Indesit UI6 F1T W User Manual
Displayed below is the user manual for UI6 F1T W by Indesit which is a product in the Freezers category. This manual has pages.
Related Manuals
EN
Quick guide
THANK YOU FOR BUYING AN INDESIT PRODUCT
In order to receive a more complete assistance, please
register your product on www . indesit . com/ register
Before using the appliance carefully read the Safety
Instruction.
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting the
appliance to the power supply.
Connect the appliance to the power supply and turn the thermostat
knob to switch on the appliance.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available).
CONTROL PANEL
1. Temperature alarm indicator
2. Fast freezing function
3. Temperautre settings
(stand by button)
2.
1.
3.
TEMPERATURE ALARM INDICATOR
When the product is plugged in to the mains, during the rst 10
minutes of working, any temperature sensor failure will be displayed
on the control panel.
Led ON Led OFF
Legend:
Led flashing
The appliance will work anyway preserving the food stored, but it is
necessary to contact after-sales service and provide alarm code.
Note: The Temperature alarm may activate if the door is left open for a
prolonged period of time or following the introduction of fresh food in the
freezer compartment; this temporary rise in temperature does not aect
the storage of already frozen food in any way.
FAST FREEZING FUNCTION
The use of this function is recommended to increase the cooling speed
when placing a very high quantity of food in the freezer compartment.
To activate this function press the Temperature button on the control
panel repeatedly until 3 LED’s ash and then remain lit.
The function is automatically deactivated after 48 h.
TEMPERATURE SETTING
Press the Temperature button on the control panel to adjust the
temperature from the warmest through the lower to the coldest level.
Pressing the Temperature button, the temperature setting will change
cyclically.
At rst plug-in of appliance temperature setpoint is present at medium
position (factory setting).
Following table shows temperature setpoints:
Led ON Led OFF
Led ON
Led OFF
high temp.
med-high temp.
medium temp.
med-low temp.
low temp.
Note: Displayed set points correspond to the average temperature
throughout the whole freezer.
STANDBY BUTTON
To put the product in Stand-by, press and hold for 3 seconds the Stand-
by button. All the indicators turn o. To reactivate the appliance press
once (briey) or for 3 seconds this button.
HOW TO STORE FOOD AND BEVERAGE
Legend
FREEZING ZONE
All food items
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The appliance doesn’t work. There may be an appliance power
supply problem.
Make sure:
• there is not a power failure;
• the plug is properly inserted in the power socket and the double-
pole switch (if present) is in the correct position (on);
• the household electrical system protection devices function;
• the power cable is not broken.
The inside light does not
work.
It may be necessary to replace the light
bulb.
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
The internal temperature
of the compartments is not
cold enough.
The reasons could vary (see “Solution”)
column.
Check that:
• the doors are closed properly;
• the appliance is not installed near a heat source;
• the temperature is appropriately set;
• the circulation of air through the ventilation grilles on the base of
the appliance is not obstructed.
There is water on the
bottom of the refrigerator
compartment.
The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and
Maintenance").
Excessive amount of frost in
the freezer compartment.
The door to the freezer compartment is
not closed properly.
• Check that there is nothing preventing the door from closing
properly.
• Defrost the freezer compartment.
• Make sure the appliance has been correctly installed.
The front edge of the
appliance that the door
gaskets seal against is hot.
This is not a problem. It prevents
condensation from forming.
A solution is not needed.
The temperature of the
refrigerator compartment is
too cold.
• The set temperature is too cold.
• A large amount of fresh food may
have been placed in the freezer
compartment.
• Try to set a less cold temperature.
• If fresh food has been put in the freezer compartment, wait until
the freezing has been completed.
• Turn o the fan (if present) described in the paragraph “FAN”.
19515388300
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
• Visiting our website docs . indesit . eu
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication
plate.