Chief ROTR-11 User Manual
Displayed below is the user manual for ROTR-11 by Chief which is a product in the Rack Cabinets category. This manual has pages.
Related Manuals
INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
POTR
ROTR
Pull Out and Rotating Rack
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
POTR / ROTR
POTR / ROTR Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of all
components located within the rack does not exceed 300 lbs
(136.1 kg). Use with products heavier than the maximum
weight indicated may result in instability or collapse of the rack
causing possible injury.
IMPORTANT ! : Minimum spacings between the Accessories
and components and the (ITC/AV) Rack Enclosure shall be
maintained for safe operation of the equipment when installed
in accordance with the National Electric Code, ANSI/NFPA 70-
2008. Operating temperature inside rack shall not exceed
104°F.
--SAVE THESE INSTRUCTIONS--
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
Installation Instructions POTR / ROTR
3
DIMENSIONS
"A"
3.39
86.2
BASE HEIGHT
ROTR
DIMENSIONS: INCHES
[MILLIMETERS]
2.51
63.6
BASE HEIGHT
"A"
POTR
DIMENSIONS: INCHES
[MILLIMETERS]
POTR / ROTR Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
7/16"
A (1)
B (6)
C (6)
1/4-20 x 1/2"
1/4-20
NOTE: Items B, C and D
D (2)
[Rack rail]
are already attached to ROTR and
POTR in Models ROTR8, ROTR9,
ROTR10, ROTR11, POTR8, POTR9,
[ROTR]
A (1)
[POTR]
OR
POTR10, and POTR11.
Installation Instructions POTR / ROTR
5
ASSEMBLY
NOTE: Proceed to Step 2 if assembling Models POTR/
ROTR8,-9,-10 or -11.
1. Attach rack rails (D) to POTR/ROTR using three 1/4-20 x 1/2"
pem studs (C) and three 1/4-20 lock nuts (B) for each rack rail.
(See Figure 1)
NOTE: Leave the hardware loose until all three fasteners on
one rack rail have been installed, then tighten.
Figure 1
2. Remove and SAVE two screws from POTR/ROTR front and
remove the cover plate. (See Figure 2)
Figure 2
3. Attach POTR/ROTR base to floor of cabinet or to a pedestal
or stand using 1/4-20 bolts (not included) through the base.
(See Figure 3)
4. The POTR/ROTR may now slide back and forth on the
base.
5. Proceed to Completing Installation section.
Figure 3
ROTR Only
1. Unlock the thumbscrew in the ROTR front. (See Figure 4)
2. Pull out and swivel the ROTR as needed to gain access to
the back.
3. Swivel ROTR to front and tighten thumbscrew to keep from
swiveling. (See Figure 4)
Figure 4
1
(B) x 6
(C)
(D)
x 6
(ROTR shown as example)
2
x 2
Cover plate
(ROTR shown as example)
Mounting
holes
Mounting
holes
3
3
3
3
1
2
POTR / ROTR Installation Instructions
6
COMPLETING INSTALLATION
1. Close the POTR/ROTR. (See Figure 5)
2. Replace cover plate. (See Figure 5)
3. Attach cover plate to POTR/ROTR with two fasteners
removed in earlier step. (See Figure 5)
IMPORTANT ! : Ensure that fasteners fit through cover
plate and into front of base.
Figure 5
1
2
3
x 2
Front of
base
Installation Instructions POTR / ROTR
7
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P800.582.6480 / 952.225.6000
F877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P+31 (0) 495 580 852
F+31 (0) 495 580 845
Asia Pacific A Office No. 918 on 9/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P852 2145 4099
F852 2145 4477
POTR / ROTR Installation Instructions
Chief, a products division of
Milestone AV Technologies
8800-002295 Rev01
2016 Milestone AV Technologies
www.chiefmfg.com
03/16