Table of Contents
Philips BT2200B/27 User Manual
Displayed below is the user manual for BT2200B/27 by Philips which is a product in the Portable Speakers category. This manual has pages.
Related Manuals
www.philips.com/support
User manual
Always there to help you
Register your product and get support at
BT2200
Question?
Contact
Philips
1
English
EN
Contents
1 Important 2
Important safety instructions 2
2 Your Bluetooth speaker 3
Introduction 3
What’s in the box 3
Overview of the speaker 4
3 Get started 5
Charge the built-in battery 5
Switch on/off 5
4 Use Bluetooth devices 7
Connect a device 7
Play from Bluetooth device 8
Control your phone call 8
5 Other features 9
Listen to an external device 9
Adjust volume 9
6 Product information 10
Specications 10
7 Troubleshooting 11
General 11
About Bluetooth device 11
8 Notice 12
Contents
2EN
1 Important
Warning
•Never remove the casing of this speaker.
•Never lubricate any part of this speaker.
•Never place this speaker on other electrical equipment.
•Keep this speaker away from direct sunlight, naked
amesorheat.
Important safety instructions
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation
openings. Install in accordance with
the manufacturer’s instructions.
h Do not install near any heat sources
such as radiators, heat registers,
stoves, or other apparatus (including
ampliers) that produce heat.
i Only use attachments/accessories
specied by the manufacturer.
j Refer all servicing to qualied service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as liquid has been spilled or
objects have fallen into the apparatus,
the apparatus has been exposed to
rain or moisture, does not operate
normally, or has been dropped.
k Battery shall not be exposed to excessive
heat such as sunshine, re or the like.
l Do not place any sources of
danger on the apparatus (e.g. liquid
lled objects, lighted candles).
m This speaker is designed to be waterproof
in compliance with IEC 60529 IPX6.
n Before use in environment
subject to water, always securely
close the protective cover at
the bottom of the speaker.
o After use in environment subject to
water, immediately clean the speaker with
a soft dry cloth and let it dry in a well-
ventilated place away from direct sunlight.
Note
•The type plate is located on the back of the product.
3
English
EN
2 Your Bluetooth
speaker
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfrom
the support that Philips offers, register your
product at www.philips.com/welcome.
Introduction
With this speaker, you can
• enjoy audio from your Bluetooth-enabled
devices or other external audio devices;
and
• control the incoming phone call through
Bluetooth connection.
What’s in the box
Check and identify the contents
of your package:
• Main unit
• USB cable
• Short user manual
4EN
Overview of the speaker
a
• Press and hold to switch on or off.
b +/-
• Adjust volume.
c
• Press and hold for more than 2
seconds to enter pairing mode
manually.
• Press and hold for more than 10
seconds to clear pairing information.
• Press to answer answer
an incoming call.
• Press and hold to reject
an incoming call.
• During a call, press to
end the current call.
a
b
c
e
d
f
d Waterproof protective cover
e AUDIO IN socket
• Connect an external audio device.
f USB charging socket
• Recharge the built-in battery.
5
English
EN
3 Get started
Always follow the instructions in
this chapter in sequence.
Charge the built-in battery
The speaker is powered by a built-
in rechargeable battery.
Note
•Before use, fully charge the built-in battery.
•The micro USB socket is for charging only.
•Rechargeable battery has a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
1 Pull open the protective cover.
2 Connect the USB cable between
• the USB charging socket on the speaker,
and
• a USB socket on a computer.
DC IN
The LED indicator on the button
indicates the battery status.
LED indicator on
the button
Battery status
Solid red Under
charging
Off, or solid white when the
speaker is switched on
Fully charged
Flashing red Low power
Switch on/off
• Press and hold to switch the speaker on.
» The LED indicator on the button
turns solid white.
» Forrst-timesetup,theLEDindicator
on the buttonasheswhite,
indicating that the speaker is in pairing
mode.
• To switch off, press and hold again.
» The LED indicator on the button
turns off.
100%
6EN
Switch to standby mode
• In Bluetooth mode, if Bluetooth connection
is invalid or music playback is stopped
for 15 minutes, this speaker switches to
standby mode automatically.
• In AUDIO IN mode, if the audio-in cable is
disconnected or music playback is stopped
for 15 minutes, this speaker switches to
standby mode automatically.
» To switch on from standby mode, start
music play again.
7
English
EN
4 Use Bluetooth
devices
With this speaker, you can listen to audio
from Bluetooth-enabled devices and control
the incoming call through Bluetooth.
Connect a device
Note
•Make sure that your Bluetooth device is compatible
with this speaker.
•Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
•The speaker can memorize a maximum of 8 paired
devices.
•Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
•Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
•Keep away from any other electronic device that may
cause interference.
•The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
Philips BT2200
1 Make sure that the speaker is in pairing
mode, that is, the LED indicator on the
buttonasheswhite.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
(refer to the user manual of the device).
3 When [Philips BT2200] is displayed on
your device, select it to start pairing and
connection. If necessary, enter default
password “0000”.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator on the button turns solid
white.
To disconnect the Bluetooth-enabled device:
• Disable Bluetooth on your device;
• Press on the speaker; or
• Move the device beyond the
communication range.
To clear the existing pairing information:
• Press and hold for more than 10
seconds.
