Chief HB92C User Manual
Displayed below is the user manual for HB92C by Chief which is a product in the Projector Mount Accessories category. This manual has pages.
Related Manuals
HB92C
VIDEO PROJECTOR CEILING MOUNT
FOR CHRISTIE DIGITAL EASY RIDER,
The Christie HB92C custom video projector ceiling mount is designed to provide fast, simple and secure installation.
Special roll, pitch, yaw and horizontal adjustments simplify projection positioning for image alignment. The HB92C
mount also has positive registration lock so the projector may be removed without losing projector mount
registration.
Unpack and check contents:
(1) Deluxe ceiling mount assembly (8) M12 Flat washers
(1) Custom mounting bracket (8) M12 X 20mm hex bolts
(4) 5/16” flange nuts
INSTALLATION INSTRUCTIONS
1. Turn your projector upside down.
2. Place the custom mounting bracket on the projector so the small triangle in the bracket is toward the front of the
projector and all eight holes in the custom bracket align with the eight mounting inserts in the bottom of your
projector.
3. Place (1) M12 flat washer on each of the (8) M12 X 20mm bolts, starting them all by hand and secure them using
the proper size wrench. Using the proper wrench, securely tighten all eight mounting bolts at this time.
WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL
INJURY! All components must be securely fastened to each other and to the ceiling, AND
the ceiling MUST be capable of supporting 5 times the total weight of the installation. If it
cannot, the ceiling MUST be reinforced.
4. Be sure the method of support you are using for the VCM ceiling mount is securely installed to the ceiling. If not,
the ceiling must be reinforced. Improper installation may result in serious personal injury.
5. Attach the VCM housing to your method of support and tighten firmly so the VCM housing is square to the
screen.
WARNING: Installing a ceiling mount requires the presence of two persons familiar with
mechanical installations. A third assistant is recommended
6. With the help of your one or two assistants, lift the projector and install it on the studs extending from the
mounting plate. Make sure the custom mounting plate is seated in the slots and Tighten securely using the
four 5/16” flange nuts.
For projector alignment see attached sheet.
8803-000063 02/05