Table of Contents
Philips AQ1001/05 User Manual
Displayed below is the user manual for AQ1001/05 by Philips which is a product in the Home Audio Systems category. This manual has pages.
Related Manuals
Register your product and get support at
www.philips.com/welcome
AQ1001
User manual
1EN
Contents
1 Important 2
Safety 2
2 Your Cassette Recorder 3
Introduction 3
What's in the box 3
3 Get started 3
Carry the recorder 3
Install batteries 3
Connect power 4
4 Play 4
Play a cassette 4
Record from different sources 5
5 Other features 5
Listen through headphones 5
6 Product information 6
Specications 6
7 Troubleshooting 7
8 Notice 7
2EN
1 Important
Safety
• Heed all warnings and follow all
instructions.
• Do not use the device near water.
• Clean only with dry cloth.
• Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
• Do not install near any heat sources such
as radiators, heat registers, stoves, or other
devices(includingampliers)thatproduce
heat.
• Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the device.
• Onlyuseattachments/accessoriesspecied
by the manufacturer.
• Unplug the device during lightning storms
or when unused for long periods of time.
• Referallservicingtoqualiedservice
personnel. Servicing is required when the
device has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have
fallen into the device, the device has been
exposed to rain or moisture, does not
operate normally, or has been dropped.
• Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
device:
• Incorrect use of batteries can cause
electrolyte leakage and will corrode
the compartment or cause the
batteries to burst.
• Old and new or different types of
batteries should not be combined.
• Install the battery correctly, + and - as
marked on the device.
• Remove battery when the device is
not used for a long time.
• Batteries contain chemical substances,
so they should be disposed of properly.
• The device shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on
thedevice(e.g.liquidlledobjects,lighted
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
•Never remove the casing of this device.
•Never place this device on other electrical equipment.
•Keep this device away from direct sunlight, naked
amesorheat.
•Toreducetheriskofreorelectricshock,donot
expose this device to rain or moisture.
•Ensure that you always have easy access to the power
cord, plug, or adapter to disconnect this device from
the power.
3EN
2 Your Cassette
Recorder
Introduction
With this cassette recorder, you can play a
cassette and make a recording.
What's in the box
Qu ck star t guide
3 Get started
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of your apparatus. The
model number and serial number are on the
bottom of your apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Carry the recorder
Pull out the handle to carry the recorder.
Install batteries
Tip
•You can use both batteries and AC power as power
supply of this device.
1 Open the battery compartment.
2 InsertfourCtypebatteries(notsupplied)
withcorrectpolarity(+/-)asindicated.
3 Close the battery compartment.
UT MAIC TOP
C S ET E RE OR ER A 1 01
4EN
Tip
•The RECORD BATT lights when battery is low.
Connect power
Caution
•Risk of product damage! Ensure that the power voltage
corresponds to the voltage printed on the back or
underside of the unit.
•Risk of electric shock! When you unplug the power
adapter, always pull the plug from the socket. Never
pull the cord.
•Before connecting the power adapter, ensure that you
have completed all other connections.
•Use the supplied power adapter only.
DC IN
4 Play
Play a cassette
1 Press STOP/EJECT to open the cassette
door.
2 Load a cassette with the side to play facing
up.
3 Push to close the cassette door.
4 Press to start play.
Control play
Buttons Functions
Press both and to record.
Start play.
Rewind the tape.
Search forward fast.
Pause play.
Adjust volume
VOLUME
5EN
Record from different
sources
1 Prepare the source.
• Build-in microphone: place the
recorder within 0 5m from the sound
source.
• External microphone: insert the
microphoneplug(notsupplied)into
the MIC jack. If the microphone has a
remote control plug, connect it to the
REM jack.
• Audio source: connect an external
audio device to the AUX jack through
anAUX-INcable(notsupplied),and
set the volume of the audio device to
the desired level.
2 Press STOP/EJECT to load a blank tape.
3 Press RECORD and PLAY at the same
time to start recording.
» Both RECORD and PLAY lock down
and recording begins.
Note
•Do not force down RECORD if no tape is loaded.
•The VOLUME setting doesn't control the recording
level.
4 Press STOP/EJECT to stop recording.
Tip
•Recording stops automatically when the tape ends.
5 Other features
Listen through headphones
Plug headphones into EAR socket on the left of
the device.
Hearing safety
Listen at a moderate volume.
• Using headphones at a high volume can
impair your hearing. This product can
produce sounds in decibel ranges that may
cause hearing loss for a normal person,
even for exposure less than a minute. The
higher decibel ranges are offered for those
that may have already experienced some
hearing loss.
• Sound can be deceiving. Over time your
hearing 'comfort level' adapts to higher
volumes of sound. So after prolonged
listening, what sounds 'normal' can actually
be loud and harmful to your hearing. To
guard against this, set your volume to a safe
level before your hearing adapts and leave
it there.
To establish a safe volume level:
• Set your volume control at a low setting.
• Slowly increase the sound until you can
hear it comfortably and clearly, without
distortion.
Listen for reasonable periods of time:
• Prolonged exposure to sound, even
at normally 'safe' levels, can also cause
hearing loss.
• Be sure to use your equipment reasonably
and take appropriate breaks.
Be sure to observe the following guidelines
when using your headphones.
• Listen at reasonable volumes for
reasonable periods of time.
6EN
• Be careful not to adjust the volume as your
hearing adapts.
• Do not turn up the volume so high that
you can't hear what's around you.
• You should use caution or temporarily
discontinue use in potentially hazardous
situations. Do not use headphones while
operating a motorized vehicle, cycling,
skateboarding,etc.;itmaycreateatrafc
hazard and is illegal in many areas.
6 Product
information
Note
•Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 0.4 W RMS
Frequency Response 125-6300Hz
Signal to Noise Ratio >45 dB
Total Harmonic Distortion <1%
Aux Input 0.6VRMS20kohm
General information
Power Supply
- AC Power Adaptor
- Battery
Model: KSAS3R
50600050VKD
Input:100-240V~,
50/60Hz;0.15A
Output:6.0V 0.5
mA
4 X C batteries
Operation Power
Consumption 3 W
Dimensions
-MainUnit(WxHxD) 144x46x241mm
Weight
- With Packing
- Main Unit
0.83 kg
0.64kg
7EN
7 Troubleshooting
Warning
•Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support).Whenyoucontact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
•Ensure that the AC power plug of the unit
is connected properly.
•Ensure that there is power at the AC
outlet.
•Insert the batteries with their polarities
(+/–signs)alignedasindicated.
•Replace the battery.
No sound
•Adjust the volume.
No response from the unit
•Take out the batteries and turn on the unit
again.
•Disconnect and reconnect the AC power
plug, then turn on the unit again.
8 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
This product complies with the radio
interference requirements of the European
Community.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
iscoveredbytheEuropeanDirective2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
Your product contains batteries covered by
theEuropeanDirective2006/66/EC,which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
8EN
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Recording and playback of material might
requireconsent.SeeCopyrightAct1956and
The Performer’s Protection Acts 1958 to 1972.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separateintothreematerials:cardboard(box),
paperpulp(buffer)andpolyethylene(bags,
protectivefoamsheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Note
•The type plate is located on the bottom of the
apparatus.
Specifications are subject to change without notice
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
AQ1001_05_UM_V1.1