Candy CBT6130/2N-07 User Manual
Displayed below is the user manual for CBT6130/2N-07 by Candy which is a product in the Cooker Hoods category. This manual has pages.
Related Manuals
CBT6130/2W-07
CBT6130/2N-07
CBT6020/2X-07
Instruction manual
1
CONTENT
1………………………………………. Introduction
2………………………………………. Safety precaution
3……………………………………….. Installation instructions
4……………………………………….. Operation
5…………………………………………Use and maintenance
6 …………………………………………Trouble shooting
7…………………………………………Environmental protection
2
INTRODUCTION
Thank you for choosing this cooker hood.
This instruction manual is designed to
provide you with all required instructions
related to the installation, use and
maintenance of the appliance. In order to
operate the unit correctly and safety, please
read this instruction manual carefully before
installation and usage.
SAFETY PRECAUTION
This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning use
of the appliance in a safe way and
understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not
be made by children without supervision
3
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
The instructions shall state the substance
of the following:
– there shall be adequate ventilation of
the room when the range hood is used at
the same time as appliances burning gas
or other fuels (not applicable to
appliances that only discharge the air
back into the room);
– the details concerning the method and
frequency of cleaning;
– there is a fire risk if cleaning is not
carried out in accordance with the
instructions;
– do not flambé under the range hood;
– CAUTION: Accessible parts may
become hot when used with cooking
appliances.
4
The installation instructions shall include
the substance of the following:
– the air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other fuels
(not applicable to appliances that only
discharge the air back into the room);
– the minimum distance between the
supporting surface for the cooking vessels
on the hob and the lowest part of the
range hood. (When the range hood is
located above a gas appliance, this
distance shall be at least 65 cm.
– regulations concerning the discharge of
air have to be fulfilled.
The installation instructions for range
hoods with accessible metallic enclosures
of class II construction shall include
details that indicate the location and
maximum permitted lengths for any fixing
or mounting screw or other fixing device
that penetrates into the range hood to
5
attach an accessory such as a facia or
duct fitting.
Where fixing or mounting screws, or other
fixing devices are used, that penetrate
into the range hood with an accessible
metallic enclosure of class II construction,
to attach an accessory, the instructions
shall indicate the required location of
these screws or fixing devices and include
the substance of the following warning.
Warning: Failure to install the screws or
fixing device in accordance with these
instructions may result in electrical
hazards
For safety reason, please use only the
same size of fixing or mounting screw
which are recommended in this instruction
manual.
Warning: Failure to install the screws or
fixing device in accordance with these
instructions may result in electrical
hazards
6
Regarding the instructions method of
fixing for the fixed appliance and how the
appliance is to be fixed to its support,
thanks to refer to the section
“INSTALLATION AND FIXING”.
Regarding the instructions for the bulb
changing, thanks to refer to the section
“light changing”. ILCOS D code for this
lamp is: IBB/C-40-230-E14-35
3. Installation instructions
The cooker hoods should be placed at a distance of 65-75cm from the
cooking surface for best effect. （See Pic 1）
65cm
75cm
Pic 1
Way one: (See Pic 2A)
4.1.1 To install onto the wall drill 4 holes of Ø8mm on a suitable place
according with the centre distance of hole in the back of the cooker
hood.
7
4.1.2 Insert the wall plugs into the holes.
4.1.3 Insert the screws into the wall pulgs and tight the screws.
4.1.4 Put up the cooker hood onto the fixed screws.
4.1.5 Put the one air outlet and extensible pipe onto the cooker hood. (the
extensible pipe is optional not supplied)
Way two: (See Pic 2B)
4.2.1 Drill 6 holes of 4mm diameter at the bottom of the hanging cupboard
4.2.2 Put the air outlet on the cooker hood, then install the cooker hood on
the bottom of the cupboard, tighten the hood with enclosed 6 screws.
4.3.3 Install the adjusted board on the bottom of the hood in order to keep
out the gap between hood back and cupboard.
8
For safety reason, please use only the
same size of fixing or mounting screw
which are recommended in this instruction
manual.
Warning: Failure to install the screws or
fixing device in accordance with these
instructions may result in electrical
hazards
4. OPERATION
5.1 Connect the plug into the power.
5.2 Push the switch ① into “ ”, the lamp be on; push into “0”, the lamp
be off.
5.3 Push the switch ② into “I、II”, the motor will be on “low、high” two
speeds, push into “0”, the motor will be off.
5.4 The cooker hood will working at low or high speed when pull out the
front panel.
