Hoover S2IN1300A User Manual
Displayed below is the user manual for S2IN1300A by Hoover which is a product in the Steam Cleaners category. This manual has pages.
Related Manuals
®
®
PRINTED IN P.R.C.
48014372
D
B
C
L
M
N
A
E
F
G
U
K
V
W
J
I
HR S
T
Q Q
O P
1 2
910 11
12
65 7 8
3414
17
16
18 19
15
13
+
+
1
GB
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning,
as described in this user guide. Please ensure that this
guide is fully understood before operating the appliance.
Do not leave the appliance plugged in. Always switch off
and remove the plug from the socket after use, or before
cleaning the appliance or any maintenance task.
This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance.
Keep the appliance out of reach of children
when it is energized or cooling down.
The appliance is not to be used if it has been dropped,
if there are visible signs of damage or if it is leaking.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised
Hoover service engineer must replace the power cord.
This appliance must be earthed.
The appliance shall not be left unattended while
it is connected to the supply mains.
Do not use your appliance out of doors.
Use only attachments, consumables or spares
recommended or supplied by Hoover.
Do not use the appliance to clean or direct
steam towards animals, people or plants.
Liquid or steam must not be directed towards equipment
containing electrical components, such as the interior of ovens.
Danger of Scalding.
Surfaces are liable to get very hot during
use. Avoid contact with steam.
Do not stand on or wrap the cord around arms
or legs when using your appliance.
Do not position the appliance above
you when cleaning the stairs.
When using the cleaning tools ensure to always steady
the appliance with your other hand. This will ensure
that the appliance does not fall while in use.
Do not handle the plug or appliance with wet hands.
Do not run over the power cord when using your appliance
or remove the plug by pulling on the power cord.
Do not continue to use your appliance if it appears faulty.
Hoover service: To ensure the continued safe and
that any servicing or repairs are only carried out
by an authorised Hoover service engineer.
Do not immerse the appliance in water or other liquids.
Do not use detergents or liquids other
than water inside the appliance.
For UK and Ireland only: This appliance has a 13
Amp mains plug. If you need to change the fuse in the
mains plug, use a 13Amp ASTA (BS1362) fuse.
The Environment
The symbol on this appliance indicates that this appliance may not be treated
as household waste. Instead it must be handed over to the applicable collection
point for the recycling of electrical and electronic equipment. Disposal must be
carried out in accordance with local environmental regulations for waste disposal.
For more detailed information about treatment, recovery and recycling of this
or the shop where you purchased the appliance.
This appliance complies with the European Directives 2006/95/EC, 2004/108/EC
and 2011/65/EU.
2
GB
A. Handle
B. Cord Hook
C. Power Cord
D. Handle Release Button
E. Handheld Carry Handle
F. Steam Trigger Button
Water Tank
H. Floor Head
I. Water Tank Cap
J. Steam Control Dial
K. Power Light
L. Utility Head
Small Cloth
Window Squeegee
O. Conic Tool
P. Hose
Q. Round Brush
R.
S. Comb Brush
T. De-scaling Tool
U. Water Cup
V.
W. Textile Pad
Remove all components from the packaging.
1. Insert the handle into the cleaner main body until it locks into position. [1]
2. Assemble the main body of the cleaner to the Floor Head. [2]
BEFORE YOU BEGIN CLEANING
1.
2.
indicated by illustration on Cap, and remove.
3.
Do not add any chemicals,detergents or perfumes to the clean Water Tank. [6]
4.
NOTE:
mop the use of distilled or de-mineralized water in the unit is highly recommended.
5. Attach a Textile Pad to the base of the Floor Head. [3]
IMPORTANT: Always unplug the cleaner when adding water or changing a Textile Pad.
NOTE: Wash the Textile Pad prior to use to remove any lint.
STEAM CLEANING HARD FLOORS
NOTE: Always sweep or vacuum the oor prior to use to remove any loose dirt or
debris.
IMPORTANT:Do not use the cleaner without a Textile Pad attached to the Floor Head.
NOTE:
1. Plug the steam cleaner into the mains power. Turn Steam Control Dial clockwise
depends on the current steaming task. Rotate the Steam Control Dial for desired
steam intensity.
2. After a few seconds Power Light stops blinking, indicating the cleaner is ready for
use.
3. Recline the cleaner by placing a foot on the Floor Head and lowering the main body
[8]
4.
REFRESHING CARPETS
NOTE: Always sweep or vacuum the oor prior to use to remove any loose dirt or debris.
