Chief SSM115 User Manual
Displayed below is the user manual for SSM115 by Chief which is a product in the Projector Mount Accessories category. This manual has pages.
Related Manuals
INSTALLATION INSTRUCTIONS
Milestone AV Tec hnol ogie s, and its affiliated co rpo rat ions a nd subs idiaries (c ol lectiv el y, "Miles tone"), intend to make this ma nual ac cu rat e an d compl ete. However, Mi lestone makes
no claim that the in for mation con taine d h erein co vers all deta ils, con ditions or va ri atio ns, nor does i t provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone as sumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-0 0010 4 R ev 01
©2009 Milestone AV Te chnologies,
a Duchossois Group Company
05/09
SSB-115, SSM-115, SLB-115 and SLM-115 Interface Brackets
SSB-115, SSM-115, SLB-115 and SLM-115 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit conten ts. If any listed parts are missing, immediately contact a Ch ief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIO US PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Install bracket cradle by carefully sliding it from the rear of the projector and along its edges forward until vertical legs move past control
panel at side (NOTE: stop just before it reaches the forward feet of the projector).
3. Install four rubber bumpers into four inner .28 diameter holes of cradle bracket.
4. Raise two adjustable feet by pushing foot release inward (NOTE: this will allow placing of interface bracket on cradle studs).
5. A lign four outer . 25 diameter holes of interface bracket with four 10-24 x .5" long studs in the cradle. Install four 10-24- Nylock nuts with
washers onto studs and tighten moderately. Install the two metric fasteners into the projector bottom. Tighten all fasteners at this time,
securing interface bracket to projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (4) Rubber Bumpers
(6) 10 - 24 Thumb Nuts** (4) #10 Flat Washers
(1) All-Po ints Secu rity Kit (2) M4 Flat Washers
(1) Cradle Bracket (4) 10-24 Nylock Nuts
(2) M4 x 10mm Screws
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encirc led locati ons abov e. DO NOT attempt t o subst itute a nd USE ONLY thi s pre-in stalled hardware for SSB-sty le and SSM-st yle
interface bracket installation.
(No
te: SSM
-style in
terf
a
c
e
b
r
a
c
k
e
t
c
o
n
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(No
te: SSB
-style in
terface
bracke
t conne
ctions
a
r
e
e
n
c
i
r
c
l
e
d
)
SLM-115
SLB-115
Towards front of
projector
Towards front of
projector