Bouncepad Caddy User Manual
Displayed below is the user manual for Caddy by Bouncepad which is a product in the Tablet Security Enclosures category. This manual has pages.
Related Manuals
Sheet Code: BP-IM-070_REV2_Combined
Release Date: 18/05/2022
Copyright 2020 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Condential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
CADDY
Assembly Instructions
Tools Required to Fix From Below:
Unless specied, instructions are
for both Eddy and Click stands.
Drill
Pencil
5mm Drill Bit
Fixings List
* Due to the modular nature of
our product range you may receive
additional xings in the xings kit
4x M4
wing nut
4x M4 split
washer
4x M4 at
washer
1x tie 4x clips
Fixings Kit
1x Caddy
2x 80mm
grub screw
4x M4
buttonhead
screw
In the Caddy Box
1x Drilling
Template
T20 torx
allen key
Insert the tie through the grill and
then clasp over the device.
2Insert the cable management clips
into the grill, then twist to secure.
3 4 Feed your Eddy/Click charge cable
through the channel.
1Complete separate Eddy
or Click manuals until
steps shown above.
65 Additonal devices are connected
by repeating step 2.
Wrap the charge cable around the
clips and plug into the power source.
tie
clip
full list of
supported devices
available at
bouncepad.com
USB hub or battery pack
7
Basic setup is now complete. To add
security features follow steps 7 onwards.
* Keep sucient slack
to allow Eddy/Click to
rotate freely.
full list of
supported devices
available at
bouncepad.com
receipt printer
card reader
Eddy manual
Step 6
Click manual
Steps A2+C1
Lift up the Eddy Stand and remove
bungs and OUTER half-bungs from
Caddy.
bung
half-bung
Eddy Only
Screw M4 80mm grubscrews into
Caddy until nger tight.
11
9 10 9
Attach 4x M4 buttonhead screws
through the tray and into the stand.
Attach 2x M4 buttonhead screws
through the tray and into the stand.
Lift up the Click Stand and remove
the INNER half-bungs from Caddy.
M4
Buttonhead
Screw
M4
Buttonhead
Screw
80mm
Grubscrew
T20 Pin Torx
Allen Key
T20 Pin Torx
Allen Key
T20 Pin Torx
Allen Key
half-bung
Attach illustrated washers and tighten wingnuts by hand.
Caddy is now securely attached to your surface.
15
Use a hand drill with 5mm bit to
make holes through your surface.
13
power drill
14 Insert the assembled product through
the pilot holes.
12 Place the drilling template over the
surface and mark the holes with a
pencil.
pencil
drilling template
M4 at washer
M4 split washer
M4 wing nut
Eddy Only Click OnlyClick Only
Assembly
Complete