To reconnect the Bluetooth-enabled device:
• For a paired Bluetooth device on which
automatic reconnection is enabled, this
product reconnects with it once it is
detected.
• For a paired Bluetooth device that does
not support automatic reconnection,
reconnect it with this product manually.
To connect another Bluetooth-enabled device:
• Disable Bluetooth on the current device,
and wait for around 3 minutes before you
connect another device.
LED indicator on
the button
Description
Flashing white Connecting or waiting
for connection
Solid white Connected
8EN
Play from Bluetooth device
Note
•If there is an incoming call on the connected mobile
phone, music play pauses.
• After successful Bluetooth connection, play
audio on the Bluetooth device.
» Audio streams from your Bluetooth
device to the speaker.
Control your phone call
After Bluetooth connection, you can control
an incoming call with this speaker.
Button Function
Press to answer answer
an incoming call.
Press and hold to reject
an incoming call.
During a call, press to end
the current phone call.
Note
•You can talk through the microphone of the speaker.
•Music play pauses when there is an incoming call, and
resumes when your phone call ends.
9
English
EN
5 Other features
Listen to an external device
With this speaker, you can also listen to an
external audio device such as an MP3 player.
1 Pull open the protective cover.
2 Connect an audio input cable with a 3.5
mm connector on both ends to
• the AUDIO IN socket on this speaker,
and
• the headphone socket on
the external device.
» The speaker switches to the AUDIO
IN source automatically.
3 Play audio on the external device (refer to
its user manual).
Tip
•When you unplug the 3.5mm audio cable, the speaker
switches to the Bluetooth source automatically.
Adjust volume
• Press +/- on the speaker to increase or
decrease the volume.
10 EN
6 Product
information
Note
•Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 1 X 2.8W RMS
Frequency Response 40 - 20000
Hz, ±3dB
Signal to Noise Ratio > 62dBA
AUX Input sensitivity 260mV RMS
22kohm
Bluetooth
Bluetooth version V4.0
Bluetooth
Frequency Band
2.402GHz ~
2.48GHz ISM Band
Range 10 m (Free space)
Speakers
Speaker Impedance 4 ohm
Speaker Driver 4 cm full range
Sensitivity > 81dB/m/W
± 3dB/m/W
General information
Power Supply (through
USB socket)
DC 5 V, 500mA
Built-in Battery Li-polymer battery
(3.7V, 500mAh)
Water resistance IPX6
Operation temperature 0˚C~45˚C
Storage temperature -40˚C~70˚C
Dimensions - Main
Unit (W x H x D)
107.3 x 69.1
x 58 mm
Weight - Main Unit 0.2 kg
11
English
EN
7 Troubleshooting
Warning
•Never remove the casing of this device.
To keep the warranty valid, never try
to repair the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
General
No power
• Recharge your speaker.
No sound
•Adjust volume on the speaker or
the Bluetooth-connected device.
•Make sure that your Bluetooth device is
within the effective operational range.
No response from the speaker
•Restart the speaker.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•The Bluetooth reception is poor. Move
the device closer to this product or
remove any obstacle between them.
Cannot connect with the device.
•The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
•This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
The paired device connects and disconnects
constantly.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
•For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature. This does not indicate
any malfunction of this product.
12 EN
8 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Notice for the USA and Canada
This device complies with Part 15 of
the FCC Rules and RSS standard of
Industry Canada. Operation is subject
to the following two conditions:
1 this device may not cause harmful
interference, and
2 this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to part 15 of
the FCC Rules and CAN ICES(B)/NMB-
3(B) of Industry Canada. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instruction manual, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
RF Radiation Exposure Statement: This
equipment complies with FCC’s and IC’s RF
radiation exposure limits set forth for an
uncontrolled environment. The antenna(s)
used for this transmitter must be installed and
operated to provide a separation distance
of at least 20 cm from all persons and must
not be collocated or operating in conjunction
with any other antenna or transmitter.
Installers must ensure that 20cm separation
distance will be maintained between the
device (excluding its handset) and users.
This Class [B] digital apparatus complies
with Canadian CAN ICES(B)/NMB-3(B).
Disposal of your old product and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This product may contain lead and
mercury. Disposal of these materials
may be regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or visit www.recycle.philips.com.
This product contains non-removable batteries:
• Do not incinerate. Batteries may explode if
overheated.
• For disposal or recycling information,
please contact your local authorities or visit
www.recycle.philips.com.
Caution
•Removal of the built-in battery invalidates the warranty
and may destroy the product.
13
English
EN
Always bring your product to a professional
to remove the built-in battery.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy
to separate into three materials: cardboard
(box), polystyrene foam (buffer) and
polyethylene (bags, protective foam sheet.)
Your system consists of materials which
can be recycled and reused if disassembled
by a specialized company. Please observe
the local regulations regarding the
disposal of packaging materials, exhausted
batteries and old equipment.
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by
WOOX Innovations is under license.
Specications are subject to change without notice.
2013 © WOOX Innovations Limited. All rights reserved.
This product was brought to the market by WOOX
Innovations Limited or one of its afliates, further referred
to in this document as WOOX Innovations, and is the
manufacturer of the product. WOOX Innovations is the
warrantor in relation to the product with which this booklet
was packaged. Philips and the Philips Shield Emblem are
registered trademarks of Koninklijke Philips N.V.
BT2200_UM_10_V1.0