Whirlpool ART 364/A+/6 User Manual
Displayed below is the user manual for ART 364/A+/6 by Whirlpool which is a product in the Fridge-Freezers category. This manual has pages.
Related Manuals
Gebrauchsanweisung
Instructions for use
Mode d’emploi
Gebruiksaanwijzing
Istruzioni per l’uso
Brugsanvisning
Bruksanvisning
Käyttöohje
Manual de utilização
Instrucciones para el uso
Instrukcje użytkowania
Használati utasítás
ИнструкциЯ за употреба
Návod k použití
Návod na použitie
Instruc∑iuni de utilizare
Инструкции по эксплуатации
3
DEUTSCH Gebrauchsanweisung Seite 4
ENGLISH Instructions for use Page 10
FRANÇAIS Mode d’emploi Page 16
NEDERLANDS Gebruiksaanwijzing Pagina 22
ESPAÑOL Instrucciones para el uso Página 28
PORTUGUÊS Manual de utilização Página 34
ITALIANO Istruzioni per l’uso Pagina 40
ΕΛΛΑΣ Οδηγίες χρήοης Σελίδα 46
Always unplug the refrigerator before replacing any light bulbs, then follow the relevant instructions
in accordance with the type of lighting fitted in your appliance.
Only use bulbs of the same type, which can be requested from the After-Sales Service and
authorised dealers.
Lighting type 1)
1. Loosen the screws and take off the lamp cover.
2. The lamp has a bayonet bulb and needs to be pulled
out, not unscrewed, following the directions of the arrows
as indicated.
3. After the new bulb has been inserted, replace the
lamp cover and wait five minutes before plugging the
appliance back in.
Lighting type 2)
To remove the light bulb, turn anticlockwise as shown in the
figure. Wait for 5 minutes before reconnecting the appliance.
Lighting type 3)
If the product has LED lighting which is in need
of replacing, contact the After-Sales Service for
assistance.
LED lights last longer than normal bulbs, they
illuminate better and are more environmentally
friendly
10
Clean the appliance regularly using a cloth and a solution of
lukewarm water and neutral detergent specifically formulated for
refrigerator interiors. Never use abrasive detergents. Clean inside
the defrost water drain outlet on the rear wall of the refrigerator
(near the fruit and vegetable crisper drawer) regularly, using the
tool supplied with the appliance so as to ensure defrost water is
removed correctly (see figure).
Before all cleaning or maintenance procedures, unplug the
appliance from the mains or disconnect the electricity supply.
2
1
Connect the appliance to the mains power supply.
A beep may be emitted by some models, to indicate that the temperature alarm has intervened:
press and hold the button to switch off acoustic alarms. As applicable, insert the anti-bacterial/
anti-odour filter into the fan as indicated on the filter package.
Note: after switching on, the refrigerator needs approximately 4/5 hours to reach the correct
temperature for storing a normal fridge load of food.
FIRST USE
APPLIANCE MAINTENANCE
AND CLEANING
CHANGING THE BULB OR LED (depending on the model)
11
Unplug the appliance from the mains, then empty, defrost (if necessary) and clean it. Leave the
doors ajar, so that air can circulate inside the compartments. This will prevent the formation of
mould and bad odours.
WHEN THE APPLIANCE IS NOT IN USE
Keep the doors closed to allow the stored food to stay cold as long as possible. Do not refreeze
partially thawed food. If the blackout persists, the blackout alarm may sound (depending on the
model).
DURING BLACKOUTS
The refrigerator compartment is designed for the storage of fresh food and beverages.
Refrigerator compartment defrosting is completely automatic.
Droplets of water on the rear wall of the compartment indicate that the periodic automatic defrost
cycle is in progress. The defrost water is automatically routed to a drain outlet and into a container
from which it evaporates.
Depending on the model, the appliance may have a special box (“Meat & Fish” or “Zero Degrees”)
which is ideal for the storage of fresh meat and fish.
Important: refrigerator accessories must not be washed in a dishwasher.
Note: the ambient temperature, the door opening frequency and the position of the appliance may
affect temperatures inside the two compartments. Set the temperature in accordance with these
factors.
Note: when there is a lot of moisture inside the refrigerator compartment and on the glass
shelves in particular, condensation may form. In this case, we recommend closing any liquid-
filled containers (e.g.: saucepans full of stock), wrapping foods with a high liquid content
(e.g.: vegetables) and setting the temperature to a warmer value.
