Register your product and get support at
1 Important 2
2 Your Docking Speaker 3
What's in the box 3
Overview of the main unit 4
3 Get started 5
Connect power 5
4 Play 5
Play from iPod/iPhone 5
Play from an external audio device 6
Charge the iPod/iPhone 6
General information 7
6 Troubleshooting 7
7 Notice 8
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Do not block any ventilation openings.
Install in accordance with the
Do not install near any heat sources such
as radiators, heat registers, stoves, or
Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the apparatus.
by the manufacturer.
Unplug this apparatus during lightning
storms or when unused for long periods
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
Apparatus shall not be exposed to
dripping or splashing.
Do not place any sources of danger on the
Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
Never remove the casing of this apparatus.
Never place this apparatus on other electrical
Ensure that you always have easy access to the power
cord, plug or adaptor to disconnect the apparatus from
2 Your Docking
Congratulations on your purchase, and
support that Philips offers, register your product
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
Model No. __________________________
Serial No. ___________________________
With this docking speaker, you can enjoy audio
from the iPod/iPhone, and other external audio
What's in the box
Check and identify the contents of your
AC power adaptor
Quick start guide
Overview of the main unit
Start or pause play.
c VOLUME + / -
d Dock for the iPod/iPhone
Connect an external audio device.
f DC IN
Connect AC power.
3 Get started
Always follow the instructions in this chapter in
Risk of product damage! Make sure that the power
supply voltage matches the voltage printed on the
bottom of the docking speaker.
Risk of electric shock! When you unplug the AC
adaptor, always pull the plug from the socket. Never
pull the cord.
Connect the AC power adaptor to:
the DC IN socket at the back of the
the wall outlet.
Play from iPod/iPhone
You can enjoy audio from your iPod/iPhone
through this docking speaker.
The docking speaker supports the following
iPod and iPhone models:
iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th
Listen to the iPod/iPhone
1 Place an iPod/iPhone in the dock.
2 Play audio on the iPod/iPhone.
3 To adjust volume, press VOL +/-.
4 To mute, press .
5 To play or pause, press .
To remove the iPod/iPhone:
Pull the iPod/iPhone out of the dock.
Play from an external audio
Make sure that no iPod/iPhone is docked in the speaker.
the MP3 LINK socket at the back of
the docking speaker.
the headphone socket on an external
2 Press to play music on the device.
Charge the iPod/iPhone
When the docking speaker is connected to
power, the docked iPod/iPhone begins to
Total Output Power 4W per channel x 2
Signal to Noise Ratio > 62 dBA
MP3 Link 650mV RMS
AC Power Model: AS110-080-
Input: 100-240 V ~,
Output: 8.0 V 1.3 A
Consumption 15 W
Consumption <0.5 W
265x 94x 74 mm
- Main Unit
- With Packing
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site
Philips, ensure that the apparatus is nearby
and the model number and serial number are
Ensure that the AC power plug of the unit
is connected properly.
Ensure that there is power at the AC outlet.
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power
plug, then turn on the unit again.
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
This product complies with the radio
interference requirements of the European
“Made for iPod” and “Made for iPhone”
mean that an electronic accessory has been
the developer to meet Apple performance
standards. Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note that
the use of this accessory with iPod or iPhone
may affect wireless performance.
iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.
Your product is designed and manufactured
with high quality materials
and components, which can be recycled and
When you see the crossed-out wheel bin
symbol attached to a product,
it means the product is covered by the
European Directive 2002/96/EC:
Never dispose of your product with other
household waste. Pleaseinform yourself about
the local rules on the separate collection of
electrical and electronic products. The correct
disposal of your oldproduct helps prevent
potentially negative consequences on the
environment and human health.
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
Your system consists of materials which can
be recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, old equipment.
Specifications are subject to change without notice
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.