Dimplex FTE16 User Manual
Displayed below is the user manual for FTE16 by Dimplex which is a product in the Dehumidifiers category. This manual has pages.
Related Manuals
Installation and
Operating Instructions
Model: FTE10 10L Dehumidifier
Model: FTE16 16L Dehumidifier
Model: FTE20 20L Dehumidifier
08/52826/0 Issue 0
_________________________________________________________________________________________________________________________________________________
Products comply with the European Safety Standard EN60335-2-40 and the relevant parts of the European Standards for Electromagnetic Compatibility (EMC) EN55014, and
EN61000 along with EN62233 covering Electromagnetic Field (EMF) requirements. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC.
_________________________________________________________________________________________________________________________________________________
SAFETY INFORMATION
1. Please read the operating instructions carefully before using your
dehumidifier for the first time and keep them in a safe place.
2. Never immerse the appliance in water or other liquids.
3. Never operate the appliance if a cable or connector has been damaged,
after appliance malfunction or if the appliance was dropped or is
otherwise damaged.
4. Please ask a professional service agent to repair the product. Improper
repair may cause danger to users.
5. Never allow children to operate the appliance.
6. Disconnect the appliance from mains power whenever it is not in use,
before relocating it, and before cleaning.
7. Operate the appliance only at the voltage specified on the rating label.
8. This appliance is designed for household purposes (not commercial)
only.
9. DO NOT COVER. Never cover or obstruct in any way the outlet at the
top of the dehumidifier or the air inlet slots at the rear of the
dehumidifier.
10. To prevent spillage, empty the water tank before relocating the
appliance.
11. Do not tip the appliance to any side as escaping water could damage
the appliance. Only operate the product in a level upright position.
12. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.
13. When the supply cord is damaged, it must be replaced by the
manufacturer, or a professional service agent only.
14. Only operate this appliance with a minimum of 50cm clearance all
around i.e. away from walls, furniture and overhanging objects such as
curtains or a shelf.
15. When the unit stops, you have to wait for 3 minutes before you can
restart the unit to protect the compressor from damage
OPERATING INSTRUCTIONS
1.
Control panel
2.
Air outlet
3.
Carry handle
4.
Front panel
5.
Air inlet
6.
Water outlet tube
(continuous use)
7.
Water tank
CONTROL PLATE DESCRIPTION
OPERATION INSTRUCTION
Starting the unit
Allow the unit to stand upright for 24hrs to let the compressor stabilize
before first use or when transported.
1. Firstly, turn the humidity control switch to the “OFF” position.
2. Plug in the dehumidifier.
3. Turn on the humidity control switch (clockwise) and set it at the desired
humidity level, please refer to table in point 4 below (e.g. position”4 = 60%).
4. For assistance in drying clothes in a laundry/ utility room, please select
maximum dial position for continuous operation and maximum moisture
removal.
Turning off the unit
1. Turn the humidity control switch fully anticlockwise to the “OFF” position
and the power supply is cut off and the unit stops operating.
2. If the dehumidifier is not in use for a long time, please disconnect the power
cord plug from the supply outlet.
NOTES AND PRECAUTIONS
1. The dehumidifier will not operate if the humidity dial is set lower than the
ambient humidity e.g. room humidity 40% and dial setting 2 or 4. In other
words the higher the humidistat dial setting e.g. position 8 the dehumidifier
will attempt to dry the ambient humidity to 20% (RH) relative humidity.
2. When the water tank is full an automatic float switch shuts down the
product and the tank full LED illuminates. Remove the water storage tank
and empty its contents, carefully replace the empty water tank back in
position, the unit will now automatically restart operating.
3. The following table indicates the approximate relative humidity settings
against its related position number on the humidity control switch:
CONTROL SWITCH
POSITION NO.
APPROXIMATE
HUMIDITY SETTING
Cont.
Continuous
running
8 20
﹪
7 30
﹪
6 40
﹪
4 60
﹪
2 80
﹪
4. The ideal position is around position 6- approximately 40% relative
humidity
5. The operational temperature range for this unit is 5-35°C. Please note the
effectiveness of the product reduces as the ambient temperature reduces.
For example in a room of 6
o
C- little if any moisture will be removed. The
product works on the principal that it requires a high ambient temperature
with warm air drawing over a very cold compressor creating water
droplets.
6. Other than on the case of note 2 above, where the dehumidifier does not
start, the operational light does not illuminate or the dehumidifier
intermittently stops for unknown reasons, please check the plug and
power supply for poor connection. If the plug and power supply are in
good condition, wait for 10 minutes and restart the unit (it can take about
10 minutes for the unit to reset). If the unit still does not start after 10
minutes, please contact your retailer or the manufacturer for repair.
7. When the dehumidifier is in operation, the running compressor will
produce heat. This is normal and may potentially raise the room
temperature.