Removing the crisper drawer (depending on the model)
If your product only has a crisper drawer, to facilitate its removal we recommend emptying
(and, if necessary, removing) the two lower door trays beforehand.
Fan and anti-bacterial/anti-odour filter (depending on the model)
The fan will ensure uniform air circulation inside the compartment, for improved food storage and
excess moisture reduction. Do not obstruct the fan inlet. The fan can be activated/deactivated
manually (see Quick Start Guide); when activated, it works automatically as necessary.
REFRIGERATOR COMPARTMENT
The freezer compartment stores frozen food (for the period indicated on the package)
and freezes fresh food. The amount of fresh food that can be frozen in 24 hours is shown on the
rating plate; place the food in the freezer compartment (see Quick Start Guide), leaving leaving
enough space around the packages to allow air to circulate. Refreezing partially thawed food is not
recommended. It is important to wrap food so that no water, moisture, or vapour may penetrate.
To save energy and prolong the life of the appliance, make sure hot foods are never placed inside it.
Note: the ambient temperature, door opening frequency and position of the appliance can affect
the temperatures inside the two compartments. Set the temperature based on these factors.
Making ice cubes
Fill the ice cube tray (where provided) 2/3 full and place it in the freezer compartment. Never use
sharp or pointed objects to remove the ice.
Removing drawers (depending on model)
Pull the drawers all the way out, lift them up a little and remove. To create more space, the freezer
compartment can also be used as follows:
A) If the freezer compartment base resembles figure A, remove
the upper drawers and/or lids. The lower drawer should be left in
position. Make sure that, once the food has been placed on the
racks/shelves, the door closes properly.
B) If the freezer compartment base resembles figure B, remove all
drawers or lids. Make sure that, once the food has been placed on
the racks/shelves, the door closes properly.
Removing the lid (if present)
Open the lid and remove the pin, as illustrated in figure C.
12
No Frost models do not need defrosting.
For other models, if frost forms in the freezer compartment, we
recommend it is defrosted twice a year or whenever an excessive
amount of frost has formed (3 mm thickness).
It is perfectly normal for frost to form.
The amount of frost which forms and the rate at which it builds
up depends on room temperature and humidity, and on how
often the door is opened. To defrost, unplug the appliance and
remove all foodstuffs. Leave the door ajar to allow the frost to melt.
For products with a freezer compartment below the refrigerator
compartment, the defrost water drain pipe can be removed (see
figure) and a recipient placed underneath.
After defrosting, replace the drain pipe, making sure that no water is
left in it. Clean inside the freezer compartment and dry carefully.
Switch the appliance back on and place the food back inside.
DEFROSTING THE FREEZER
COMPARTMENT (depending on the model)
FREEZER COMPARTMENT
A
B
C
13
The Meat & Fish box was designed specially to keep foods fresher
for longer, without altering nutritional values or original freshness.
Do not store fruit or vegetables in this box, as the temperature may
drop below 0°C, causing water contained in the food to freeze.
Temperature Adjustment
The temperature inside the Meat & Fish box is indicated by the
position of the arm on the door of the box, and depends on the
general temperature of the refrigerator compartment.
We recommend setting the temperature of the refrigerator compartment between +2° and +6°.
To work out if the temperature inside the Meat & Fish box is correct, refer to the pictures below:
Important: when the function is activated and foods with a high water content are present,
condensation may form on the shelves. In this case, disable the function temporarily.
Removing the Meat & Fish compartment:
To ensure correct operation of the product, adequate preservation
of food and to optimise energy consumption, it is advisable not to
remove the Meat & Fish compartment if the symbol (see Quick
Guide) is not present on the control panel. In all other cases, the
Meat & Fish compartment can be removed to obtain more space
inside the refrigerator.
Proceed as follows:
1. Remove the compartment drawer (Figure 1).
2. Remove the drawer cover by releasing the bottom side clips
(Figure 2).
To reinstate the Meat & Fish compartment, make sure to refit the
drawer cover before inserting the drawer and reactivating operation.
3. Press the “Meat & Fish compartment function” button on the
control panel for 3 seconds, until the yellow indicator goes off.
To optimise energy consumption, it is advisable to deactivate the
Meat & Fish compartment and remove its components (except the
shelf above the crisper drawers).
MEAT & FISH BOX (depending on model)
When the arm points to the left, you need
to raise the temperature in the refrigerator
compartment.