I
MPORTANT: Do not use the cleaner without a Textile Pad attached to the Floor Head.
1. [4]
2. Plug the steam cleaner into the mains power. Turn Steam Control Dial clockwise
depends on the current steaming task. Rotate the Steam Control Dial for desired
steam intensity.
3. After a few seconds Power Light stops blinking, indicating the cleaner is ready for use.
4. Recline the cleaner by placing a foot on the Floor Head and lowering the main body
[8]
5.
3
GB
1.
2.
indicated by illustration on Cap, and remove.
3.
not add any chemicals,detergents or perfumes to the clean Water Tank.[6]
NOTE:
mop the use of distilled or de-mineralized water in the unit is highly recommended
.
4. Plug the steam cleaner into the mains power. Turn Steam Control Dial clockwise
depends on the current steaming task. Rotate the Steam Control Dial for desired
steam intensity.
5. After a few seconds Power Light stops blinking, indicating the cleaner is ready for
use.
6. To produce steam press Steam Trigger Button(Handheld).
NOTE:
mop the use of distilled or de-mineralized water in the unit is highly recommended.
IMPORTANT: Always unplug the cleaner when removing the Floor Head or handle.
Always ensure the cleaner has fully cooled down before removing the Floor Head.
ACCESSORIES
Without hose
1. After removing the Floor Head, Attach Conic Tool to Steam nozzle of main body
2. Fit other small accessories to Conic Tool and secure
With hose
1. Fit the Hose to Steam nozzle of main body .
2. Attach Conic Tool to the nozzle on the hose.
3. Fit other small accessories to Conic Tool
Window Squeegee and Utility Head [12]
The Window squeegee is to be installed on the Utility Head before installing on the Steam
nozzle of main body and is used for cleaning windows, mirrors and other smooth glass
surfaces. Fit Small Cloth on Utility Head before putting Window Squeegee on.
The Utility Head with Small Cloth is to be used for removing wrinkles from different
fabrics. Choose the steam intensity setting appropriate for the fabric you are steaming.
Comb Brush Ideal for cleaning all grout lines, sanded or not sanded.
Conic Tool Use on heavily soiled areas such as showers, kitchens.
Round Brush Use on stubborn grease and grime.
Metal Brush For oven grills and racks.
IMPORTANT: ALWAYS ENSURE THE CLEANER HAS FULLY COOLED DOWN
BEFORE PERFORMING ANY MAINTENANCE TASKS.
Empty the Water Tank
1. Unplug the cleaner from the mains power and ensure the unit has cooled.
2. Remove the water tank cap, pull off directly.
3. Empty any excess water from the tank. Replace the water tank cap.
.
Removing and cleaning the Textile Pad
1. Unplug the cleaner from the mains power and ensure the unit has cooled.
Floor Base.
3. Wash the Textile Pad in a washing machine with a mild detergent at max
temperature 40°C.
IMPORTANT: Do not use bleach or fabric softener when washing the Textile Pad.
Cleaning the blockage
1. Unplug the cleaner from the mains power and ensure the unit has cooled.
2. Ensure the water tank is empty.
4. Insert supplied de-scaling tool into steam outlet to clear any blockages.
5. R
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
The steam stick will not switch on.
The steam stick is not producing steam.
Steam output is weak or intermittent.
Steam Control Dial is set too LOW. Turn Steam Control Dial to a desired steam rate position.
The Textile Pad won’t pick up dirt.
4
GB
When is Steamjet ready? In approximately 30 seconds.
Can I use Steamjet on all oor surfaces?
Does Steamjet emit steam automatically?
steam you should press Steam Trigger Button under the handle.
Can I put detergents or other chemicals inside the tank?
What if in the city where I live the water is very hard?
How long will one tank of water last before needing to be relled? Approximately 12
minutes if you press continuously the trigger.
Is the mop washable?
mild detergent at max temperature 40°C. Do not use bleach or fabric softener.
How often should I replace the mop? It depends on different factors above all how
still dirty after having washed it or if you notice that it doesn’t perform like before.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Consumables
Filter Cassette U74 35601641
AC31 35601642
Small Cloths (x3) AC27 35601392
Hoover Customer Helpline Service
Customer Helpline on the number below.
Tel: 08444 995 599
Email: customer.services@hoovercandy.com
Quality
Hoover’s factories have been independently assessed for quality. Our products are
made using a quality system which meets the requirements of ISO 9001
Your Guarantee
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.