Table of Contents
Philips AJ3200/05 User Manual
Displayed below is the user manual for AJ3200/05 by Philips which is a product in the Radios category. This manual has pages.
Related Manuals
www.philips.com/support
User manual
Always there to help you
Register your product and get support at
AJ3200
Question?
Contact
Philips
1EN
Contents
1 Important 2
2 Your clock radio 2
Introduction 2
What's in the box 2
Overview of the clock radio 3
3 Get started 4
Install battery 4
Connect power 4
Turn on 4
Set time 4
4 Listen to FM radio 5
Tune to FM radio stations 5
Store FM radio stations in memory 5
Select a preset radio station 5
Adjust volume 5
5 Other features 6
Charge your mobile devices 6
Set alarm timer 7
Set sleep timer 7
6 Product information 8
Specications 8
7 Troubleshooting 9
8 Notice 9
2EN
1 Important
Warning
• Never remove the casing of this clock radio.
• Never lubricate any part of this clock radio.
• Never place this clock radio on other electrical
equipment.
• Keep this clock radio away from direct sunlight, naked
amesorheat.
• Make sure that you always have easy access to the
power cord, plug or adaptor to disconnect the clock
radio from the power.
• Make sure that there is enough free space
around the product for ventilation.
• Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
clock radio:
• Install the battery correctly, + and - as
marked on the clock radio.
• Do not mix batteries (old and new or
carbon and alkaline, etc.).
• Remove the battery when the clock
radio is not used for a long time.
• The battery shall not be exposed to
excessiveheatsuchassunshine,reor
the like.
• Use only power supplies listed in the user
manual.
• The clock radio shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on the
clockradio(e.g.liquidlledobjects,lighted
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
2 Your clock radio
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this clock radio, you can
• listen to FM radio;
• charge your mobile devices; and
• set two alarms to ring at different time.
What's in the box
Check and identify the contents of your
package. (Fig. 1)
3EN
Overview of the clock radio
a Dock for charging mobile devices
b SOURCE
• Turn on the clock radio.
• Switch the clock radio to standby
mode.
• Select FM radio source.
c PRESET/SET TIME
• Store radio stations in memory.
• Select a preset radio station.
• Set time.
d AL1/AL2/- VOLUME +
• Set alarm.
• Adjust volume.
e HR/MIN/- TUNE +
• Tune to FM radio stations.
• Set hour and minute.
f SNOOZE/SLEEP
• Snooze alarm.
• Set the sleep timer.
g Display panel
• Display current status.
d
e
f
a
c
b
g
4EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Install battery
The batteries can only back up clock and alarm
settings when AC power is disconnected.
Caution
• The batteries contain chemical substances, so they
should be disposed of properly.
1 Open the battery compartment.
2 Insert 2 AA batteries with correct polarity
(+/-) as illustrated.
3 Close the battery compartment.
Tip
• The display backlight is off when AC power is
disconnected.
Connect power
Caution
• Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the clock radio.
• Risk of electric shock! When you unplug the AC adapter,
always pull the plug from the socket. Never pull the cord.
Connect the AC power adaptor to the wall
socket.
Turn on
Press to turn on the clock radio.
» The clock radio enters FM radio mode.
• Press again to switch the product to
standby mode.
Set time
Note
• You can only set time in standby mode.
1 Press and hold SET TIME for two seconds
to activate clock setting mode.
» The hour and minute digits blink.
2 Press HR repeatedly to set hour.
3 Press MIN repeatedly to set minute.
4 Press SET TIMEagaintoconrm.
» The set time is displayed.
5EN
4 Listen to FM
radio
Note
• Keep the clock radio away from other electronic
devices to avoid radio interference.
• For better reception, fully extend and adjust the
position of the FM antenna.
Tune to FM radio stations
1 Press SOURCE to turn on FM radio.
2 Press and hold TUNE - or TUNE + for 2
seconds.
» The clock radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more radio
stations.
To tune to a station manually:
In tuner mode, press TUNE - or TUNE +
repeatedly to select a frequency.
Store FM radio stations in
memory
You can store up to 10 FM radio stations.
1 Tune to an FM radio station.
2 Press and hold PRESET for two seconds.
» The preset number begins to blink.
3 Press TUNE - or TUNE + to select a
number.
4 Press PRESETagaintoconrm.
5 Repeat steps 1 to 4 to store other stations.
Tip
• To remove a pre-stored station, store another station
in its place.
Select a preset radio station
In tuner mode, press PRESET repeatedly to
select a preset station.
