Table of Contents
Philips AZ105S/79 User Manual
Displayed below is the user manual for AZ105S/79 by Philips which is a product in the Portable Stereo Systems category. This manual has pages.
Related Manuals
www.philips.com/support
AZ105
Always there to help you
User Manual
Question?
Contact
Philips
Register your product and get support at
2EN
Contents
1 Important 3
2 Your CD Soundmachine 4
Introduction 4
What's in the box 4
Overview of the main unit 5
3 Get started 6
Connect power 6
Turn on 7
4 Play 8
Play disc 8
Listen to FM radio 8
Play from an external device 8
5 Product information 9
Specications 9
Maintenance 9
6 Troubleshooting 10
7 Notice 10
3EN
1 Important
• Read these instructions.
• Follow all instructions.
• Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
• Do not install near any heat sources such
as radiators, heat registers, stoves, or
otherapparatus(includingampliers)that
produce heat.
• Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles, and the point
where they exit from the unit.
• Onlyuseattachments/accessoriesspecied
by the manufacturer.
• Unplug this unit during lightning storms or
when unused for long periods of time.
• Referallservicingtoqualiedservice
personnel. Servicing is required when the
unit has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have
fallen into the apparatus, the unit has been
exposed to rain or moisture, does not
operate normally, or has been dropped.
• Battery usage CAUTION – To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
unit:
• Install all batteries correctly, + and - as
marked on the unit.
• Do not mix batteries (old and new or
carbonandalkaline,etc.).
• Remove batteries when the unit is not
used for a long time.
• Batteries (battery pack or batteries
installed)shallnotbeexposedtoexcessive
heatsuchassunshine,reorthelike.
• The unit shall not be exposed to dripping
or splashing.
• Do not place any sources of danger on
theunit(e.g.liquidlledobjects,lighted
candles).
• Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
• Never remove the casing of this apparatus.
• Never place this apparatus on other electrical
equipment.
• Never look into the laser beam inside this apparatus.
Caution
• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
4EN
2 Your CD
Soundmachine
Introduction
With this CD Soundmachine, you can:
• listen to FM radio;
• enjoy audio from discs, and other external
audio devices;
• program the play sequence of tracks.
TheunitoffersyouDynamicBassBoost(DBB)
to enrich sound.
What's in the box
Check and identify the contents of the package:
• Main unit
• AC power cord
• Short user manual
5EN
Overview of the main unit
a - VOLUME +
• Adjust volume.
b SHUFFLE
• In CD mode, play tracks randomly.
c REPEAT
• In CD mode, play a track or all tracks
repeatedly.
d
• Start or pause play.
e
• Stop play.
• Erase a program.
a
k
b
c
d
e
f
h
i
j
m
n
o
l
p
g
f Display panel
g PROG
• In CD mode, program the play
sequence of tracks.
h FM frequency indicator
i LIFT TO OPEN
• Open or close the disc compartment.
j - TUNING +
• Tune to FM radio stations.
k /
• Skip to the previous or next track.
• Search within a track.
6EN
l FM antenna
• Improve FM reception.
m Source selector
• Select a source: FM, Audio-in, or CD.
• Turn the unit off.
n Audio-in
• Connect an external audio device.
o AC~ MAINS
• Connect power.
p DBB switch
• ON/OFF: turn dynamic bass boost on
or off.
3 Get started
Caution
• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Connect power
The unit can be powered by either AC power
or batteries.
Option 1: AC power
Warning
• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the unit.
• Risk of electric shock! When you disconnect the AC
power, always pull the plug from the socket. Never pull
the cord.
Connect the AC power cord to:
• the AC~ MAINS socket on the unit.
• the wall socket.
Note
• To switch the unit off completely, disconnect the power
cord from the power supply socket.
7EN
Option 2: Battery power
Caution
• Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
• Batteries contain chemical substances, so they should
be disposed of properly.
Note
• Batteries are not supplied with the accessories.
1 Open the battery compartment.
2 Insert 6 batteries (type: R14/ UM2/ C
CELL)withcorrectpolarity(+/-)as
indicated.
3 Close the battery compartment.
AC~MAINS
Turn on
Switch the source selector to FM, Audio-in, or
CD.
Turn off
Switch the source selector to OFF.
Switch to standby mode
In CD mode, the unit switches to standby
mode after 15 minutes of inactivity.
To exit the standby mode:
• Press ; or
• Select an audio source.
8EN
4 Play
Play disc
1 Switch the source selector to CD.
2 Lift to open the disc compartment.
3 Insert a disc with the printed side facing up,
then close the disc compartment.
