JPL JPL-DECT Lifter User Manual
Displayed below is the user manual for JPL-DECT Lifter by JPL which is a product in the Headphone/Headset Accessories category. This manual has pages.
Related Manuals
JPL-DECT Lifter
Headset Lifter Explained
Thank you for choosing the JPL-DECT Lifter
Compatible with JPL / AGENT / JABRA / GN NETCOM / RADIUS W-300
This lifter is designed to allow you to answer and end calls
remotely from your desk when using a DECT headset.
f
4. Handset supporting PAD
3. Surround microphone 1 5. Lifter arm
9. Slide switch
(Fig 1)
1. Connection cord
2. Ring detection LED
8. Ring detection microphone
7. Adhesive tapes
6. External microphone jack
Connect to a wireless DECT module base station.
Will ash when deskphone rings.
Detects and eliminates cross talk between mic and ring detection.
Omnidirectional adjustment in order to cradle dierent handset models.
Raises handset from its standby position.
Used to aid in ring detection on more unusual phone models.
Use to secure lifter to the deskphone.
Activates lifter arm upon decting ringing.
Adjusts height of lifting mechanism.
Detects and eliminates environmental sound that can interfere with the ring
detection microphone.
1. Connection cord:
2. Ring detection LED:
3. Surround microphone 1:
4. Handset pad:
5. Lifter arm:
6. External microphone jack:
7. Adhesive pads:
8. Ring detection microphone:
9. Rake slider:
10. Surround microphone 2:
10. Surround microphone 2
Revision 060718
Set up Instructions
Setting up your handset lifter:
Remove the handset from your telephone.
Secure the handset lifter over the loud speaker on
your telephone, using the attached adhesive tape.
Ensure the ring detection sensor is placed
centrally over your telephone’s speaker.
Plug the lifter cord directly into the port on your
DECT base station. You should now be able to
answer/end calls using the answer button on your cordless headset.
Troubleshooting:
When lifter doesn’t raise enough.
Check that when the headset is activated, the handset lifter is raising the handset off the hook switch. If the
lifter height needs raising, you can change this with the slide switch (No. 9), to either position 2 or 3.
When my telephone rings, I do not hear the ring indicator in my headset
Ensure the line cable from the handset lifter is fully plugged into the correct port on your cordless headset’s
base unit.
The ring volume on your telephone may need increasing to enable the microphone sensor to recognize the
ringtone.
The handset lifter does not lift my telephone handset
Manually lift the handset off the telephone base and press your headset button. If you cannot hear dial tone,
then check all connections on both units and also your headset configuration.
PLACEMENT OF LIFTER
Revision 060718
If you’re having any other problems or need more information on this product,
please call us on +44 (0)1258 820100 or visit our website at www.jpltele.com.