Adjust volume
While listening, press - VOLUME + to adjust
volume.
6EN
5 Other features
Charge your mobile devices
With this clock radio, you can charge your
Android-powered mobile phone with a micro
USB socket and Apple devices with a lightning
or 30-pin connector.
1 Connect the clock radio with your mobile
device.
• For Android-powered mobile device
with a micro USB socket: use the
supplied cable to connect the product
with the mobile device as illustrated;
• For Apple devices with a lightning or
30-pin connector: use the charging
cable of the Apple device (not
supplied) to connect the product with
the mobile device as illustrated;
2 Connect the clock radio to AC power.
» The mobile device begins to charge.
Note
• Gibson Innovations does not guarantee the
compatibility of this product with all devices.
7EN
Set alarm timer
You can set two alarms to ring at different time.
Note
• You can only set the alarm in standby mode.
• Make sure that you have set the clock correctly.
1 Press and hold AL1 or AL2 for two
seconds to activate alarm setting mode.
» The hour and minute digits blink.
2 Press HR repeatedly to set the hour.
3 Press MIN repeatedly to set the minute.
4 Press AL1 or AL2toconrm.
Tip
• The clock radio exits alarm setting mode when being
idle for 10 seconds.
Activate or deactivate the alarm timer
Press AL1 or AL2 repeatedly to activate or
deactivate the alarm timer.
» If the alarm timer is activated, the
alarm indicator for FM tuner or buzzer
is displayed.
» If the alarm timer is deactivated, the
alarm indicator disappears.
• To stop the ringing alarm, press the
corresponding AL1/AL2.
» The alarm repeats ringing for the next
day.
Note
• If FM tuner is selected and you are listening to radio
when alarm time comes, buzzer is activated automatically.
• If buzzer is selected as alarm source, the alarm volume
remains at a default level.
• If FM tuner is selected as alarm source, the alarm
volume increases gradually and cannot be adjusted.
Alarm source Alarm
duration
AC power FM tuner/Buzzer 30 minutes
Snooze the alarm
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing
nine minutes later.
Set sleep timer
1 Turn on the product..
2 Press SLEEP repeatedly to select a period
(in minutes).
» The clock radio switches to standby
mode automatically after the preset
period.
To deactivate the sleep timer:
• Press SLEEP repeatedly until [OFF]
(off) appears.
120 90 60 30 15
OFF
8EN
6 Product
information
Note
• Product information is subject to change without prior
notice.
Specications
Amplier
Total Output Power 500 mW
Tuner (FM)
Tuning Range 87.5-108
MHz
Tuning Grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio <22 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >50 dBA
General information
AC Power
(Power Adapter)
Brand name: Philips;
Model: S012B0551500B;
Input: 100-240V~ 50/60Hz
max. 300mA
Output: 5.5 V 1500mA
USB Port 5 V 1 A
Operation Power
Consumption
9 W
Standby Power
Consumption
<1 W
Dimensions:
- Main Unit
(W x H x D) 112 x 101 x 125 mm
Weight:
- Main Unit 0.4 kg
9EN
7 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
No power
•Make sure that the AC power plug of the
unit is connected properly.
•Make sure that there is power at the AC
outlet.
No sound
•Adjust the volume.
No response from the unit
•Disconnect and reconnect the AC power
plug, then turn on the unit again.
Cannot charge your mobile devices
•Make sure that the Apple device or
Android-powered device is connected
with the clock radio properly.
•Make sure that the clock radio is powered
on.
Poor radio reception
•Increase the distance between the product
and other electrical appliances.
•Fully extend the antenna.
Alarm does not work
•Set the clock/alarm correctly.
Clock/alarm setting erased
•Power has been interrupted or the power
plug has been disconnected.
•Reset the clock/alarm.
8 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
Gibson Innovations may void the user’s
authority to operate the equipment.
Hereby, Gibson Innovations declares that
this product is in compliance with the
essential requirements and other relevant
provisions of Directive 2014/53/EU. You
canndtheDeclarationofConformityon
www.philips.com/support.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol
is attached to a product it means that the
product is covered by the European Directive
2012/19/EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
10 EN
Your product contains batteries covered by
the European Directive 2013/56/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Note
• The type plate is located on the bottom of the
apparatus.
Class II equipment symbol:
CLASS II apparatus with double insulation, and
no protective earth provided.
Specications are subject to change without notice.
Copyright © 2014 Gibson Innovations Limited. Revised Edition © 2017
This product has been manufactured by, and is sold under the responsibility of Gibson
Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license.
AJ3200_05_UM_V4.0