Chief SSM058 User Manual
Displayed below is the user manual for SSM058 by Chief which is a product in the Projector Mount Accessories category. This manual has pages.
Related Manuals
INSTALLATION INSTRUCTIONS
Milestone AV Tec hnol ogie s, and its affiliated co rpo rat ions a nd subs idiaries (c ol lectiv el y, "Miles tone"), intend to make this ma nual ac cu rat e an d compl ete. However, Mi lestone makes
no claim that the in for mation con taine d h erein co vers all deta ils, con ditions or va ri atio ns, nor does i t provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone as sumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-0 0005 0 R ev 01
©2009 Mil eston e AV Technologies,
a Ducho ssois Group Comp any
05/09
SSB-058, SSM-058, SLB-058 and SLM-0 58 Interface Brackets
SSB -058 , S SM- 058 , SL B-0 58 and SLM-058 I nterface Bra cke ts a re desi gne d fo r us e wi th Chi ef® S erie s Pr ojector Mo unts . Se e t he s pecific install at ion
instructions provided with the mount for additional installation information. Unpack carton and verify kit contents. If any listed parts are missing,
immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto the 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the nylon spacers over the threaded inserts in the bottom of the projector (i.e., position them so the short one is on the raised surface and
the other two are on the lower surface to keep the bracket level).
4. Place the in terface br acket ont o the ny lon spac ers on the bo ttom of t he proje ctor and ali gn the mounting holes in the bracket w ith th e nylon spa cers.
5. Using the three M4 screws and one M4 washer, place the washer around the pan head screw and start the two flat head screws into the two
counter sink holes in the threaded inserts. Tighten all three fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in
the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (2) Spacer, Nylon, 1/2" x .194 x 3/8"
(4) 10-24 Thumb Nuts ** (1) Screw, Phillips Flat head, M4x 12mm
(1) All-Points Security Kit (1) Screw, Phillips Flat head, M4x 16mm
(1) Washer, Flat, M4 (1) Screw, Phillips Pan head, M4x 16mm
(1) Spacer, N ylon, 1/2" x .275 x 3/16"
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific t o SSB-style and SSM-style interfa ce bracket installati on, all appropriate screws come pre-installed as reflected in the encirc led
loca tion s above. DO NOT atte mpt to su bsti tute a nd USE ONLY th is pr e-instal l ed hardw are for S SB- styl e and SS M-styl e inter face br acket
installation.
SLB-058 SLM-058
(
N
o
t
e
:
S
S
M
-
s
t
y
l
e
i
n
t
e
r
f
a
c
e
b
r
a
c
k
e
t
c
o
n
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(
Note: SSB-st
y
l
e
i
n
t
e
r
f
a
c
e
b
r
a
c
k
e
t
c
o
n
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
Towards front of
projector
Towards front of
projector