Vertiv SA2-003 User Manual
Displayed below is the user manual for SA2-003 by Vertiv which is a product in the Network Equipment Chassis category. This manual has pages.
Related Manuals
GEIST™ SWITCHAIR
AIRFLOW MANAGEMENT DEVICE
Quick Installation Guide
VM1179/590-2243-501A 1
Models:
SA2-003
Switch Type:
Side Air Intake - Side Exhaust 2U
Switches
CAUTION: Ensure the required
airflow for safe operation of
equipment is not compromised
when installing the Geist SwitchAir
device.
WARNING: Take precaution to
avoid interference with the switch’s
input power cords when installing
behind a live switch.
1. Installing the airflow
channel
NOTE: The following
instructions install the SwitchAir
SA1-02005 device to move air
along the left side of the rack.
For right-side airflow, rotate the
channel and SwitchAir device
180˚and install them using the
same procedure.
Using customer-provided
hardware, insert the cage nuts
into the four holes on the front
of the channel.
Select a 2U space in the rack.
With the channel facing the
centerline of the rack, hold the
channel on the inside of the left
rack upright. Fasten in place
using screws only in the top and
bottom holes of the 2U space.
2. Installing the wiper
Attach the SwitchAir wiper
using the provided screws.
Orient the wiper with the tab
facing away from the centerline
of the switch.
3. Installing the switch
Slide the network switch into
the rack’s 2U space at the
installed channel’s height. Using
customer-provided cage nuts
and screws, mount the switch
to the rear rack uprights.
Geist SwitchAir Airflow Management Device
Geist SwitchAir Rack Rail Installation
Wiper
Wiper tab
Geist SwitchAir Wiper Installation
1
2
Left front
rack upright
Airflow
channel
Top and bottom
screws of 2U space
CENTERLINE
OF RACK
CENTERLINE
OF DEVICE
Cage nuts x4
To contact Vertiv Technical Support: visit www.VertivCo.com
© 2019 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names,
trademarks or registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co. assumes no
responsibility, and disclaims all liability, for damages resulting from use of this information or for any errors or omissions. Specifications are subject to change without notice.
GEIST™ SWITCHAIR AIRFLOW MANAGEMENT DEVICE
Quick Installation Guide
2 VM1179/590-2243-501A
4. Installing the SwitchAir
device into the rack
NOTE: Connect to power
before attaching the SwitchAir
device to the rack. (The
SwitchAir has a standard C14
power inlet. Due to the variety
of possible power source outlet
types, an appropriate power
cord type must be determined
and supplied by the customer.)
Insert the SwitchAir device into
the open rack space at the
same 2U height as the switch.
As the SwitchAir device is
inserted into the space, the
wiper tab acts as a guide to
deflect the wiper past the
switch’s corner and along it’s
side.
Once the SwitchAir device is
fully seated, install the
mounting screws to fasten the
unit to the front rack uprights.
Airflow Airflow
SwitchAir
Switch
3
4
Geist SwitchAir Rack Installation Complete
Geist SwitchAir and Network Switch Installation
Front upright
Rear upright
Airflow channel