
means of an external switching
device, such as a timer, or
separate remote controlled
system.
7
This appliance is intended
to be used in household and
similar applications such as:
sta kitchen areas in shops,
oces and other working
environments; farm houses; by
clients in hotels, motels, bed &
breakfast and other residential
environments.
No other use is permitted
(e.g. heating rooms).
This appliance is not for
professional use. Do not use the
appliance outdoors.
Do not store explosive or
ammable substances (e.g.
gasoline or aerosol cans) inside
or near the appliance - risk of re.
INSTALLATION
The appliance must be
handled and installed by two or
more persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including water
supply (if any) and electrical
connections, and repairs must
be carried out by a qualied
technician. Do not repair or
replace any part of the appliance
unless specically stated in the
user manual. Keep children away
from the installation site. After
unpacking the appliance, make
sure that it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest After-sales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.)
must be stored out of reach of
children - risk of suocation. The
appliance must be disconnected
from the power supply before
any installation operation -
risk of electrical shock. During
installation, make sure the
appliance does not damage
the power cable - risk of re or
electrical shock. Only activate the
appliance when the installation
has been completed.
Carry out all cabinet cutting
works before tting the
appliance in the furniture and
remove all wood chips and
sawdust.
Do not remove the appliance
from its polystyrene foam base
until the time of installation.
After installation, the bottom
of the appliance must no longer
be accessible - risk of burn.
Do not install the appliance
behind a decorative door - risk
of re.
ELECTRICAL WARNINGS
The rating plate is on the front
edge of the appliance (visible
when the warming drawer is
open).
It must be possible to
disconnect the appliance from
the power supply by unplugging
it if plug is accessible, or by
a multi-pole switch installed
upstream of the socket in
accordance with the wiring
rules and the appliance must
be earthed in conformity
8
with national electrical safety
standards.
Do not use extension leads,
multiple sockets or adapters.
The electrical components must
not be accessible to the user
after installation. Do not use the
appliance when you are wet or
barefoot. Do not operate this
appliance if it has a damaged
power cable or plug, if it is not
working properly, or if it has
been damaged or dropped.
If the supply cord is
damaged, it must be replaced
with an identical one by the
manufacturer, its service agent
or similarly qualied persons in
order to avoid a hazard - risk of
electrical shock.
In case of replacement
of power cable, contact an
authorized service center.
CLEANING AND MAINTENANCE
WARNING: Ensure that the
appliance is switched o and
disconnected from the power
supply before performing any
maintenance operation; never
use steam cleaning equipment -
risk of electric shock.
Do not use harsh abrasive
cleaners or metal scrapers to
clean the door glass since they
can scratch the surface, which
may result in shattering of the
glass.
Ensure the appliance is cooled
down before any cleaning or
maintenance. - risk of burn.
DISPOSAL OF PACKAGING
MATERIALS
The packaging material is 100% recyclable
and is marked with the recycle symbol .
The various parts of the packaging must
therefore be disposed of responsibly and in
full compliance with local authority regulations
governing waste disposal.
DISPOSAL OF HOUSEHOLD
APPLIANCES
This appliance is manufactured with recyclable
or reusable materials. Dispose of it in accordance
with local waste disposal regulations. For further
information on the treatment, recovery and
recycling of household electrical appliances,
contact your local authority, the collection
service for household waste or the store where
you purchased the appliance. This appliance is
marked in compliance with European Directive
2012/19/EU, Waste Electrical and Electronic
Equipment (WEEE). By ensuring this product
is disposed of correctly, you will help prevent
negative consequences for the environment
and human health.
The symbol on the product or on the
accompanying documentation indicates that
it should not be treated as domestic waste but
must be taken to an appropriate collection
center for the recycling of electrical and
electronic equipment.
9
BEFORE USING THE WARMING DRAWER
To open and close the drawer, push the middle
of the panel as shown in the gure.
At rst use, clean the appliance as follows:
- clean the surface with a damp cloth and then
dry.
- Preheat the empty drawer for at least two
hours: turn the temperature knob to maximum
in order to eliminate any residuals of fat, oil or manufacturing resins that can create
unpleasant odors during the warming of dishes. Air the room.
- After completing these operations, the appliance is ready for rst use.
• Before use, remove:
- stickers placed on the front and door of the warming drawer, except the rating plate;
- keep children away from the product and the packing materials, to avoid interaction
with them, if not properly supervised;
- any stickers from accessories when present.
INSTALLATION
Safety instructions for tting the warming drawer
IMPORTANT: The drawer must be immediately xed to the cabinet, following the
instructions given below. The coupled appliance cannot be installed before xing
the drawer to the cabinet.
Fix the drawer as shown in the gure.
Before electrically connecting the
appliance, make sure the rating plate
data matches the mains power supply,
otherwise the appliance could become
damaged.
Make sure the connection to the power supply is easily accessible after the appliance
has been tted.
The warming drawer can only be tted in combination with other appliances with
maximum weight of 60 kg and provided with adequate cooling ventilation.
To install the appliance that can be combined with the dish warmer, follow the
instructions given in the relevant use and installation handbook.
