StarTech.com UDCMTRAY User Manual
Displayed below is the user manual for UDCMTRAY by StarTech.com which is a product in the Cable Organizers category. This manual has pages.
Related Manuals
Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: November 12, 2020
Product Diagram (UDCMTRAY)
Components Function
1Cable Tray Organizer • Organize and hide Cables
• Hide a Power Strip
2Mounting Holes/
Screws
• Mount the Cable Tray Organizer underneath
a Desk
• #12 Phillips® Head Screws
3Screwdriver Access
Holes
• Cutouts that allow a Phillips Head
Screwdriver or a Phillips Head Drill Bit to
pass through the bottom of the Cable Tray
Organizer
Note: A long Phillips Head Screwdriver or a
Drill Bit Extension may be required to fasten the
Mounting Screws.
Requirements
For the latest requirements, please visit www.startech.com/UDCMTRAY.
• #3 Phillips Head Screwdriver or a Power Drill with a Phillips Head Bit x 1
• Power Drill with a Drill Bit x 1
• Pencil x 1
• (Optional) Drill Bit Extension x 1
Under Desk Cable Tray Organizer
Installation
Note: It is easier to complete the following installation steps with two people.
1. Hold the Cable Tray Organizer in the desired location under the Desk, with the
Mounting Holes resting against the underside of the Desk.
2. Mark the location of the Mounting Holes using a Pencil.
3. Use a Power Drill with an appropriately sized Drill Bit to drill Pilot Holes into the
locations of the Mounting Holes.
Notes: The Pilot Holes should be the same depth as the length of the Mounting
Screws. A small piece of tape can be placed on the Drill Bit to mark the proper depth
of the Pilot Holes.
The Drill Bit size will be determined by the wood used to construct the Desk. Consult a
professional if you are unable to determine the proper Drill Bit size.
4. Insert the Mounting Screws through the Mounting Holes and into the Desk.
(Figure 1)
5. Fasten the Screws into the Desk using a Phillips Head Screwdriver or a Power
Drill with a Phillips Head Bit.
114mm
76mm
600mm
400mm
1
2
2
3
3
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-
party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the
property of their respective holders.
PHILLIPS® is a registered trademark of Phillips Screw Company in the United States or other countries.
Warranty Information
This product is backed by a two-year warranty.
For further information on product warranty terms and conditions, please refer to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents)
for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of prots, loss of
business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product.
Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
Safety Measures
• If product has an exposed circuit board, do not touch the product under power.
Mesures de sécurité
• Si l’un des circuits imprimés du produit est visible, ne pas touchez le produit lorsqu’il est sous tension.
安全対策
• 製品に露出した状態の回路基盤が含まれる場合、電源が入っている状態で製品に触らないでください。
Misure di sicurezza
• Se il prodotto ha un circuito stampato visibile, non toccare il prodotto quando è acceso.
Säkerhetsåtgärder
• Rör aldrig vid enheter med oskyddade kretskort när strömmen är påslagen.
FR: fr.startech.com
DE: de.startech.com
ES: es.startech.com
NL: nl.startech.com
IT: it.startech.com
JP: jp.startech.com
StarTech.com Ltd.
45 Artisans Cres
London, Ontario
N5V 5E9
Canada
StarTech.com Ltd.
Unit B, Pinnacle 15
Gowerton Rd,
Brackmills
Northampton
NN4 7BW
United Kingdom
StarTech.com LLP
4490 South Hamilton
Road
Groveport, Ohio
43125
U.S.A.
Figure 1