LG W122CE User Manual
Displayed below is the user manual for W122CE by LG which is a product in the Window & Through-Wall Air Conditioners category. This manual has pages.
Related Manuals
www.lg.com
OWNER’S MANUAL
Please read this manual carefully before operating
your set and retain it for future reference.
TYPE :
WINDOW
AIR
CONDITIONER
MODELS W121CE SL0 W122CE SL0
W182CE ST0
NORSK SUOMI DANSK
P/NO : MFL69716003
14
10
7
This appliance is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and
knowledge, unless they have been given su-
pervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
WARNING: Before accessing the terminals, all
power circuits must be disconnected.
WARNING: Fixed installations will incorporate disconnect
means in accordance with installation rules.
WARNING: This device will not be accessible to public.
WARNING: The appliance must be installed in
accordance with national regulations for electrical
installations.
Read completely, then follow step-by step.
• The appliance shall be installed in accordance with national wiring regulation.
• If a power plug isn't to be used, provide a circuit breaker between power source and the unit, as following
picture.
Main Power source
Circuit Breaker
Use a circuit breaker
or time delay.
1. To prevent vibration and noise, make sure the unit is
installed securely and firmly.
2. Install the unit where the sunlight does not shine directly on
the unit.
3. There should be no obstacle, such as a
fence or wall, within 50cm from the back of the cabinet
because it will prevent heat radiation of the condenser.
Restriction of outside air will greatly reduce the cooling
efficiency of the air conditioner.
4. Install the unit a little obliquely outward not to leak the
condensed water into the room (about 10 ~ 15 mm or 1/4
bubble with level).
CAUTION: All side louvers of the cabinet must
remain exposed to the outside of the structure.
Select the Best Location
10
~15 mm
Over 50 cm
HEAT
RADIATION
FENCE
AWNING
FOAM
COOLED
AIR
70-150cm
Level
1/4 Bubble
3. Slide the air conditioner into the case.
Reinstall the 2 screws removed earlier on each
side of the case.
CAUTION: The power cord must be
connected to an independent circuit. The
green wire must be grounded.
4. Stuff the foam between the top of the unit and the
wall to prevent air and insects from getting into the
room. The Foam
5
6
7
8
10
7
FAN SPEED SELECTOR
ON/OFF TIMER
OPERATION MODE SELECTOR
POWER
11
TEMPERATURE CONTROL
REMOTE CONTROL SENSOR
CLEAN FILTER
12
13
14
Troubleshooting Tips
Save time and money! Review the chart below first and
you may not need to call for service.
Normal Operation
• You may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy
days or when the humidity is high. This design feature helps remove moisture and improve efficiency.
• You may hear the thermostat click when the compressor cycles on and off.
• Water will collect in the base pan during high humidity or on rainy days. The water may overflow and drip from
the outdoor side of the unit.
• The fan may run even when the compressor does not.
Abnormal Operation
Problem Possible Causes What To Do
■The air conditioner is unplugged.
■The fuse is blown/circuit breaker is
tripped.
■Power failure.
■Airflow is restricted.
■The thermostat may not be set
high enough.
■ TEMP Control set too higher
number.
■The air filter is dirty.
■The room may have been hot.
■Cold air is escaping.
■Cooling coils have iced up.
■Ice blocks the air flow and stops
the air conditioner from cooling the
room.
• Make sure the air conditioner plug is pushed
completely into the outlet.
• Check the house fuse/circuit breaker box and
replace the fuse or reset the breaker.
•
If power failure occurs, push power button to OFF.
When power is restored, wait 3 minutes to restart
the air conditioner to prevent tripping of the
compressor overload.
• Make sure there are no curtains, blinds, or
furniture blocking the front of the air conditioner.
• Turn the knob to a higher setting. The highest
setting provides maximum cooling.
• Set the TEMP control to a lower number.
• Clean the filter at least every 2 weeks.
See the operating instructions section.
• When the air conditioner is first turned on you
need to allow time for the room to cool down.
• Check for open furnace floor registers and cold
air returns.
• Set the air conditioner's vent to the closed
position.
• See Air Conditioner Freezing Up below.
• Set the mode control at MED fan or high cool
with the thermostat at 1or 2(Left side).
• Set the mode control at HIGH fan or high cool
with the high temperature.
Air conditioner
does not start
Air conditioner
does not cool as it
should
Air conditioner
freezing up
15
16
18
22
25
29
17
18
19
20
21
C
22
3
4
23
Conectar la vivienda.
5
24
6
7
8
25
7
26
CONTROL DE TEMPERATURA
SENSOR DEL CONTROL REMOTO
LIMPIEZA DEL FILTRO
27
28
30
30
W121CE SL01 040W 9,7A
W121CE SL0
W122CE SL01 040W 4,8A
W122CE SL0
W182CE ST0 1 590W 7,2A
W182CE ST0
Sor Juana Inés de la Cruz No. 555
Col. San Lorenzo Industrial
Tlalnepantla de Baz, Estado de México
C.P. 54033