Important: The same brand coee maker or combi microwave oven, sized as shown
on the following page, can be installed above the warming drawer. For installation,
carefully follow the directions given in the instruction handbooks supplied with the
coee maker and the combi microwave oven.
10
HOW TO USE THE PRODUCT
CONTROL PANEL DESCRIPTION
1. Temperature knob
2. Luminous ON-OFF switch
3. ON-OFF Indicator
WARMING DRAWER
The control elements are the temperature knob and the luminous ON-OFF switch.
With the switch pressed (position 1), the drawer is on, whereas with the switch released
(position 0), the drawer is o.
These elements are only visible when the drawer is open.
When the drawer is closed, a control light located on the front of the appliance
indicates if the drawer is on.
OPERATION
- Place the dishes in the drawer
- Set a temperature
- Turn the appliance on; the switch lights up
- Close the drawer, guiding it carefully
- Turn the appliance o before removing the warmed dishes.
11
TEMPERATURE SELECTION
The temperature control knob allows adjustments up to approx. 75°C (max). Turn
the temperature knob clockwise until the stop which indicates maximum, and then
anticlockwise.
Do not force it beyond the stop, otherwise the thermostat will become damaged.
Temperature adjustment Instructions for use
40°C cups, glasses
Cups and glasses warmed at this
temperature help delay the cooling time
of the beverage subsequently added. Use
gloves to remove containers from the
drawer.
60°C plates
Plates warmed at this temperature
help delay the cooling time of food
subsequently placed on them. Use gloves
to remove containers from the drawer.
MAX
approx. 75°C crockery
The thermostat is set to the maximum
temperature. Use gloves to remove
containers from the drawer.
WARMING TIMES
The time required to warm dishes, glasses, etc. depends on various factors:
• Material and thickness of the dishes
• Load
• Arrangement of load
• Temperature setting
Therefore absolute indications cannot be given.
It is advisable to establish the optimum settings required, based on practical
experience
LOAD CAPACITY
The load capacity depends on the height of the appliance and the size of the dishes.
Remember that the drawer can take a maximum weight of 25 kg.
12
CLEANING AND MAINTENANCE
Make sure that the appliance has
cooled down before carrying out any
maintenance or cleaning.
Do not use steam cleaners.
The appliance must be disconnected
from the mains before carrying out any
kind of maintenance work.
Wear protective gloves.
Do not use wire wool, abrasive scourers
or abrasive/corrosive cleaning agents,
as these could damage the surfaces of
the appliance.
For drawers with iXelium treatment,
proceed as follows:
• Use a soft cloth (preferably microber)
with water or a normal glass cleaning
detergent.
• Do not use paper towels, which could
leave traces of paper and streaks on the
surface.
• Do not use abrasive or corrosive
products, chlorine-based products or
scouring pads.
• Do not use ammable steam cleaning
devices.
• Do not leave acid or alkaline
substances, such as vinegar, mustard,
salt, sugar or lemon juice, on the
surface.
For glass surfaces, proceed as follows:
• Use a neutral detergent and lukewarm
water, then dry with a soft cloth.
• Do not leave acid or alkaline
substances, such as vinegar, mustard,
salt, sugar or lemon juice, on the
surface.
Tempered glass drawer base
It is advisable to clean the bottom of the
drawer after each use, making sure to let
it cool. This will prevent the build-up of
dirt and make cleaning easier.
• Use a clean cloth, paper towels and
washing up liquid, or specic products
for cleaning the tempered glass.
• Do not use abrasive products, bleach,
oven cleaner spray or metallic scouring
pads.
TROUBLESHOOTING GUIDE
If the dishes are not warm enough,
check that:
• the appliance is switched on
• the right temperature has been set
• ventilation openings are not covered by
plates or large bowls
• the dishes were not heated long
enough.
• the mains switch has not been turned
o.
Dierent factors aect the warming time,
for example:
- material and thickness of the dishes, the
load and its arrangement, temperature
setting.
- The optimum times for warming dishes
vary, therefore it is advisable to do tests
to establish them according to needs.
13
AFTER-SALES SERVICE
Before contacting the After-Sales
Service:
1. See if you can solve the problem
yourself with the help of the
“Troubleshooting guide”.
2. Switch the appliance o and then on
again to see if the problem has been
eliminated.
For the following problems, contact a
qualied technician or the After-Sales
Service:
If the dishes do not get warm:
• the electrical power cable could be
disconnected or damaged.
If the dishes get too hot:
• the temperature controller could be
faulty.
The On/O switch does not activate
when the appliance is turned on:
• the switch control indicator is faulty.
If the problem persists after the above
checks, contact the nearest After-Sales
Service.
Always specify:
• a brief description of the fault;
• the warming drawer type and exact
model;
• the Service number (the number after
the word Service on the data plate),
located on the outer right edge of the
drawer runner. The Service number is
also given in the warranty booklet;
• your full address;
• your telephone number.
If any repairs are required, contact an
authorized After-Sales Service Center (to
ensure the use of original spare parts and
correct repairs). Failure to comply with
these instructions can compromise the
safety and quality of the product.
400011228423 GB