8. When the product is defrosting, the defrost LED will illuminate. The
reason this happens is because the compressor gets very cold to
maximize moisture removal. The defrost function protects the compressor
from freezing up and avoid damage to the product.
DRAINAGE INSTRUCTION
Switch off before carrying out any of these
operations and leave for 3 minutes before switching
on again. The extracted water is collected by the
water tank (set up as supplied), or can be set up to
drain continuously using a PVC hose (not included)
connected to a drain outlet, the drain point must
be lower than the unit outlet (see details below).
USE OF WATER TANK:
When the tank full LED illuminates the tank is full, the compressor and the
fan will stop operation, please empty the water tank. Remove the water tank
as per Fig 01 and empty it. Gently refit the water tank into the unit in its
original position. Note, if the tank full LED remains on when the tank is
emptied please remove and re-fit the tank to reset the light.
CONTINUOUS DRAINAGE
If you want to use this function, please pull out the water tank and plug a 9mm
internal diameter water pipe onto the “Water out
tube” (See Fig.02). Replace the water tank into the
unit, the unit will now operate while discharging the
extracted water through the free end of the fitted
pipe, Note, you must ensure that the free end of the
pipe is below the product outlet connection and that
the drain point is likewise lower than the unit outlet.
Filter Removal
•
To remove the filter you must first remove the
water tank as instructed above.
•
The filter can then be removed from its slot by
gripping the filter handle and sliding it down
and out of the back of the appliance as
indicated below.
• Every 2 weeks, remove the filter and clean it
with warm water, below 40°C. Allow it to dry
naturally and then replace by reversing the removal instruction above.
Fig 02
Fig 01
Care and Maintenance Instruction
1. To avoid the occurrence of vibration and noise the unit should not be
operated while located on any soft or uneven surface.
2. Never insert any foreign objects into the unit through its air inlet or outlet
to avoid hazard or unit failure.
3. During power off or when not in use for a long time, please disconnect
the product from the mains.
4. For a better dehumidifying effect, the areas to the front, rear and above
the unit should be clear and free from any obstacles which will block the
air flow of the unit. Do not block any air inlet or outlet grilles – keep clear
of hanging drapes, curtains and furnishings – DO NOT COVER, as
specified under safety information section a clearance of 50cm
should be maintained all around the appliance when it is in use.
5. Every 2 weeks, remove the air filter and clean it with warm water, below
40°C. Allow it to dry naturally and then replace by reversing the removal
instruction above.
SPECIFICATIONS
MODEL
SPECIFICATION
FTE10
FTE16 FTE20
POWER SUPPLY 220-240V~50Hz
POWER INPUT 250W 410W 480W
RUNNING CURRENT 1.2A 2.1A 2.2A
WEIGHT 11.1Kg 13.3Kg 13.7Kg
MOISTURE REMOVAL
(@ 30
℃
℃℃
℃
& RH 80%
）
））
）
10 litre/day
16 litre/day 20 litre/day
DIMEMSIONS
(WxDxH)mm
W:365 x D:220 x H:500
APPLICABLE
TEMPERATURE
5
℃
℃℃
℃
- 35
℃
℃℃
℃
WATER TANK CAPACITY 2.3L
(CE) N 842/2006:
R134A is a kind of fluorinated greenhouse gas covered by
the Kyoto Protocol.
Its total global warming potential (GWP) is 1300
Recycling:
For electrical products sold within the European
Community. At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice in
your country.
After Sales Service:
Your product is guaranteed for one year from the date of purchase. Within this
period, we undertake to repair or exchange this product free of charge
provided it has been installed and operated in accordance with these
instructions.
Your rights under this guarantee are additional to your statutory rights, which
in turn are not affected by this guarantee. Should you require after sales
information or assistance with this product please go to www.dimplex.co.uk or
ring our helpdesk on 0844 879 3588 (UK) or 01 842 4833 (R.O.I.).
It would assist us if you can quote the model number, series, date of purchase
and the nature of the fault at the time of your call. The customer services
helpdesk will also be able to advice you should need to purchase any spares.
Please do not return any faulty product to us in the first instance as this may
result in loss or damage and delay in providing you with a satisfactory service.
Please retain your receipt as proof of purchase.
____________________________________________________________
CE This appliance complies with European Safety Standard EN60335-2-40, and
European Electromagnetic Capability (EMC) EN55014-1, EN55014-2, EN61000-
3-2 and EN61000-3-3. These cover the essential requirements of EEC Directives
2006/95/EC and 2004/108/EC.
Dimplex Customer Service UK: 0844 879 3588
Millbrook House Fax: 0844 879 3582
Grange Drive Email: customer.service@gdcgroup.co.uk
Hedge End Republic of Ireland: 01 842 4833
Southampton
S030 2DF
A division of GDC Group Ltd.
Website: www.gdcgroup.co.uk
© GDC Group Ltd.
All rights reserved. Material contained in this publication may not be reproduced in whole
or in part without prior permission in writing of GDC Group Ltd.
