Table of Contents
StarTech.com APLVESAMNTP User Manual
Displayed below is the user manual for APLVESAMNTP by StarTech.com which is a product in the Monitor Mount Accessories category. This manual has pages.
Related Manuals
1
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Compliance Statements
Use of Trademarks, Registered Trademarks, and other
Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and
other protected names and/or symbols of third-party companies not related in
any way to StarTech.com. Where they occur these references are for illustrative
purposes only and do not represent an endorsement of a product or service
by StarTech.com, or an endorsement of the product(s) to which this manual
applies by the third-party company in question. Regardless of any direct
acknowledgement elsewhere in the body of this document, StarTech.com
hereby acknowledges that all trademarks, registered trademarks, service marks,
and other protected names and/or symbols contained in this manual and
related documents are the property of their respective holders.
2
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Warning Statements
• Make sure that you assemble this product according to the instructions.
• Do not exceed the weight capacity of this product. Overloading this product
might result in injury or property damage. This product can support the
following weight: 30.8 lb. (14 kg).
• This product is intended for indoor use only and should not be used
outdoors.
Varningsmeddelanden
• Se till att du monterar produkten i enlighet med instruktionerna.
• Överskrid inte produktens viktkapacitet. Överbelastning av produkten kan
orsaka skada på person eller egendom. Denna produkt har stöd för följande
vikter: 14 kg.
• Produkten är endast avsedd för användning inomhus och ska inte användas
utomhus.
Avertissements
• Assemblez ce produit conformément aux instructions.
• Ne dépassez pas la capacité pondérale du produit. Une surcharge du produit
peut entraîner des blessures ou des dommages matériels. Ce produit peut
supporter 14 kg.
• Ce produit est uniquement destiné à une utilisation en intérieur et ne doit
pas être utilisé à l’extérieur.
Warnhinweise
• Beachten Sie bei der Montage dieses Produkts die Montageanweisungen.
• Überschreiten Sie nicht die Tragkraft dieses Produkts. Ein Überladen dieses
Produkts kann zu Verletzungen oder zur Beschädigung des Produkts führen.
Dieses Produkt ist für folgendes Gewicht geeignet: 14 kg.
• Dieses Produkt ist nur zum Gebrauch in Innenräumen vorgesehen und sollte
nicht im Freien verwendet werden.
Dichiarazioni di avvertenza
• Assicurarsi di Assemblare il prodotto secondo le istruzioni.
• Non superare la capacità di carico del prodotto. Il sovraccarico del prodotto
potrebbe causare danni o lesioni. Il prodotto è in grado di supportare i
seguenti pesi: 14 kg.
• Il prodotto è destinato all’uso in ambienti interni. Se ne sconsiglia l’impiego
in ambienti esterni.
3
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Mensagens de aviso
• Certique-se de que monta este produto de acordo com as instruções.
• Não exceda a capacidade de peso deste produto. Sobrecarregar este produto
pode resultar em ferimentos ou danos de propriedade. Este produto pode
suportar o seguinte peso: 14 kg.
• Este produto destina-se apenas a uma utilização no interior e não deve ser
utilizado no exterior.
Advertencias de uso
• Asegúrese de ensamblar este producto según las instrucciones.
• Asegúrese de no exceder la capacidad de peso de este producto. La
sobrecarga de este producto puede causar lesiones personales o daños en la
propiedad. Este producto tiene capicidad para el siguiente peso: 14 kg.
• El uso de este producto es solo para interiores y no debe utilizarse en
exteriores.
Waarschuwingen
• Zorg dat u dit product volgens de instructies in elkaar zet.
• Overschrijd de maximale capaciteit van dit product niet. Overbelasting
van dit product kan letsel of materiële schade veroorzaken. Dit product
ondersteunt het volgende gewicht: 14 kg.
• Dit product is alleen bedoeld voor binnengebruik en mag niet buiten
worden gebruikt.
注意
• 必ず取扱説明書に従って本製品の組み立てを行って下さい。
• 本製品で定められた最大積載重量を超えないようにして下さい。最大積載重量をオーバーした
場合、怪我をする恐れや器物破損の恐れがあります。
本製品は、モニター1台あたり14kgまで支
持できます。
• 本製品は、室内での使用を想定しています。戸外では使用しないで下さい。
4
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Table of Contents
Compliance Statements ........................................................................1
Warning Statements ..............................................................................2
Product Diagram ....................................................................................5
Product Information .............................................................................6
Specications.............................................................................................................................................. 6
Package Contents .....................................................................................................................................8
Attaching a Monitor ...............................................................................10
5
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Product Diagram
1Plastic Caps (x 4) 3Mounting Point
2VESA Monitor Adapter
1
2
3
6
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Product Information
Specications
Type of measurement Measurement
VESA Mounting Hole
Pattern
75x75
100x100
Tilt
+90 to -15
Screen Size
Maximum 30 in. (762 mm)
Rotate
360
7
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Swivel
360
LB
kg
Weight/Load Capacity
30.8 lb. (14 kg)
8
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Package Contents
Monitor Mount
Qty: 1
Flange Mount
Qty: 1
VESA Screws
Qty: 4
Torx Key
Qty: 1
9
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
3 mm Hex Key
Qty: 1
4 mm Hex Key
Qty: 1
Access Card
Qty: 1
Monitor Mount Screws
Qty: 2
Plastic Caps
Qty: 4
10
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Attaching a Monitor
1. Turn o the iMac Monitor and disconnect all cables
connected to the back of the iMac Monitor.
