Chief FSB75100B User Manual
Displayed below is the user manual for FSB75100B by Chief which is a product in the Mounting Kits category. This manual has pages.
Related Manuals
Milestone AV Tec hnol ogie s, and its affiliated corpo rat ions and subsidiaries (collectiv el y, "Miles tone"), intend to mak e th is ma nual accurate an d compl ete. However, Mi lestone mak es
no claim that the information con tained herein co vers all deta ils, con ditions or variations, nor does it provide for every possible conti ngency in connection with the i nstallation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty , expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility fo r accuracy, completeness or suffici ency of the information contained in this document.
Chief, a products division of Milestone AV Technologies
6436 City West Parkway, Eden Prairie, MN 55344
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
8800-0 02 66 6 R ev 00
©2014 Milestone AV Technologies
12/14
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE
PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY
AND DAMAGE TO EQUIPMENT! DO NOT over tighte n screws
when installing mount ing buttons.
Flush Mount Display Inter fa ce Installation
1. Place display face down on a clean dry surface.
2. Assembl e mounting but tons (A) to display usi ng four M4 x 20mm
(D) Phillips pan head screws. (See Figure 1)
Figure 1
Recesse d Moun t Display Interface Instal lation
1. Align and place four spacers (B or C) over mounting holes in
display back. (See Figure 2)
2. Place mounting buttons (A) over four spacers (B or C). (See
Figure 2)
3. Assemble mounting buttons (A) to display using four M4 x 25mm
(E) or four M4 x 30mm (F) Phillips pan head screws through
spacers. (See Figure 2)
Figure 2
Chief® is a registered trademark of Milestone AV Technologies. All
rights reserved.
2
(D) x 4
(A)
3
(E or F) x 4
(B or C) x 4
(A)
FSB-75100
Small Display Interface Kit
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
TOOLS REQUIRED FOR INSTALLATION / PARTS
B (4)
3/4" x 1/4" C (4)
3/4" x 1/2"
D (4)
M4 x 20mm E (4)
M4 x 25mm
F (4)
M4 x 30mm
A (4)
[Mounting buttons]