StarTech.com RKPW161915 User Manual
Displayed below is the user manual for RKPW161915 by StarTech.com which is a product in the Power Distribution Units (PDUs) category. This manual has pages.
Related Manuals
Instruction Manual
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
Manual Revision: 08/13/2020
For the most up-to-date information, please visit: www.startech.com
Packaging Contents
• RKPW161915 Power Distribution Unit
• Installation Guide
System Requirements
• 19” front/rear mounting rack/cabinet (EIA 310-D compliant)
• 125VAC power source
RKPW161915
16 Outlet PDU Power Distribution Unit 125V 15A (12A UL)
*actual product may vary from photos
Installation
1. The power distribution unit takes up 1U of rack space, so locate an
appropriate location on the rack and mount it against the front or
rear mounting posts.
2. Using the mounting hardware (screws, nuts, etc.) provided with
your rack or from your rack manufacturer, secure the unit to the
posts.
3. Connect the power cable from the distribution unit to a 125VAC
power source.
Note: It is recommended that the unit be connected directly to a
main source and not another distribution unit.
4. Toggle the “Reset” switch on the front of the unit to the ‘on’
position to energize the unit.
5. The “Power” and “Surge” LEDs should light up to indicate surge
protection is active. The “Ground” LED should light up to indicate
proper grounding is present.
Note: If the “SURGE” LED indicator is o, the surge protection circuit
is compromised. Power cycle the power strip by toggling the power
switch to the “OFF” position and back to the “ON” position. If a
power cycle does not remedy the issue, it is likely the power strip has
absorbed a power surge. Please contact your authorized
StarTech.com reseller to purchase a replacement, or StarTech.com if
you require additional support.
6. You may now attach your 125VAC compatible devices to the
distribution unit.
Note: Combined power draw from all devices should not exceed
15A, otherwise the built-in circuit breaker will trip.
7. In the event of an overload scenario, the built-in circuit breaker
will be tripped and power to all outlets will be stopped.
8. Disconnect the problem device or all devices from the distribution
unit and toggle the “Reset” switch to turn the ports back on.
NEMA 5-15 outlets
Reset switch
Ground LED
Surge LED Power LED
Front View
Rear View
Specications
Number of Power Outlets 16
Connectors 16 x NEMA 5-15 female
Electrical Rating 125VAC / 15A
LEDs
1 x Ground (green)
1 x Surge (red)
1 x Power (yellow)
Operating Temperature -5oC to 45
o
C (23oF to 113oF)
Storage Temperature -25oC to 65oC (-13oF to 149oF)
Dimensions 482.6mm x 95.5mm x 42.7mm
Weight 2360g
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s)
to which this manual applies by the third-party company in question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all
trademarks, registered trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the property of their respective holders.
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials and workmanship for the periods noted, following the initial date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion. The warranty covers parts and labor costs only. StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental,
consequential, or otherwise), loss of prots, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product. Some states do not allow
the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.