XYZprinting RF10XXEUZWK User Manual
Displayed below is the user manual for RF10XXEUZWK by XYZprinting which is a product in the 3D Printing Materials category. This manual has pages.
Related Manuals
Filament Replacement Instructions
Take out the stopper by
rotating anti-clockwise.
Remove the stopper Lift the cartridge Change the filament
and chip Close the cartridge
Screw in the stopper
tightly
Take out the accessories
from the filament cartridge
and replace them with new
accessories.
A. Filament parameter chip
B. Filament
C. Desiccant pouch
Press the joint of the casing
of the filament cartridge
gently and open it. Put a new filament parameter
chip in place. Make sure it is
placed in the correct direction.
Reassemble the cartridge
and pull the filament to
make sure it is discharged
smoothly.
Replace the stopper and
screw it up clockwise.
Turn the cartridge over
and make sure the
stopper has been
tightened to its position.
Put a new desiccant pouch
in place.
Direct the filament through
the guide hole to put out
the filament easily.
1
1-1
1-2
2-1 3-1 4-1
4-2
5-1
5-2
3-3
2-2
2
A
BC
345
Note
1. Do not use the filament cartridge in an environment with heavy dust or high humidity.
2. Unsealed filament kit must be used as soon as possible to ensure good printing quality.
3. If product is defective out of the box, please contact customer service and return the filament and parameter
chip with the original packing for exchange.
3-2