9
5. USE AND MAINTENANCE
It is recommended to operate the appliance prior to cooking.
There shall be adequate ventilation of the room when the cooker hood is
used at the same time as appliances burning gas or other fuels(not
applicable to appliances that only discharge the air back into the room.
It is recommended to leave the appliance in operation for 15 minutes
after cooking is terminated in order to completely eliminate cooking
vapours and odours.
If the appliance is not used, please turn off.
Don’t have flame under the cooker hood.
Don’t use or stop use if the appliance is damaged especially the supply
cord and the case.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
Don’t immerse the appliance in liquid.
The exhaust air must not be discharge into a flue which is used for
10
exhausting fumes from appliance burning gas or other fuels.
Regulations concerning the discharge of air have to be fulfilled.
The details concerning the method and frequency of cleaning.
In order to prevent fire hazard, it is recommendable to clean the filter at a
maximum of 2 months by carrying out the followings:
-Unplug before cleaning, then remove the filters from the cooker hood
and wash them in a solution of water and neutral liquid detergent,
leaving to soak.
-Rinse thoroughly with warm water and leave to dry.
-The filters may also be washed in the dishwasher.
The aluminum panels may alter in color after several washes. This is not
cause for customer complaint nor replacement of panels.
Clean the surface of the cooker hood regularly using cloth moistened
with denatured alcohol of non abrasive liquid detergent. (Remark: There
can not clear the motor and inside part.)
Replace filters approximately every 4 months.
There is a fire risk if cleaning is not carried out in accordance with the
11
instruction.
Replace the lamp pls see pic 5
ILCOS D code for this lamp is: IBB/C-40-230-E14-35
Carbon filter (not supplied)
Carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed at three or six months according to your cooking habit.
Activated carbon filter cannot be washed or recycled. The installation
procedure of activated carbon filter is as below.
-Slide the front part of the cooker hood.
- In order to install the activated carbon filter, the Al anti-grease filter should
be detached first. Press the lock and pull it downward.
- Put the activated carbon filter into the unit and turn it in anti-clockwise
direction. Repeat the same on the other side. Put back to the grease filter in
position.
Note: When the activated carbon filter installed, the suction power will be
lowered.
12
6. Trouble shooting
Problem
Possible cause
Solution
The extractor fan ceases to
function.
The kitchen hood feed cable is
not connected to the network.
There is no electrical current in
the network.
Connect feed cable to the
network.
Check that the network has
electrical current.
Insufficient suction power.
Did not set to the right speed
and/or air outlet being blocked.
If the kitchen hood is set up for
recirculation, check that the
charcoal filter is still effective.
If the kitchen hood is set up for
extraction, check that the ducting
and outlets are not blocked.
The kitchen is adequately vented
to allow the entry of fresh air.
Hood has switched off
during operation.
The safety cut-out device has
been tripped.
Turn off the hood and then wait
for the device to reset.
If the hood has been installed
below the heights indicated in the
installation instructions, the
motor will cut-out frequently
which may damage the hood.
The lamps do not light up.
The lamps are burnt out.
The lamps are loose.
Change the lamps.
Tighten the lamps.
Oil leakage.
One-way valve and air
ventilation entrance not tightly
sealed.
Leakage from the connection
of U-shaped section and cover.
Seal with glue on the one-way
valve.
Seal with soap or paint on
U-shaped section.
Hood shakes during
operation.
Leaf is damage.
The body or motor tightly
hung.
Replace the leaf as a damaged
leaf causes shaking.
Lock the motor tightly or fix the
body tightly, respectively.
13
7.ENVIRONMENTAL PROTECTION:
This product is marked with the symbol on the selective sorting of
waste electronic equipment. This means that this product must not be
disposed of with household waste but must be supported by a system
of selective collection in accordance with Directive 2002/96/EC. It
will then be recycled or dismantled to minimize impacts on the environment,
electrical and electronic products are potentially dangerous for the
environment and human health due to the presence of hazardous
substances.
For more information, please contact your local or regional authorities.
Note：
a. In order to reduce the environmental impact (e.g. energy use) of the cooking
process, please be sure that your product is installed according to the user
manual, keep the operation place ventilated, keep the extraction duct be
direct and short as possible as it can be.
b. For the product with manual operation mode, we suggest switch the motor
off within 10 minutes after finishing the cooking process.
c. Please be sure to dismantle related components according to the user
manual when maintaining for non-destructive, protect the parts to make the
re-installed work can be favoring and avoid damage.