When the arm is in the middle, the
temperature is ok.
When the arm points to the right, you
need to lower the temperature in the
refrigerator compartment.
Fig. 1
Fig. 2
14
The “Zero Degrees” box is specifically designed to
maintain a low temperature and a suitable humidity level,
in order to keep foods fresher for longer (e.g. meat, fish,
fruit and winter vegetables).
Activating and deactivating the box
The temperature inside the box, when active, is approximately 0°.
To activate the compartment, press the button
shown in the figure for more than 1 second,
until the symbol lights up
The symbol lit indicates that the compartment is
functioning. Press the button again for more
than 1 second to deactivate the compartment
The following factors are vital for the “Zero Degrees” box to work properly:
- the refrigerator compartment must be switched on
- the temperature of the refrigerator compartment must be between +2°C and +6°C
- the box must be inserted to enable activation
- no special functions, such as Standby, Cooling-Off, Vacation, that disable the product or
the refrigerator compartment are selected.
If one of these special functions has been selected, the “Zero Degrees” box must be deactivated
manually, and any fresh food inside it removed.
Note:
- if the symbol does not light up when the box is activated, check that the box is properly inserted;
if the problem persists, contact your nearest authorized After-sales Service
- if the box is active and the drawer open, the symbol on the control panel may be deactivated
automatically. If the drawer is inserted, the symbol will become active again
- irrespective of the state of the box, a slight noise may be heard: this is normal and is not a cause
for concern.
- when the box is not active, the temperature inside it depends on the general temperature inside
the refrigerator compartment. In this case, we recommend it is used to store fruit and vegetables
which are not sensitive to cold temperatures (fruits of the forest, apples, apricots, carrots,
spinach, lettuce, etc.).
Important: If the function is activated and food with high water content is present, condensate
may form on the shelves. In this case, temporarily deactivate the function.
When placing small containers and food products on the top shelf of the “zero degrees”
compartment, make sure they do not accidentally fall between the drawer and the back of the
refrigerator compartment.
Removing the “Zero Degrees” box:
The “Zero Degrees” box can be removed to create more space inside the refrigerator. In this
case proceed as follows:
- to facilitate removal, we recommend emptying (and if necessary, removing) the two lower door trays
- switch off the box
- pull out the drawer and the white plastic shelf underneath the box.
“ZERO DEGREES” BOX (depending on the model)
15
Before contacting the After-Sales Service:
Switch the appliance on again to see if the
problem has been solved. If it has not, unplug
the appliance and wait for about an hour before
switching on again.
If the appliance is still not working after you
have gone through all the checks listed in the
troubleshooting guide and switched it off then
on again, contact the After-Sales Service to
explain the problem and have the following
information ready:
• thetypeoffault
• themodel
• thetypeandserialnumberoftheappliance
(given on the rating plate)
• theServicenumber(thenumberafterthe
word SERVICE on the rating plate inside the
appliance)
Note:
the door opening direction can be
changed. If this operation is performed by
the After-Sales Service it is not covered by
the warranty.
AFTER-SALES SERVICE
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A
13amp fused plug, to change a fuse in this type of plug use an
A.S.T.A. approved fuse to BS 1362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse
and if the fuse cover is lost the plug must not be used until
a correct replacement is fitted. Correct replacement are
identified by the colour insert or the colour embossed in
words on the base of the plug. Replacement fuse covers are
available from your local electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but a third type of plug and
socket is also used, the 2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact After-sales Service for further
instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out
by a qualified technician in compliance with the manufactures instructions and current standard
safety regulations.
ELECTRICAL CONNECTION FOR GREAT
BRITAIN AND IRELAND ONLY
Note: the upper shelf and the side supports cannot be removed.
To restore “Zero Degrees” box operation, make sure you replace the white plastic shelf
underneath the box before inserting the drawer and reactivating the function. To optimise energy
consumption, we recommend you deactivate the “Zero Degrees” box and remove it.
Clean the box and all its parts regularly, using a cloth and a solution of warm water and neutral
detergent specifically formulated for refrigerator interiors (take care not to immerse the white
plastic shelf underneath the box in water).
Before cleaning the box (including the outside), remove the drawer so as to disconnect
the box from the electricity supply.
Never use abrasive detergents.
5019 608 02160 ESNL
GB FR GR
PT IT
DE 07/11