Table of Contents
Vaddio CeilingMIC User Manual
Displayed below is the user manual for CeilingMIC by Vaddio which is a product in the Microphones category. This manual has pages.
Related Manuals
Document Number 411-0033-31 Rev B – February 2019
Installing CeilingMIC Conference Room Microphones
This guide contains only the information required to install this product. Refer to the
Complete Manual for CeilingMIC Conference Room Microphones for
additional product information, compliance statements, and warranty information.
Products Covered
This manual covers:
CeilingMIC Conference Room Microphone (worldwide) – 999-85100-000
(white); 999-85150-000 (black)
The CeilingMIC System is a component of the following conferencing product
bundles:
nEasyTALK USB Audio Bundle – 999-86400-000 (North America); 999-86400-
001 (Europe/UK); 999-86400-009 (Australia/New Zealand)
nEasyUSB MicPod I/O with two CeilingMICs – 999-88000-000 (North America);
999-88000-001 (Europe/UK)
nEasyUSB MicPod I/O with four CeilingMICs – 999-88100-000 (North America); 999-88100-001 (Europe/UK)
nConferenceSHOT AV System with one CeilingMIC, white – 999-99950-100W (North America); 999-99950-
101W (Europe/UK); 999-99950-109W (Australia/New Zealand)
nConferenceSHOT AV System with one CeilingMIC, black – 999-99950-100 (North America); 999-99950-101
(Europe/UK); 999-99950-109 (Australia/New Zealand)
nConferenceSHOT AV System with two CeilingMICs, white – 999-99950-200W (North America); 999-99950-
201W (Europe/UK); 999-99950-209W (Australia/New Zealand)
nConferenceSHOT AV System with two CeilingMICs, black – 999-99950-200 (North America); 999-99950-201
(Europe/UK); 999-99950-209 (Australia/New Zealand)
nConferenceSHOT AV Camera (no speaker) with one CeilingMIC, white – 999-99950-800W (North America);
999-99950-801W (Europe/UK); 999-99950-809W (Australia/New Zealand)
nConferenceSHOT AV Camera (no speaker) with oneCeilingMIC, black – 999-99950-800 (North America); 999-
99950-801 (Europe/UK); 999-99950-809 (Australia/New Zealand)
nConferenceSHOT AV Camera (no speaker) with two CeilingMICs, white – 999-99950-700W (North America);
999-99950-701W (Europe/UK); 999-99950-709W (Australia/New Zealand)
nConferenceSHOT AV Camera (no speaker) with two CeilingMICs, black – 999-99950-700 (North America); 999-
99950-701 (Europe/UK); 999-99950-709 (Australia/New Zealand)
What's in the Box
Make sure you received all the items you expected.
CeilingMIC System (worldwide) – 999-85100-000 (white); 999-85150-000 (black)
nIn-ceiling interface box
nMicrophone body and strain-relief boot (white or black)
nTile brace
nTrim plates, qty. 2, with mounting hardware (white or black)
nDrop-down cable (white or black)
nSmall zip-tie
nStrain relief clamp
nSplit grommet
Contact Vaddio Technical Support if you did not receive all the items listed.
A Quick Look at the CeilingMIC
Interface box
nProvides AEC reference from far end and applies it to each microphone element
individually
nNew design emphasizes simplicity and ease of connection
nUp to 100 ft. cable distance from the interface box to the connected device
Trim plates
nWhite or black, to match the microphone body
nTwo-piece design can be installed after the rest of the installation is complete
Drop-down cable
nMatches the trim ring and microphone body
nUp to 15 ft. (4.6 m) drop-down cable length supported
Strain relief boot
nSecurely grips the drop cable to prevent tension at the connector
nSplit design and flexible material for easy installation
nAccomodates standard category cable; installers can build cable to length
nClean lines for visual appeal
Microphone body
nThree-element design with improved geometry for 360° coverage with better audio pick-up
nEach microphone element features integrated echo cancellation and Digital Signal Processing (DSP), including
equalization, filtering and automatic gain control (AGC)
nEasy access to the cable connector in the microphone
nNew cloth-wrapped design
Note
Contact Vaddio Technical Support if your installation requires a drop-down cable longer than 15 ft. (4.6 m).
Preparing for a Successful Audio Installation
Here are a few tips for avoiding common audio problems.
nThe effective range for each Vaddio conference room microphone is about 12 ft. (3.7 m) under most
circumstances. Be sure the room design includes enough microphones to provide adequate coverage.
nBecause of the microphone geometry, sensitivity is somewhat reduced in a small area directly below the
CeilingMIC. In a small to medium corporate conference room, it may make sense to suspend the CeilingMIC(s)
above the centerline of the conference table.
nTo prevent audio feedback, keep microphones at least 4 ft. (1.2 m) from speakers. More separation is better.
nAlways place microphones closer to the people talking than to the speakers. This helps maintain quality echo
cancellation.
nDo not route CeilingMIC cables across or beside fluorescent light fixtures; electrical interference from the
ballasts may degrade the audio signal.
nMount the CeilingMIC away from air vents; they can pick up the sounds of the HVAC system.
nDo not let cats play with CeilingMIC conference room microphones. (OK, that's not actually a common
problem.)
Installing CeilingMIC Conference Room Microphones
2
Tools You Will Need
To install the CeilingMIC, you will need:
nHole saw for the appropriate type of ceiling
n#2 Phillips screwdriver
nWire cutters
nTape measure
nLadder or lift
nAppropriate personal protective equipment
Safety Information
Installing the CeilingMIC requires the use of a ladder or lift.
