Chief SLM215 User Manual
Displayed below is the user manual for SLM215 by Chief which is a product in the Projector Accessories category. This manual has pages.
Related Manuals
INSTALLATION INSTRUCTIONS
Milestone AV Technolo gies, Inc., and its affiliated corporati ons and subs idiaries ( collectively, "Milest one"), i ntend to mak e this manual a ccurate and complet e. However, Mileston e
makes no claim that the information co ntai ned herein co vers all details, c onditions or variations , nor does it prov ide for every pos sible contingenc y in connection with the i nsta llation
or u se of thi s product . The i nformati on contai ned in t his doc ument is s ubje ct to change withou t noti ce or obl igation of any k ind. Miles tone m akes no r eprese ntation of warran ty, ex-
press ed or implied, regar ding the information conta ined herei n. Milestone assume s no respo nsibility for accuracy, completenes s or sufficiency of t he information contai ned in th is
document.
© 2008 Chief Manufacturing, 8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-000145 Rev.A
3/17/08
SLB-215 and SLM-215 Interface Brackets
for Sharp XV-Z90U, Sharp Vision Theago DT-200
SLB and SLM series Interface brackets are designed for use with Chief RPA, RPM, and Smart-Lift series projector mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative by calling
1-800-582-6480.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation:
WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE P ART S AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB Interface bracket. If an SLM bracket is being installed proceed to step 2.
1. Screw four thumb screws onto four 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket o nto the bottom of the projector lining up the four mounting hole s in the bracket with the four threaded inserts
in the bottom of the projector.
4. Using the four M4 X 10mm mounting screws, start them into the mounting holes by hand and secure all four fasteners at this time.
NOTE: Securi ty scre ws can be s ubsti tuted whe n mount ing Inter face bra cket to projec tor by us ing the parts and installat ion ins truct ions i n the
All-Poi nts Security Kit.
(1) Interface Bracket (4) Washer, Flat, M4
( 4) 10- 24 Thumb Nu ts * * (4) Screw, Pan head, M4 x 10mm
(1) All-Poi nts Secu rity Kit
**Only used when installing SLB Interface brackets.
SLB-215
SLM-215
Towards front of
Towards front of
Projector
Projector