» Play starts automatically.
Control play
/ Selectanaudiole;
Press and hold to fast-forward
or fast-reverse the track during
playback, then release to resume
play.
Pause or resume play.
Stop play.
REPEAT [ ]: Play the current track
repeatedly.
[ ]: Play all tracks repeatedly.
SHUFFLE [ ]: Play tracks randomly.
- VOLUME + Adjust volume.
Enhance bass
To turn dynamic bass boost on or off, slide DBB
switch to ON or OFF.
Program tracks
You can program a maximum of 20 tracks.
1 Press to stop playback.
2 Press PROG to activate the program
mode.
» [PROG] (program)begintoblink.
3 Press / to select a track number,
and then press PROGtoconrm.
4 Repeat step 3 to program more tracks.
5 Press to play the programmed tracks.
» During play, [PROG] (program)and
the preset number are displayed.
• To erase the program, press twice.
Listen to FM radio
Note
• Position the antenna as far as possible from TV, VCR or
other radiation source.
• For optimal reception, fully extend and adjust the
position of the antenna.
1 Switch the source selector to FM.
2 Rotate - TUNING + to tune to an FM
radio station.
Play from an external device
You can also listen to an external audio device
through this unit.
1 Switch the source selector to Audio-in.
2 Connect an audio cable (3.5mm, not
supplied)to:
• the Audio-in socket on the unit.
• the headphone socket on an external
device.
3 Play the external device (see the device's
usermanual).
Note
• The Audio-in socket is not for headphones.
9EN
5 Product
information
Note
• Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 2 x 1 W RMS
Frequency Response 63 -14000 Hz, -3 dB
Signal to Noise Ratio >57 dBA
Total Harmonic
Distortion
<1 %
Audio-in Input 650 mV RMS
Disc
Laser Type Semiconductor
Disc Diameter 12cm/8cm
Support Disc CD-DA, CD-R, CD-RW
Total Harmonic
Distortion
<1%
Frequency Response 63 -14000 Hz, -3 dB
Signal to Noise Ratio >57 dBA
Tuner
Tuning Range FM: 87.5 - 108MHz
Total Harmonic Distortion <3 %
Signal to Noise Ratio >50 dBA
Speakers
Speaker Impedance 8 ohm
General
Power supply
- AC Power
- Battery
220-240 V ~, 50/60 Hz
9V,6x1.5VR14/UM2
Operation Power
Consumption
15 W
Standby Power
Consumption
< 0.5 W
Dimensions - Main Unit
(WxHxD)
261 x 123 x 245 mm
Weight - Main Unit 1.1 kg
Maintenance
Clean the cabinet
• Use a soft cloth slightly moistened with
a mild detergent solution. Do not use a
solution containing alcohol, spirits, ammonia
or abrasives.
Clean discs
• When a disc becomes dirty, clean it with
a cleaning cloth. Wipe the disc from the
centre out.
• Do not use solvents such as benzene,
thinner, commercially available cleaners,
or antistatic spray intended for analogue
records.
Clean the disc lens
• After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure good
play quality, clean the disc lens with Philips
CD lens cleaner or any commercially
available cleaner. Follow the instructions
supplied with cleaner.
10EN
6 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support).Whenyoucontact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
•Ensure that the AC power plug of the unit
is connected properly.
•Ensure that there is power at the AC
outlet.
•Insert the batteries with their polarities
(+/–signs)alignedasindicated.
•Replace the battery.
No sound
•Adjust the volume.
No response from the unit
•Take out the batteries and turn on the unit
again.
•Disconnect and reconnect the AC power
plug, then turn on the unit again.
No disc detected
•Insert a disc.
•Check if the disc is inserted upside down.
•Wait until the moisture condensation at
the lens has cleared.
•Replace or clean the disc.
•UseanalizedCDorcorrectformatdisc.
Poor radio reception
•Increase the distance between the unit and
your TV or VCR.
•Fully extend the FM antenna.
7 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
This product complies with the radio
interference requirements of the European
Community.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
iscoveredbytheEuropeanDirective2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
Your product contains batteries covered by
the European Directive 2006/66/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
11 EN
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separateintothreematerials:cardboard(box),
paperpulp(buffer)andpolyethylene(bags,
protectivefoamsheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
This apparatus includes these labels:
Class II equipment symbol
This symbol indicates that the apparatus has a
double insulation system.
Note
• The type plate is located on the bottom of the
apparatus.
2015 Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under
the responsibility of Gibson Innovations Ltd., and Gibson
Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used under
license from Koninklijke Philips N.V.
AZ105_79_UM_V2.0