Chief SLM229 User Manual
Displayed below is the user manual for SLM229 by Chief which is a product in the Projector Accessories category. This manual has pages.
Related Manuals
INSTALLATION INSTRUCTIONS
Milestone AV Tec hnol ogie s, and its affiliated co rpo rat ions a nd subs idiaries (c ol lectiv el y, "Miles tone"), intend to make this ma nual ac cu rat e an d compl ete. However, Mi lestone makes
no claim that the in for mation con taine d h erein co vers all deta ils, con ditions or va ri atio ns, nor does i t provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone as sumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
© 2008 Chief Manufacturing, a divisio n of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000290
9/10/08
SLB-229 and SLM-229 Interfac e Brackets
SLB and SLM series Interface brackets are designed for use with Chief RPA, RPM, and Smart-Lift series projector mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representati ve by calling
1-800-582-6480.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation:
WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE P ART S AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB Interface bracket. If an SLM bracket is being installed proceed to step 2.
1. Screw four thumb screws onto four 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the three nylon spacers on the bottom of the projector, lining them up with the three threaded inserts in the bottom of the projector.
4. Place the interface bracket onto the spacers, lining up the three holes in the bracket with the three spacers and threaded inserts on the
bottom of the projector.
5. Us ing the three M4 x 20mm flat head mounting screws, start them into the mounting holes by hand and secure all three fastener s at this
time.
NOTE: Security scre ws can be s ubsti tuted whe n mount ing Inter face bra cket to projec tor by us ing the parts and install ation instruct io ns in th e
All-Poi nts Security Kit.
(1) Interface Bracket (3) Washer, Flat, M4
(4) 10-24 Thumb Nuts ** (3) Screw , Phillips Flat Head, M4 x 20mm
(1) All-Points Security Kit (3) Spacer, Nylon, .500 x .194 x .500
(1) Hex Key, 5/32"
**Only u sed wh en installi ng S LB Interface brackets.
SLB-229
SLM-229
Towards front
of projector Towards front
of proj ector