Warning
Follow standard safety practices when using ladders or lifts. Failure to do so can result in injury or death.
Note
All above-ceiling work must conform to local building codes and should be performed by qualified personnel.
Don’t Void Your Warranty!
Caution
This product is for indoor use. Do not install it outdoors or in a humid environment without the appropriate protective
enclosure. Do not allow it to come into contact with any liquid.
Do not install or operate this product if it has been dropped, damaged, or exposed to liquids. If any of these things
happen, return it to Vaddio for safety and functional testing.
Cabling Notes
Caution
Do not use pass-through RJ-45 connectors. If they are crimped incorrectly, they can damage the
connectors on the product, cause intermittent connections, and degrade signal quality. Physical
damage to the connectors may void your warranty.
Intact – will make reliable contact
with cable connector
Damaged – Bent contact fingers
will NOT make reliable contact with
cable connector
Use Cat-5e or better cable. We recommend using high-quality connectors and a high-quality crimping tool.
We recommend shielded cabling if the cables will be coiled, run tightly with other cables, or placed close sources of
electromagnetic interference such as power lines.
Caution
Check your cables. Connecting a cable to the wrong port or using the wrong pin-out can result in equipment damage
and will void the warranty.
Pro Tip
Label all cables at both ends.
Installing CeilingMIC Conference Room Microphones
3
Installing the CeilingMIC
Warning
Follow standard safety practices when using ladders or lifts. Failure to do so can result in injury or death.
We like you, we don't want you to be injured or killed, and we hope you understand the gravity of the situation.
Preparing the Ceiling Box
1. Remove the cover from the ceiling box.
2. Determine the desired length of the drop cable, from the ceiling to the top of the microphone body (not the top of
the strain relief boot). Be sure this leaves enough cable inside the ceiling box to avoid placing tension on the
connector.
Note
If desired, you can use a Cat-5 cable made to the desired length for the microphone drop-down cable. The cable
may be up to 15 ft. (4.6 m); contact Vaddio Technical Support if your installation requires a longer drop cable.
3. Thread the drop cable through the opening in the floor of the box.
4. Snap the strain relief grommet onto the drop cable at the desired cable length, and press it
into the opening in the floor of the box.
5. Connect the drop cable to the port labeled IN FROM MIC.
6. If there is excess cable above the grommet, thread a zip tie through the tie loop in the side
of the box and secure the cable.
Preparing the Ceiling
If installing in a hard ceiling:
Using the tile brace as a template, make a hole in the ceiling where the microphone will be
mounted.
If installing in a suspended tile ceiling:
1. Remove the ceiling tile where the microphone will be mounted, and make a hole in the ceiling tile using the tile
brace as a template.
2. Reinstall the ceiling tile and position the tile brace.
Note
Because the CeilingMIC assembly weighs very little, the tile brace does not need to be physically attached to
the tile support grid unless this is required by local building codes.
Installing CeilingMIC Conference Room Microphones
4
Working Above the Ceiling
1. Route a Cat-5e (or better) cable from the ceiling box to the mixer or other audio device. The cable may be up to
100 ft. (30 m.) long.
2. Thread the cable through the opening in the side of the ceiling box.
3. Install the split grommet in the opening in the side of the ceiling box to keep the cable from chafing.
4. Connect the cable to the port labeled OUT TO MIXER.
5. Reinstall the cover on the ceiling box.
6. Thread the drop cable through the opening in the ceiling and place the ceiling box flat.
Working Below the Ceiling
1. Connect the drop cable to the port in the microphone body.
2. Fit the strain relief boot over the drop cable.
3. Fit the strain relief boot into place in the microphone body.
4. Slide both the slotted trim plates over the cable, making sure the countersinks face outward, and turn them so
the slots are on opposite sides. Use the 3/4 inch flat head screws to secure the trim plates to the threaded posts
on the bottom of the interface box.
(Illustration shaded for clarity)
Contact Vaddio Technical Support if you have questions or encounter any problems. Phone 800.572.2011 /
+1.763.971.4400, email av.vaddio.support@legrand.com.
Installing CeilingMIC Conference Room Microphones
5
Basic Connections
This is a simple installation for a small conference room, using the CeilingMIC with a ConferenceSHOT AV
system. In this installation, the CeilingMIC connects to a ConferenceSHOT AV camera with speaker. The camera
connects to a computer over a USB 3 connection, making audio and video available to soft conferencing
applications.
Installing CeilingMIC Conference Room Microphones
6
This installation is for a larger room, using an AV Bridge MATRIX PRO to manage the room audio and video. The
four CeilingMIC microphones connect directly to EasyMIC ports on the AV Bridge MATRIX PRO. The speaker(s)
require an amplifier, as shown by the amplifier symbol in the diagram. This system can include multiple cameras.
Installing CeilingMIC Conference Room Microphones
7
Vaddio is a brand of Legrand AV Inc.· www.legrandav.com · Phone 800.572.2011 / +1.763.971.4400 · Fax
+1.763.971.4464 · Email av.vaddio.support@legrand.com·
Visit us at support.vaddio.com for firmware updates, specifications, drawings, manuals, technical support
information, and more.
©2019 Legrand AV Inc.
Vaddio is a registered trademark of Legrand AV Inc. All other brand names or marks are used for
identification purposes and are trademarks of their respective owners. All patents are protected under
existing designations. Other patents pending.
Commercial AV Brands Chief | Da-Lite | Middle Atlantic | Projecta | Vaddio