2. Turn the iMac Monitor around so that the back is facing
forward.
3. Tilt the top of the iMac Monitor forward.
4. Insert the Access Card into the slot at the top of the
Monitor Stand, disengaging the locking mechanism.
Notes: The Access Card needs to be on a slight upward
angle and will need to go into the slot approximately 3/4 of
an inch order to disengage the locking mechanism.
Only the Access Card should be used to disengage the lock-
ing mechanism.
Tilt the iMac Monitor and Insert the Access Card
11
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
5. Tilt the iMac Monitor forward until the Monitor Stand
is locked into place and the eight screws on the Monitor
Stand are visible.
6. Lay the iMac Monitor face down on a at surface (e.g. desk)
with the Monitor Stand hanging over the edge of the desk.
7. Use the Torx Key to remove the eight screws from the back
of the iMac Monitor.
Removing the Screws from the iMac Monitor
8. Remove the stand from the iMac Monitor.
9. While sliding the Flange overtop of the Mounting Bracket,
align the center hole and the eight holes in the Flange
with the eight threaded holes and alignment pin on the
Mounting Bracket.
12
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
10. Re-insert the eight screws through the Flange.
11. Using the Torx Key tighten the eight screws, being careful
not to over-tighten.
Installing the Flange
12. Slide the Plastic Caps (x 4) over the ends of the Monitor
Mount, to protect the surface of the iMac Monitor.
Installing the Plastic Caps
13
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
13. Align the 2 screw holes on the Monitor Mount with the 2
Mounting holes on the Flange. The orientation of the iMac
Monitor is important.
Aligning the Monitor Mount
14. Insert the 2 Monitor Mount Screws through the Monitor
Mount and into the Flange.
15. Use the Hex Key (4 mm) to tighten the Monitor Mount
Screws. Be careful not to over-tighten the Monitor Mount
Screws.
14
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Attaching the Monitor Mount
Attaching the Monitor Mount
Notes: Attaching the Monitor Mount may require two
people.
The Monitor Mount supports up to a maximum of 30.86 lb.
(14 kg).
1. While supporting the weight of the Monitor, carefully
align the Mounting Hole on the Monitor Mount with the
Mounting Peg on the top Swivel Arm on the compatible
Startech.com mount.
2. Slide the Mounting Hole on the Monitor Mount over the
Mounting Peg until it clicks into place.
15
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Attaching the Monitor Mount
3. Using the 4 mm Hex Key, adjust the swivel tension of the
Monitor Mount by loosening or tightening the Hex Screw
located on the Monitor Mount next to the Mounting Hole.
16
Warranty Information
This product is backed by a ten-year warranty.
For further information on product warranty terms and conditions, please refer
to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or
their ocers, directors, employees or agents) for any damages (whether direct
or indirect, special, punitive, incidental, consequential, or otherwise), loss of
prots, loss of business, or any pecuniary loss, arising out of or related to the use
of the product exceed the actual price paid for the product.
Some states do not allow the exclusion or limitation of incidental or
consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
16
Hard-to-nd made easy. At StarTech.com, that isn’t a slogan.
It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need.
From the latest technology to legacy products — and all the parts that bridge
the old and new — we can help you nd the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they
need to go. Just talk to one of our tech advisors or visit our website. You’ll be
connected to the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products
and to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and
technology parts. StarTech.com was founded in 1985 and has operations in the
United States, Canada, the United Kingdom and Taiwan servicing a worldwide
market.
Reviews
Share your experiences using StarTech.com products, including product
applications and setup, what you love about the products, and areas for
improvement.
StarTech.com Ltd.
45 Artisans Cres.
London, Ontario
N5V 5E9
Canada
StarTech.com LLP
2500 Creekside Pkwy.
Lockbourne, Ohio
43137
U.S.A.
StarTech.com Ltd.
Unit B, Pinnacle
15 Gowerton Rd.,
Brackmills
Northampton
NN4 7BW
United Kingdom
FR: startech.com/fr
DE: startech.com/de
ES: startech.com/es
NL: startech.com/nl
IT: startech.com/it
JP: startech.com/jp
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support