Chief SSB245 User Manual
Displayed below is the user manual for SSB245 by Chief which is a product in the Projector Mount Accessories category. This manual has pages.
Related Manuals
8802-002012 Rev01
©2009 Milestone AV Technologies,
a Duchossois Gr oup Company
www.chiefmfg.com
09/09
INSTALLATION INSTRUCTIONS
Milestone AV Tec hnol ogies, and its affiliated co rpo rat ions and subsidiaries (collectivel y, "Miles tone"), intend to mak e th is ma nual accurate and complete. However, Milestone mak es
no claim that the in for mation containe d h erein co vers all details, con ditions or variatio ns, nor does it pro vide for ev ery possible contingency in connection with the i nsta llation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
SSB-245, SSM-245, SLB-245 and SLM-245 Interface Brackets
SSB-245, SSM-245, SLB-245 and SLM-245 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack c arton and verify kit co ntents. If any listed parts are missing, im mediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM /SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. D O NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector, and align the three mounting holes in the bracket with the three threaded
inserts in the bottom of the projector.
4. Position the M4 x 8mm mounting screws and M4 flat washers through the bracket and into the threaded inserts. Tighten all fasteners at
this time, securing the bracket to the projector.
NOTE: Securi ty screws can be su bst ituted when m ount ing i nterface br ack et to projec tor by us ing the parts and inst al lation i nst ructions i n t he
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (3) Screw, Phillips Pan Head, Machine, M4 x 8mm
(4) 10-24 Thumb Nuts ** (3) Washer, Fl at, M4
(1) All-Points Security Kit (1) 5/32" Security Hex Key
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations above.
DO NOT attempt to substitute and USE ONLY this pre-installed hardw are for SSB-style and SSM-style interface bracket installation.
Towards
front of
projector Towards
front of
projector