Chief SLB304 User Manual
Displayed below is the user manual for SLB304 by Chief which is a product in the Projector Mount Accessories category. This manual has pages.
Related Manuals
8800-0 02 23 9 R ev 00
©2012 Mile stone AV Technologies,
a Duchossois Group Company
08/12
Milestone AV T ec hnol ogie s, and its affi liated corporat ions a nd subsidiaries (c ol lectiv el y, "Milestone"), i ntend to make this manual ac cu rat e an d compl ete. However, Mi lestone makes
no claim that the in for mation containe d h erein co vers all details, con ditions or variatio ns, nor does it pro vide for ev ery possible contingency in connection with the i nsta llation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expr essed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
6436 City West Parkway, Eden Prairie, MN 55344
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
INSTALLATION INSTRUCTIONS
SLB-304 and SLM-304 Interface Brackets
SLB-304 and SLM-304 Interface Br ackets are desi gned for u se with Chief® Series Projector Mounts. S ee the spec ific installation instructions
provided with the mount for additional installation information.
Unpack c arton and veri fy kit contents. If any listed parts are missing, im mediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB interface bracket. If an SLM bracket is being installed, proceed to Step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place spacers over threaded inserts in bottom of projector.
4. Place the interface bracket onto the spacers on the bottom of the projector, aligning the mounting holes in the bracket with the spacers
and threaded inserts in the bottom of the projector and ensuring that triangle in bracket points towards front of projector.
5. Position M5 x 25mm mounting screws through the bracket, spacers and into the threaded inserts. Tighten all fasteners at this time,
securing the bracket to the projector.
NOTE: Security s cr ews can b e subs titu ted wh en mounti ng In terfa ce bracke t to proje ctor by u sin g the part s an d insta llat ion in struct ions i n the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (3) Screw, Phillips Flat Head, Machine, M5 x 25mm
(4) 10-24 Thumb Nuts ** (3) Spacer, .5 x .257 x .625
(1) All-Points Security Kit (1) 5/32" Security Hex Key
SLB-304 SLM-304
Towards front
of projector
Towards front
of proje ctor